SWING audio handset 7 Description WIRE audio handset for wall mounted installation. It s fitted with keys for: door lock release, and programmable keys (---), which operating mode is set through the configuration. The volume of the bell can be adjusted, or the bell may be disabled. It has 6 different pre-programmed bells. It also performs the following functions: conversation secrecy, office (when the call is made from the entrance panel the associated door lock automatically opens without the need for pressing the relevant key on the handset), door lock status check. When a SWING handset is used toghether with an Elettrika CISA door lock (with accessory 6), it is possible to control the status of the door lock connected to the system using door lock actuators, item 6/item 66. If the Elettrika CISA door lock is open, the SWING Handset LED flashes. The LED will continue flashing while the lock remains open. Wall fixing bracket supplied. Technical data Power supply from SCS BUS: 8 7 Vdc Stand by absorption: 5 ma Max. operating absorption: 5 ma Operating temperature: 5 - C Dimensional data 9 mm 5 mm 56 mm Front view Internal view Legend - Bell volume adjustment and exclusion - Door lock key - DOOR STATUS signalling LED or activation of the OFFICE function - programmable keys using the configuration (---) 5 - Extensible cord capped on both ends with RJ connectors 6 - Clamps for the connection of the WIRE BUS, additional floor call functions and extra bell. 7 - Line termination ON/OFF micro-switch (audio/video systems only) 8 - Configurator socket 6 5 7 8 SHEETS BT5-b-UK TECHNICAL
7 Configuration N handset number The N configurator assigns to each handset an identification number within the system. The handsets must be configured in progressive order. In case of handsets with parallel connection (max ) inside the apartment without item 685, these must be configured using the same N configurator. 5 ET BUS OFF ON P entrance panel association The P configurator identifies the associated EP, or the first entrance panel on which the audio is activated when the () is pressed for the first time, as well as which door lock is activated when the key is pressed while the handset is idle. N P M O D N P MOD Configurator in P Key function () -9 Entrance panel audio activation (configured with P = -9) Configurator in P Key function -9 Opening of the EP door lock (configured with P = -9) Operating mode of the keys In addition to the door lock opening key, the SWING handset also has programmable keys (---). The programmable keys may be associated to different operating modes (e.g. activation of external actuators, intercom, additional EP activation, office mode activation), depending on the type of configurators connected to MOD (see details in the following pages). BT5-b-UK
7 Configuration Below are the various operating modes that can be assigned to the programmable keys: MODE KEY FUNCTION NOTES Staircase light switching on EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5), or activation of door lock actuators 6-66 (configured with P+) Audio/video EP or camera activation (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=9) Staircase light switching on N= N= N= N= N= N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. N= N= N= N= N= N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. Staircase light switching on N= N= N= N= N= N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. Audio/video EP or camera activation (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=9) 5 Staircase light switching on EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5) or activation of the actuator item 6/item 66 (configured with P+) EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5) or activation of the actuator item 6/item 66 (configured with P+) TECHNICAL SHEETSBT5-b-UK
7 MODE KEY FUNCTION NOTES Audio/video EP or camera activation (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=9) Audio/video EP or camera activation (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=9) Audio/video EP or camera activation (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=9) Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. N= N = N= N= N= N=5 N= N= N=5 N= N= N= N= N=5 N= N= N= N= N=5 N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. N= N=5 N= N= N= N= N= N= N=5 N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. N= N= N= N= N= N= N= N=5 N=5 N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5) or activation of the actuator item 6/item 66 (configured with P+) N= N= N= N= N= N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. BT5-b-UK Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. N= N= N= N= N= N= EP activation (configured with P), directly, without call
7 MODE KEY FUNCTION NOTES 5 EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5) or activation of the actuator item 6/item 66 (configured with P+) EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5) or activation of the actuator item 6/item 66 (configured with P+) EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5) or activation of the actuator item 6/item 66 (configured with P+) EP door lock release (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=5) or activation of the actuator item 6/item 66 (configured with P+) Staircase light switching on N= Intercom between apartments, in systems with apartment interface, item 685 N= Intercom between apartments, in systems with apartment interface, item 685 EP activation (configured with P), directly, without call Staircase light switching on N= N= N= N= N= N= Intercom inside the apartment, in systems with apartment interface item 685, or intercom among apartments without apartment interface. EP activation (configured with P+), directly, without call, or activation of the actuator, item 6 (configured with P+ and MOD=9) EP activation (configured with P), directly, without call 5TECHNICAL SHEETSBT5-b-UK
7 MODE KEY FUNCTION NOTES Intercom between apartments, in systems with apartment interface, item 685 N= N= Intercom between apartments, in systems with apartment interface, item 685 N= Intercom between apartments, in systems with apartment interface, item 685 N= Intercom between apartments, in systems with apartment interface, item 685 6 Staircase light switching on Activation of the scenario saved in the scenario module (SCENARIO ) Activation of the scenario saved in the scenario module (SCENARIO ) EP activation (configured with P), directly, without call 6 Activation of the scenario saved in the scenario module (SCENARIO ) Activation of the scenario saved in the scenario module (SCENARIO ) Activation of the scenario saved in the scenario module (SCENARIO ) Activation of the scenario saved in the scenario module (SCENARIO ) BT5-b-UK Activation of the paging function on all the sound system loudspeakers EP door lock release configured with P, directly, without call Audio/video EP or camera activation (configured with P+), directly, without call Audio/video EP or camera activation (configured with P), directly, without call, and 6
7 OFFICE function With the function active, when a call is received from the entrance panel, the handset rings and the associated door lock is automatically released, without the need for pressing the door lock release key on the handset. CLAK To ENABLE the function BIP To DISABLE the function BIP Led OFF s Led OFF s Led OFF MOD Configuration To activate the OFFICE function refer to the following: N P A 5 6 5 6 MOD + N P B 5 6 5 6 6 MOD A B Configuration selected for the operation of the keys (see previous pages) Configuration selected for the operation of the keys + OFFICE function 7TECHNICAL SHEETSBT5-b-UK
7 Programming of bells Bell selection from MAIN ENTRANCE PANEL (S=) Bell selection from SECONDARY ENTRANCE PANEL (S=) FLOOR CALL bell selection INTERCOM CALL bell selection O 6 6 6 6 OK RESET OK RESET OK RESET OK RESET BT5-b-UK 8