Client Project name Order# Qty Type FEATURES AND BENEFITS Physical : Low copper content high pressure die-cast aluminum housing Heavy aluminum formed yoke (standard yoke included) Stainless steel hardware Silicone sealing devices Clear tempered glass Dual chamber design for heat management and ease of maintenance Electro-statically applied polyester powder coat finish 5.44 kg / lbs EPA: Front = 0.94 sq. ft. / 0.07 sq. m. Side = 0.56 sq. ft./ 0.05 sq. m. IP66 IK0 rated Meets 3G ANSI C36.3 Vibration standard for bridge applications Corrosion-resistant coating for hostile environments* Performance : Minimum fc (0.7 lux) @ 37 feet (m) distance (4000K, 6 optic) 3,45 delivered lumens and 50,7 candelas at nadir (4000K, 6 optic) 6, 0, 0, 40 or 60 optics available CRI value: 0+ Lumen maintenance 0,000 hrs [L70 @ 5 C] Lumen measurements comply with LM - 79-0 standard Operating temperatures: -5 C to 50 C [-3F to F] CERTIFICADO No.054, 055 RETILAP IK0 Electrical : Line voltage luminaire for 00 to 77V Power and data in cable, 3ft/ m cord (#6-5) 50 watts Dimming options: 0-0 volt, DMX/RDM enabled, DALI, Lumentalk or Lutron EcoSystem enabled 0 43" 4 [mm] " [57mm] 0 70 90 0" [54mm] 7 4 " [37mm] 60 Standard Yoke Mounting Adjustable pivot limits Standard Yoke (as shown, included) * Use only when exposed to salt spray and harsh chemicals. This option is not required for normal outdoor exposure! /9 Consult
MOUNTING OPTION lumenbeam 4 3 4 " [mm] 0 " [57mm] 33 0 45 4 " 0" [54mm] [6mm] SY Short Yoke Mounting Short Yoke mounting adjustable pivot limits 09 3" [76mm] 5 6 " mm 7 6 " [mm] Standard and Short Yoke mounting holes Pattern OPTICAL OPTIONS *Factory installed LSLH Linear Spread Lens Horizontal distribution (not adjustable on site) LSLV Linear Spread Lens Vertical distribution (not adjustable on site) Factory installed, available for 6 to 40 optics. See Optical Accessories for field adjustable spread lens. /9 Consult
ACCESSORIES Order separately Mounting Accessories PM4-, PM4.5-, PM5- Round Pole Mounting accessory single " 6 [509mm] 0 " [3mm] 5 PM4-, PM4.5-, PM5- Round Pole Mounting accessory twin s 3 " 6 [55mm] 5 7 " 6 [5mm] PM4 Round Pole Mounting Accessory Shown *Consult factory for square pole section When PM4-, PM4.5- or PM5- are specified, one bracket assembly is supplied per s unless otherwise specified. 57" 4" [49mm] [0mm] TN Tenon adapter to fit on 3/ O.D. tenon " [64mm] 4" [0mm] TN4 Tenon adapter to fit on 4 O.D. tenon 3/9 5 7" [49mm] 4" [05mm] Consult
ACCESSORIES - continued Order separately Optical Accessories: LBL-SN- -BK Snoot accessory. Please specify desired exterior finish from the list below. Interior surface painted black. LBL-SNW- -BK Snoot Wide accessory. Please specify desired exterior finish from the list below. Interior surface painted black. LBL-VS- -BK Visor accessory. Please specify desired exterior finish from the list below. Interior surface painted black. LBL-WG- Wire Guard accessory. Please specify desired exterior finish from the list below. LBL-LSLA- Linear Spread Lens Adjustable accessory. Please specify desired exterior finish from the list below. Available finishes: BK - Sandtex BRZ - Bronze Sandtex SI - Silver Sandtex WH - Smooth white, low gloss BKTX - Textured black BRZTX - Textured bronze, non-metallic GRATX - Textured medium gray GRNTX - Textured green WHTX - Textured white CC - Custom color and finish (please specify RAL color) Accessory combinations: + Snoot Snoot Wide Visor Wire Guard Snoot Visor Linear Spread Lens Adjustable Accessory combinations must be ordered together on a single line. Ex: A Snoot + Wire Guard combination order code is LBL-SNWG-BK-BK. North American RAL colors specified with RAL number only are provided with a smooth/high-gloss finish. Please consult factory for other RAL textures and glosses, or to match alternate color charts. Final color matching results may vary. 4/9 Consult
ACCESSORIES - continued Order separately lumenbeam Control Systems: Control Boxes: LTO LCU LID LTN CBX Lumentouch is a wall mount DMX 5 controller keypad. Lumencue is a USB / mini SD DMX 5 controller. LumenID is a diagnostic and addressing DMX 5 controller. It must be specifi ed on all DMX applications. Refer to LID specifi cation sheet for details. Lumentone is a simple pre-programmed DMX 5 controller with a push button rotary dial and live feedback. DMX/RDM control box. Up to six power and data outputs to fi xtures or fi xture runs. Ethernet enabled option. Refer to CBX specifi cation sheet for details. 5/9 Consult
TYPICAL WIRING DIAGRAMS Non-Dimming or Lumentalk Dimming Version % minimum dimming value with Lumentalk dimming American CE USE Green White Red/Purple Orange Yellow/Green Brown Blue Grey Ground Live Neutral 0-0V / Data + 0-0V / Data - #6-3 Power cable JBOX previous next Dimming Version (0-0V) 0% minimum dimming value #6-5 Power & data cable JBOX dimmer Dimmer Maximum run lengths - 5A maximum, 6AWG cable, 0' [3m] on center spacing Configuration/Voltage next 6/9 0V 0V 40V 77V 0ft from electrical panel 36 39 50ft from electrical panel 35 3 Run length calculations are based on a voltage drop of no more than 5V. Consult factory for specific applications and max. cable length recommendations. 0-0V ma Ratings: Passive Dimmer (Current Sink): 3mA per Active Dimmer (Current Source): 0.5mA per Consult
TYPICAL WIRING DIAGRAMS - continued Dimming Version (DALI) % minimum dimming value American CE USE Green White Red/Purple Orange Yellow/Green Brown Blue Grey Ground Live Neutral 0-0V / Data + 0-0V / Data - #6-5 Power & data cable JBOX DALI Controller Typical DALI Controller Maximum run lengths - 5A maximum, 6AWG cable, 0' [3m] on center spacing Configuration/Voltage next 0V 0V 40V 77V 0ft from electrical panel 36 39 50ft from electrical panel 35 Run length calculations are based on a voltage drop of no more than 5V and a 64 limit per EcoSystem run or DALI loop. Each Lutron EcoSystem enabled has its own address; for the example shown, there are a total of 3 EcoSystem addresses. 3 Consult factory for specific applications and max. cable length recommendations. Dimming Version (EcoSystem ) % minimum dimming value #6-5 Power & data cable JBOX Lutron EcoSystem Controller Grafik Eye shown next 7/9 Consult
TYPICAL WIRING DIAGRAMS - continued Star Layout (DMX/RDM) % minimum dimming value American CE USE Green White Red/Purple Orange Yellow/Green Brown Blue Grey Ground Live Neutral 0-0V / Data + 0-0V / Data - Lumentouch.0 #6-5 Power & data cable Data input 00-40V CBX-ST lumenterminator (use at the end of each run only) Data out to next CBX (optional, not isolated/not boosted) Maximum run lengths - 5A maximum, 6AWG cable, 0' [3m] on center spacing or CBX Configuration/Voltage Fixture 40V 77V 50ft from CBX Run length calculations are based on a voltage drop of no more than 5V and a DMX/RDM enabled limit per DMX/RDM run. Consult factory for specific applications and max. cable length recommendations 3 Each requires DMX address. 4 6 outputs max. per CBX-ST, output max. per CBX-DS. DMX terminator is required at the end of each run to maintain data integrity. (x) DMX lumenterminator included per CBX-DS (6x) DMX lumenterminator included per CBX-ST See installation instructions for details. Daisy Chain Layout (DMX/RDM) % minimum dimming value CBX-DS 0V 0V 0ft from CBX #6-5 Power & data cable Data out to next CBX (optional, not isolated/ not boosted) lumenterminator (use at the end of each run only) Data Lumentouch.0 input or CBX Fixture 00-40V /9 Consult
HOW TO ORDER lumenbeam LBL 3 4 5 6 7 Housing: LBL - Lumenbeam Large Voltage: 00-00 volts 0-0 volts 0-0 volts 0-0 volts 40-40 volts 77-77 volts 3 Colors and Color temperatures: 4 Optic: 7K - 700K 30K - 3000K 35K - 3500K 40K - 4000K 57K - 5700K RD - Red GR - Green BL - Blue VN - Very Narrow 6 NS - Narrow Spot 0 NF - Narrow Flood 0 FL - Flood 40 5 Optical Option: 6 Finish: LSLH - Linear Spread Lens Horizontal distribution LSLV - Linear Spread Lens Vertical distribution BK - Sandtex BRZ - Bronze Sandtex SI - Silver Sandtex WH - Smooth white, low gloss BKTX - Textured black BRZTX - Textured bronze, non-metallic GRATX - Textured medium gray GRNTX - Textured green WHTX - Textured white CC - Custom color and finish (please specify RAL color) 7 Control: - No Dimming LT - Lumentalk 3 DIM - 0-0V Dimming option 4 DMX/RDM - DMX/RDM enabled 5 DALI - DALI Dimming option 3 ES - Lutron EcoSystem Enabled Dimming 6 Option: SY - Short Yoke 3GV - 3G ANSI C36.3 Vibration Rating CRC - Corrosion-resistant coating for hostile environments CE - CE (certification covers European Economic Area) WFL - Wide Flood 60 Factory installed, available for 6 to 40 optics. See Optical Accessories for field adjustable spread lens. North American RAL colors specified with RAL number only are provided with a smooth/high-gloss finish. Please consult factory for other RAL textures and glosses, or to match alternate color charts. Final color matching results may vary. 3 % minimum dimming value. 4 0% minimum dimming value. Current Sink: 3mA/, Current Source: 0.5mA/. 5 % minimum dimming value. DMX address per. 6 One EcoSystem address per. % minimum dimming value. 9/9 Consult