Quick Guide KX-TG7180E. 1 Connections. 2 Battery installation/ Battery charge (Initial charge: 7 hours) Digital Cordless Answering System PQQW15294ZA

Transcription

1 TG7160_7180E(e)_QG.fm Page 1 Thursday, July 27, :08 PM Quick Guide Digital Cordless Answering System Model No. KX-TG7160E KX-TG7180E 1 Connections Hook Use only the included AC adaptor and telephone line cord. ( V, 50 Hz) To telephone network 2 Battery installation/ Battery charge (Initial charge: 7 hours) Charge contact Note: L Use only the included rechargeable batteries. The pictured model is KX-TG7160. PQQW15294ZA DC0806PM0

2 TG7160_7180E(e)_QG.fm Page 2 Thursday, July 27, :08 PM 3 Bone conduction earpiece (KX-TG7180 only) The handset features a bone conduction earpiece that uses vibrations to create sound during your telephone conversations. Note: L The effectiveness of the bone conduction earpiece will vary by the type and degree of hearing loss of the user. 4 Symbols used in these operating instructions Date and time 1 {j/ok} 2 Press {^} or {V} to select Handset Setup. i {>} 3 Press {^} or {V} to select Time Settings. i {>} 4 Press {^} or {V} to select Set Date & Time. i {>} 5 Enter the current day, month, and year. 6 Enter the current hour and minute. 7 {j/ok} i {ih} 5 Accessibility Bone conduction earpiece Place the bone conduction earpiece against your face (not your ear). Try different locations to find which location works best. Start with the temple area. Symbol Meaning {j/ok} Press {j/ok}. i Proceed to the next operation. Select the words in quotations shown on the display (e.g., Handset Setup ) by pressing {^} or {V}. Caller ID announce When you receive an outside call which has phone number information, the handset announces the displayed phone number from the handset speaker. L To announce outside caller s phone number, you must first subscribe to Caller ID service. Consult your service provider/telephone company for details. List announce The handset announces phone numbers from the handset speaker while you are viewing the redial list, caller list, and phonebook. 2

3 TG7160_7180E(e)_QG.fm Page 3 Thursday, July 27, :08 PM 6 Basic operations Feature Making a call Answering a call Hanging up Receiver/speaker volume Last number redial Making a call with redial list Handset phonebook: storing an entry (name and phone numbers) Handset phonebook: making a call Handset ringer volume Changing ringtone (outside calls) Answering system Feature Answering on/off Listening to messages Operation Dial the phone number. i {C}/{s} {C} {ih} Press {^} or {V} while on a call. {R} i {C} {R} i Press {^} or {V} to select the desired number. i {C} {k} i {j/ok} i New Entry i {>} i Enter the party s name (16 characters max.). i {j/ok} i Enter the party s phone number (24 digits max.). i {j/ok} i Save i {>} i {ih} L To enter a name, see the character table in the operating instructions. {k} i Press {^} or {V} to display the desired entry. i {C} {j/ok} i Handset Setup i {>} i Ringer Setup i {>} i Ringer Volume i {>} i Press {^} or {V} to select the desired volume. i {>} i {ih} {j/ok} i Handset Setup i {>} i Ringer Setup i {>} i Ext. Ringtone i {>} i Select the desired ringtone. i {>} i {ih} Operation {j/ok} i Answer System i {>} i Answer On or Answer Off i {>} i {ih} {j/ok} i Answer System i {>} i Play New Msg. or Play All Msg. i {>} 3

4 TG7160_7180E(e)_QG.fm Page 4 Thursday, July 27, :08 PM 7 Frequently asked questions Question What kind of power outlet should I connect the AC adaptor to? Why is w flashing? Why is the handset display blank? What should I do when the handset does not turn on? How long should I charge new batteries? How long is the battery operating time? Can I keep the handset on the base unit or charger when I am not using it? Cause & solution L Connect the AC adaptor to a V outlet. L The handset is too far from the base unit. Move closer. L The AC adaptor is not connected. Check the connections. L You are using the handset or base unit in an area with high electrical interference. Place the handset and base unit away from interference sources, such as antennas and mobile phones. L The handset is not registered to the base unit. Register it. {j/ok} i Handset Setup i {>} i Registration i {>} i Register H.set i {>} i Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds. i Wait until Enter Base PIN is displayed. i Enter the base unit PIN (default: 0000 ). i {j/ok} L The handset is not turned on. To turn the power on, press {ih} for about 1 second. L Make sure that the batteries are installed correctly. L Fully charge the batteries. L Clean the charge contacts and charge again. L Charge the batteries for about 7 hours. L When you are using fully-charged Ni-MH batteries (included batteries); In continuous use: 12 hours max. (KX-TG7160)/10 hours max. (KX-TG7180) In continuous standby mode: 150 hours max. It is normal for batteries not to reach full capacity at the initial charge. Maximum battery performance is reached after a few complete cycles of charge/ discharge (use). Actual battery performance depends on a combination of how often the handset is in use and how often it is not in use (standby). L Even after the handset is fully charged, the handset can be left on the base unit or charger without any ill effect on the batteries. 4

5 TG7160_7180E(e)_QG.fm Page 5 Thursday, July 27, :08 PM Question When should I replace the batteries? What is a PIN? What do I need to do to display caller information? Cause & solution L If the batteries are fully charged until 1 is displayed, but 3 is displayed after a few calls, replace the batteries with new ones. L The PIN is a 4-digit number that must be entered in order to change certain base unit settings. The default PIN is L You need to subscribe to Caller ID service. Consult your service provider/telephone company for details. L The message You must first subscribe to Caller ID. will be displayed until you receive caller information after subscribing to Caller ID service. 8 Optional service (Caller ID) If you subscribe to Caller ID service, you can: Tom display caller information announce the caller s phone number (Caller ID announce) 9 Sales and support information Customer Care Centre L For customers within the UK: L For customers within the Republic of Ireland: L Visit our website for product information: L customer.care@panasonic.co.uk Direct Sales at Panasonic UK L Order accessory and consumable items for your product with ease and confidence by phoning our Customer Care Centre Monday - Thursday 9:00am - 5:30pm, Friday 9:30am - 5:30pm (Excluding public holidays). L Or go on line through our Internet Accessory ordering application at L Most major credit and debit cards accepted. L All enquiries transactions and distribution facilities are provided directly by Panasonic UK Ltd. L It couldn t be simpler! L Also available through our Internet is direct shopping for a wide range of finished products, take a browse on our website for further details.. Customer Care Helpline Tel. No.: U.K / R.O.I

6 TG7160_7180E(e)_QG.fm Page 6 Thursday, July 27, :08 PM IMPORTANT If you have problems setting up or operating this product please call the Panasonic DECT Helpline (UK) (Repl of Ireland)