Integrated Haleon Sensor Quick-Start Guide

Transcription

1 Integrated Haleon Sensor Quick-Start Guide Download the free smartphone app for Android and ios available on Google Play and the Apple Store. Download the App Sensor Switch VLP

2 Getting Started: 1. Select Sign up now. 2. Complete Account Sign Up. 3. Select Integrated Haleon Series. 4. Select BLE. 5. Enter a custom 6-digit PIN code. 6. Enable the settings you would The PIN code sent with the first transmission will be saved to the sensor. Note This custom PIN code must be populated for all transmissions. like to modify & select the desired values. Once all desired settings are selected, press Next.

3 7. Check off the boxes to left of displayed names for all sensors to be programmed and press Send to Selected Devices. 8. Status of transmission will be displayed on screen. 9. Successful transmission message will populate on screen and fixture will cycle on/off once in confirmation of changes.

4 Identifying Sensors: The app will immediately start looking for sensors to program from the Push Programming screen and all sensors within range will populate on the screen. The expected range for transmissions is is a minimum of 100 feet. To determine which sensor corresponds to a specific line on the app, select the corresponding Identify button and the sensor will signal the fixture to cycle on and off. The fixture will continue to cycle until the Identify button is selected again or a programming transmission is sent to that sensor from the app. Naming Sensors: From the Push Programming screen, unique sensor names may be assigned for easier identification on site. Sensor names are account-specific and will populate in place of the original name every time the device is found within range by Bluetooth. 1. The app will populate your in-range sensor on the screen as SensorSwitchxxxx. Select arrow to the right to assign unique name. 2. Tap on device name & designate unique sensor name. Press Done. 3. Unique sensor name will now populate when detected inrange by the app.

5 Saving Profiles: Once at least one setting has been selected, a Profile may be created to store both the settings and PIN code for future use. There is no limit to the number of profiles that can associated with an individual user account. 1. From Push Programming screen, select Save Profile to store settings and PIN code selected on previous screen. Note Save Profile function may be utilized without having sent a transmission. 2. Press profile name field to assign unique name. Once complete, select Save New Profile. 3. From Sensor Settings screen, select Profile Presets to view saved profiles.

6 Notes: 1. The smartphone device used for programming must be equipped with Bluetooth version 4.2 or later. 2. Depending on your operating system and Bluetooth signal strength, programming and Identify transmissions may take up to 12 seconds per sensor. 3. Default sensor settings for out-of-the-box operation are: Factory Defaults Model Default Operation Occupancy Time Delay Photocell Mode Photocell Set-point Low Trim High Trim Dim to Off Time Delay HLNxxx On/Off Occupancy Only 10 minutes Disabled Disabled Disabled Disabled Disabled HLNxxxHL Occupancy w/ 0-10V Dimming (High/Low/Off) HLNxxxADC Occupancy w/ Dim & Switch Photocell 10 minutes Disabled Disabled 10% 100% 2.5 minutes 10 minutes On/Off/Dim 4 fc 10% 100% 0 seconds HLNxxxANL Dim & Switch Photocell with High/Low Occupancy Operation 10 minutes On/Off/Dim 4 fc 10% 100% Stay Dim/ Never Off Note: Lens detection designated in place of xxx (high mount) or ASL (high-mount aisleway) 4. For complete User Guide visit: Part No One Lithonia Way, Conyers, GA Phone: Acuity Brands Lighting, Inc. All Rights Reserved. SSI_6582_0617