AC-00 XCEL DIRECT FIRED GAS CONVECTION OVEN REPLACEMENT PARTS LIST EFFECTIVE APRIL 0, 0 Superseding All Previous Parts Lists. The Company reserves the right to make substitution in the event that items specified are not available. ERRORS: Descriptive and/or typographic errors are subject to correction. BLODGETT OVEN COMPANY Lakeside Avenue, Burlington, Vermont 00 USA Telephone: (80) 68-6600 Fax: (80) 860- www.blodgett.com P/N 08
SERIAL NUMBER LOCATION / KEY: IMPORTANT: When ordering parts, please provide the model, gas type and serial number of the oven. The identification plate is located in the bottom of the motor compartment on the right hand side and, also, above the control panel under the ledge. SERIAL NUMBER IDENTIFICATION CODE: RJ = AC00 XCEL SERIAL NUMBER EXAMPLES 000RJ00T (NEW STYLE) 0/0/0 = DATE RJ = LETTER CODE FOR AC00 XCEL 00 = FACTORY SEQUENCE T = TOP OVEN TO OBTAIN LITERATURE: Email: literature@blodgett.com or visit www.blodgett.com APRIL 0, 0 AC-00 XCEL
TABLE OF CONTENTS Doors Are Not Returnable SOLID STATE MANUAL CONTROLS... SOLID STATE DIGITAL CONTROLS...6 CH0 FAST CONTROLS... BURNER ASSY AND GAS VALVE COMPONENTS...8 INTERIOR VIEW...9 DOOR COMPONENTS... 0 LOWER DOOR SUPPORT COMPONENTS... EXTERIOR COMPONENTS... ACCESSORIES... APRIL 0, 0 AC-00 XCEL
SOLID STATE MANUAL CONTROLS 0 8 6 9 Buzzer is located here, however not visible in this drawing. 88 Controller, Temperature 0 Probe, Temperature 8 Potentiometer, Remote 68 Knob, for Temperature, Mode Selector, Timer 068 Mode Selector Switch, Position 6 Buzzer, 0V 6 8 Timer, 60 Minute, 0V, 60 HZ 066 Momentary Light Switch Kit 8 86 Indicator Light, 8V, Red, Round 9 Transformer, 0V to V 0 90 Relay Assy 8 Decal, Lexan Control (Manual) Spark Box 00 Terminal Block 0 Axial Fan Assy 680 Harness, Rear Connecting 0 Probe, temperature APRIL 0, 0 AC-00 XCEL
SOLID STATE MANUAL CONTROLS FOR UNITS BUILT AFTER 0//0- THESE PARTS WERE ADDED/CHANGED DUE TO A CHANGE IN VOLTAGE. 0 9 8 6 0 Transformer, V to V Timer, 60 Min V Buzzer V 090 Harness, control 66 Switch, Gas on/off 6 6 Spark Box 66 Controller, Temperature 8 R80 Switch, Rate 9 08 Relay. VAC 0 666 Knob, Control Harness, infinite add-in R98 Relay, DPST V Module Assy- includes everything pictured below. APRIL 0, 0 AC-00 XCEL
SOLID STATE DIGITAL KEY 0 8 9 8 Orient rate switch with terminals toward inside corner of panel. 068 Controller, Time & Temperature Qty 0 Probe, Temperature Qty 66 Knob, Adjust Temperature Qty 068 Mode Selector Switch, Position Qty 666 Knob, Mode Selector Qty 066 Momentary Light Switch Kit 6 R80 Rate Switch 0 Transformer, 0V to V 099 MOV Assy (not shown The MOV Assy attaches to the terminal block of the control harness. 8 090 Harness, Control (not shown complete) The two terminal blocks shown are included with the harness and are shown plugged into the module.the wires of the harness have been eliminated from the picture. 9 08 Relay Assy Qty 0 98 Control Panel & Decal Assy Qty Spark Box 66 Gas Switch, On/Off R98 Relay, DPST, V R MOV Assy (not shown) The MOV Assy R attaches to the coil of the Relay R98. They do not come as a kit and must be purchased as separate items. 00 Terminal Block 0 Axial Fan Assy 680 Harness, Rear Connecting 06 Module Assy- includes everything pictured above APRIL 0, 0 6 AC-00 XCEL
CH-0 FAST CONTROLS KEY 9 8 Orient rate switch with terminals toward inside corner of panel. 0 6 9 0 08 Controller, CH0 ( Key) 9 Probe, RTD 000 ohm 068 Mode Selector Switch, Position Qty 666 Knob, Mode Selector Qty 066 Momentary Light Switch Kit R80 Rate Switch 6 0 Transformer, 0V to V 090 Harness, Control (not shown complete) The two terminal blocks shown are included with the harness and are shown plugged into the module. The wires of the harness have been eliminated from the picture. 8 08 Relay Assy Qty 9 Spark Box 0 66 Gas Switch, On/Off R98 Relay, DPST, V R MOV Assy (not shown) The MOV Assy R attaches to the coil of the Relay R98. They do not come as a kit and must be purchased as separate items. 00 Terminal Block 0 Axial Fan Assy 680 Harness, Rear Connecting APRIL 0, 0 AC-00 XCEL
BURNER ASSEMBLY & GAS VALVE 6 8 Ignitor Upgrade Kit Consists of Flame Sensor Probe and Ignitor Rod 8 Ignitor, Spark Rod Qty 66 Manifold 6 Orifice, Blank Qty 8 Plug, pipe Qty 6 99 Nipple, Close /" NPT 9 Flex Hose 6608 Gas Valve, NAT & LP APRIL 0, 0 8 AC-00 XCEL
INTERIOR VIEW 0 Motor, SP, / HP 0988 Retainer, Probe Wire (Qty ) 06 Rack Support (Qty - sold individually) 066 Rack, Wire (-/8" x -/6") (Each) 069 Blower Wheel (Qty ) Bulb, Light W, 0V, (Qty ) 9 Lens, Cover Light (Qty ) 0 Axial Fan, V 06 CFM " 8 Fan Guard and Hardware 00 Terminal Block 9 Power Cord assy 680 Rear Harness APRIL 0, 0 9 AC-00 XCEL
DOOR COMPONENTS 6 Door Assy, LH Glass (Qty ) 906 Window Assy 68 Pressure Lock (helps with latching) 9 Microswitch Assy, double door 60 Nameplate "BLODGETT" 99 Gasket Assy, Perimeter 0 Gasket Assy, Center APRIL 0, 0 0 AC-00 XCEL
LOWER DOOR SUPPORT COMPONENTS Lower Door Support Assy Lower Door Support Assy includes the hinge pins, arms, chain & turnbuckles, sprocket assys, cam assy, and microswitch. 9 Microswitch Assy (not visible) APRIL 0, 0 AC-00 XCEL
EXTERIOR COMPONENTS 99 Gasket Assy, Perimeter 80 Body Top S/S 6 Cover, Control (next to door) APRIL 0, 0 AC-00 XCEL
ACCESSORIES 6 8 9 89 Drafthood, Direct Venting, S/S Qty 80 Draft Diverter, Canopy Venting, S/S Qty 6686 Flue Box, Sgl Oven Qty 98 Vent Assy, Complete 86 Installation Hose, 6" Installation Hose, 8" 9 Cord Set Assy, 6 Feet Qty 6 9 Legs, " w/ Bolts, S/S Set of 600 Casters, Set of, Sgl Oven 99 Casters, Plate " All locking, Set of, Dbl Oven 98 Casters, Low Profile, Set of, Dbl Oven 0 Casters, HD, Low Profile, Set of, Dbl Oven 8 Casters & Leg Plates, Adjustable " Locking, Set of, Dbl Oven 9 9 Casters, Plate " Locking/ Non-locking, Set of, Dbl Oven APRIL 0, 0 AC-00 XCEL