WM DT16-EV1. Customer Standalone Board WOLFSON DEVICE(S): DATE: August 2009

Similar documents
WM DT20-EV1. Customer Standalone Board WOLFSON DEVICE(S): DATE: September 2009

WM DS28-EV1-REV2 Schematic and Layout WOLFSON DEVICE(S):

WM DS28-EV2-REV1 Schematic and Layout

WM CS20-M-REV2

WM8805_6152_DS28_EV1_REV3 Schematic and Layout. WM8805_6152_DS28_EV1_REV3 Schematic and Layout. Customer Information 1 of 18 June 2007, Rev 3.

WM DT16-EV1. Example Configurations INTRODUCTION. Example Configurations DOC TYPE:

WM DS28- EV2-REV1 Example Configurations

Wolfson Control Write Sequencer

WAN_0212. Impedance Compensation (Zobel Network) for Ground Referenced Outputs INTRODUCTION CHARGE PUMP

WAN_0214. External Component Requirements for Ground Referenced Outputs INTRODUCTION RECOMMENDED EXTERNAL COMPONENTS

WM8804_6152_DS20_EV1_REV2 Evaluation Board Example Configurations

WM FL24-EV1-REV3 Schematic and Layout WOLFSON DEVICE(S):

WM8805_6152_DS28_EV1_REV3 Evaluation Board Example Configurations

1171_EV2_REV2. Schematic and Layout. DATE: August DOC REVISION: Rev 1.0

w Suggested ALC Settings for Portable Devices

w WM FL32-M-REV1 Example Configurations

WM8962 to WM8962B Migration Document

VAR-EXT-CB8 Datasheet Camera Extension Board for VAR-DT8MCustomBoard & SPEAR-MX8CustomBoard V 1.x

WM7133L. Bottom Port Analogue Silicon Microphone DESCRIPTION FEATURES APPLICATIONS

Hardware UART for the TMS320C3x

SN5446A, 47A, 48, SN54LS47, LS48, LS49 SN7446A, 47A, 48, SN74LS47, LS48, LS49 BCD-TO-SEVEN-SEGMENT DECODERS/DRIVERS

Microphone Power Gating. Top. Back SPKR. Figure 1 Example Microphone Placement in a Mobile Phone

Stereo Dac Motherboard application information

Dual Access into Single- Access RAM on a C5x Device

VAR-EXT-CB103 Extension Board for VAR-xxxxCustomBoard

Quick Start Guide. Figure 1 Voice Capture Board Plugged Directly into Raspberry Pi

Debugging Shared Memory Systems

NO P.O. BOXES ALLOWED AT CHECKOUT. User Guide. User Guide Page 1

INVENTORY HISTORY REPORT EXTENSION. User Guide. User Guide Page 1

CRD User Guide. Table of Contents. 1 Initial Configuration of the CRD The Control Console

Implementation of a CELP Speech Coder for the TMS320C30 using SPOX

WAN_0218. Implementing ReTune with Wolfson Audio CODECs INTRODUCTION

INVENTORY REPORT EXTENSION. User Guide. User Guide Page 1

ADD RELATED PRODUCTS TO CART. User Guide. User Guide Page 1

CUSTOM GOOGLE SEARCH. User Guide. User Guide Page 1

IndoTraq Development Kit 1: Command Reference

MOSAIC CONTROL DISPLAYS

SavvyCube Ecommerce Analytics Connector by MageWorx. User Guide

Reading a 16-Bit Bus With the TMS320C5x Serial Port

Techniques for Profiling on ROM-Based Applications

bq2056 Designed to Go Parts List General Description bq2056 Charge Algorithm Current Voltage

HSKT TM Technology Specifications

Increase Current Drive Using LVDS

TMS320C5x Memory Paging (Expanding its Address Reach)

6061-EV1-REV1 Schematic and Layout. January 2008

TLK10081 EVM Quick Start Guide Texas Instruments Communications Interface Products

Constant Temperature Chamber ATITRS1. Figure 1. Top View. Figure 2. Front View

TFP101, TFP201, TFP401, TFP401A 2Pix/Clk Output Mode

IMPORT/EXPORT Newsletter Subscribers. User Guide. User Guide Page 1

TIDA Test Report

The photograph below shows the PMP9730 Rev E prototype assembly. This circuit was built on a PMP9730 Rev D PCB.

STEVAL-SPBT4ATV3. USB dongle for the Bluetooth class 1 SPBT2632C1A.AT2 module. Features. Description

EV-VNQ5E050AK VNQ5E050AK evaluation board

1 Photo. 7/15/2014 PMP10283 Rev A Test Results

DS25BR204 Evaluation Kit

Bit-reversed Addressing without Data Alignment on the C3x

Analog Technologies. Laser Driver Load Assembly ATLS212DLD1.0 Load Assembly for Laser Drivers

12MHz XTAL USB DAC PCM2702E

OMAP SW. Release Notes. OMAP Software Tools OST version 2.5 Release. 16xx/1710/242x platforms. Document Revision: 2.5 Release

w WM FL32-M-REV1

C Fast RTS Library User Guide (Rev 1.0)

Analog Technologies. Laser Driver Load Assembly ATLS212DLD1.0 Load Assembly for Laser Drivers

GUEST CHECKOUT TO REGISTERED CUSTOMERS. User Guide. User Guide Page 1

EV Software Rev Evaluation System User Guide. Introduction. Contents. Hardware and Software Setup. Software Installation

27 - Line SCSI Terminator With Split Reverse Disconnect

6162-EV1-REV2 Schematic and Layout

Application Report. Mixed Signal Products SLOA028

STEVAL-PCC010V1. ST802RT1A Ethernet PHY demonstration board with STM32F107 controller add-on board. Features. Description

PMC to PCI Express Adapter with JN4 Connector Breakout

ATLD10A5-D EV1.0 Evaluation Board for ATLD10A5-D 10A High Efficiency Laser Controller ATLD10A5-D Evaluation Board Rev. 1.0

Single Cell Battery Power Solution

Features. Applications

WM dB Stereo DAC FEATURES DESCRIPTION APPLICATIONS BLOCK DIAGRAM

GUEST CHECKOUT TO REGISTERED CUSTOMERS

WM8731L-6061-FL28-M-Rev1

IMPORT/EXPORT CUSTOMERS FOR MAGENTO 2. User Guide. User Guide Page 1

AN2734 Application note S-Touch design procedure Introduction

EV Evaluation System User Guide. Contents. Kit Contents. Introduction

AN2667 Application note

October 2002 PMP Portable Power SLVU074

TIDA V Stepper Motor Controller with Integrated Current Sense Reference Design

IT900 STK4 (Starter Kit)

SN65DSI86 SW Examples

XIO1100 NAND-Tree Test

SN54F38, SN74F38 QUADRUPLE 2-INPUT POSITIVE-NAND BUFFERS WITH OPEN-COLLECTOR OUTPUTS

Test Report PMP Test Data For PMP /20/2015

Using LDOs and Power Managers in Systems With Redundant Power Supplies

STEVAL-CCM002V1. TFT-LCD panel demonstration board based on the STM32 as LCD controller. Features. Description

1. Installation Instructions

I2C and the TAS3001C. Introduction. The I2C Protocol. Digital Audio Group ABSTRACT

SN54BCT760, SN74BCT760 OCTAL BUFFERS/DRIVERS WITH OPEN-COLLECTOR OUTPUTS

LPGD SBDN GND 4VR PZVS VLMU VLML PZVO PIZO. 3 GND Signal ground Signal ground pin. Connect ADC and DAC grounds to here.

Protecting the TPS25810 from High Voltage DFPs

AC Induction Motor (ACIM) Control Board

PRODUCT INQUIRY - 1.0

TIDA Test Report

This document describes the features of the GUI program used to control Power Line Modem with E-Meter Platform.

Store & Currency Auto Switcher

DatasheetDirect.com. Visit to get your free datasheets. This datasheet has been downloaded by

HX2VL Development Kit Guide. Doc. # Rev. *A

Transcription:

DOC TYPE: BOARD REFERENCE: BOARD TYPE: WOLFSON DEVICE(S): WM8524-6228-DT16-EV1 Customer Standalone Board WM8524 DATE: August 2009 DOC REVISION: Rev 1.0 Customer Information 1

SCHEMATIC Sheet 1: Main Schematic Customer Information 2

Sheet 2: S/PDIF Interface Customer Information 3

Sheet 3: WM8524 Customer Information 4

Sheet 4: Passive Line Output Customer Information 5

Sheet 5: Power Customer Information 6

Sheet 6: Reference Tables Customer Information 7

BILL OF MATERIALS (BOM) Customer Information 8

Customer Information 9

PCB LAYOUT Top Layer: Overview Customer Information 10

Top Layer: Silkscreen + Copper Customer Information 11

Top Layer: Copper Customer Information 12

Bottom Layer: Copper Customer Information 13

Bottom Layer: Silkscreen + Copper Customer Information 14

DEFAULT BOARD CONFIGURATION USB Power, Electrical S/PDIF input, DAC in 24-bit I2S Mode, No MUTE Customer Information 15

APPLICATION SUPPORT If you require more information or require technical support, please contact the Wolfson Microelectronics Applications group through the following channels: Email: apps@wolfsonmicro.com Telephone Apps: +44 (0) 131 272 7070 Fax: +44 (0) 131 272 7001 Mail: Applications Engineering at the address on the last page or contact your local Wolfson representative. Additional information may be made available on our web site at: http://www.wolfsonmicro.com Customer Information 16

IMPORTANT NOTICE Wolfson Microelectronics plc ( Wolfson ) products and services are sold subject to Wolfson s terms and conditions of sale, delivery and payment supplied at the time of order acknowledgement. Wolfson warrants performance of its products to the specifications in effect at the date of shipment. Wolfson reserves the right to make changes to its products and specifications or to discontinue any product or service without notice. Customers should therefore obtain the latest version of relevant information from Wolfson to verify that the information is current. Testing and other quality control techniques are utilised to the extent Wolfson deems necessary to support its warranty. Specific testing of all parameters of each device is not necessarily performed unless required by law or regulation. In order to minimise risks associated with customer applications, the customer must use adequate design and operating safeguards to minimise inherent or procedural hazards. Wolfson is not liable for applications assistance or customer product design. The customer is solely responsible for its selection and use of Wolfson products. Wolfson is not liable for such selection or use nor for use of any circuitry other than circuitry entirely embodied in a Wolfson product. Wolfson s products are not intended for use in life support systems, appliances, nuclear systems or systems where malfunction can reasonably be expected to result in personal injury, death or severe property or environmental damage. Any use of products by the customer for such purposes is at the customer ss ownrisk. Wolfson does not grant any licence (express or implied) under any patent right, copyright, mask work right or other intellectual property right of Wolfson covering or relating to any combination, machine, or process in which its products or services might be or are used. Any provision or publication of any third party s products or services does not constitute Wolfson s approval, licence, warranty or endorsement thereof. Any third party trade marks contained in this document belong to the respective third party owner. Reproduction of information from Wolfson datasheets is permissible only if reproduction is without alteration and is accompanied by all associated copyright, proprietary and other notices (including this notice) and conditions. Wolfson is not liable for any unauthorised alteration of such information or for any reliance placed thereon. Any representations made, warranties given, and/or liabilities accepted by any person which differ from those contained in this datasheet or in Wolfson s standard terms and conditions of sale, delivery and payment are made, given and/or accepted at that person s own risk. Wolfson is not liable for any such representations, warranties or liabilities or for any reliance placed thereon by any person. ADDRESS: Wolfson Microelectronics plc Westfield House 26 Westfield Road Edinburgh EH11 2QB United Kingdom Tel :: +44 (0)131 272 7000 Fax :: +44 (0)131 272 7001 Email :: apps@wolfsonmicro.com Customer Information 17