BT602 Multifunction LAN cable tester with mapping check and length measurement

Transcription

1 BT602 Multifunction LAN cable tester with mapping check and length measurement BT602 permits to test quickly and effectively all cables inside LAN networks. The tester checks all eventual wrong connections (misswires and split pairs), it can detect problems of the cable itself (open circuits, short circuits) and shows results in a large graphical mapping display in a clear and simple way. Large LCD Display with Backlight Graphical Mapping Length Measure Up to 8 remotes By using up to 8 codified remote control units (optional accessories) it's also possible to quickly detect the connection between the RJ45 sockets located in the working rooms and the ones located on the transposition panel or on the HUB. Unlike traditional LAN mapping checkers, BT602 equipped with superior function such as LAN cable length measurement (up to 255m /836ft) and Auto backlight function. User can measure cable length to check cable usage during or after installation. This can help to control and save LAN cable inventory. Its auto backlight function and the giant display enable user to work in weak/dim light environment. BT602 is ideal for LAN network installers who need an easy instrument for a preliminary LAN cable test and troubleshooting. Prepared by KIT Page 1 of 5

2 Functions: Graphical mapping display with auto backlight. WIRE MAPPING Open pair Shorted cables Miswires Split pairs Cable length measurement, up to 255m (836 ft). CABLE LENGTH MEASURE STEPS Connect Select Cable Type Press Key(s) Display ==> Test executed on twisted pairs cables UTP and FTP with RJ45 connector. Wire mapping control of following wrong conditions: - Open cables - Short cables - Miswires - Split pairs Initial auto test Quickly selection of cables pairs. OPEN, SHORT, SPLIT, MISWIRE message at display. Automatic detection of remote control units (from #1 to #8). Auto Power OFF Low battery indication 8 remotes Prepared by KIT Page 2 of 5

3 Accessories Instrument BT602 1 Remote identifier RM Patch cables, RJ45/RJ45 FTP, 20 cm, connectors Carrying bag Instruction manual (English) Battery required: 1 battery (9V) (Not included in accessories) Optional accessories Remote identifiers #2, #3,#4,#5,#6,#7,#8 + 7 patches cables RJ45/RJ45 STP (RM600) Remote identifier #2 + 1 patch RJ45/RJ45 (RM600-2) Remote identifier #3 + 1 patch RJ45/RJ45 (RM600-3) Remote identifier #4 + 1 patch RJ45/RJ45 (RM600-4) Remote identifier #5 + 1 patch RJ45/RJ45 (RM600-5) Remote identifier #6 + 1 patch RJ45/RJ45 (RM600-6) Remote identifier #7 + 1 patch RJ45/RJ45 (RM600-7) Remote identifier #8 + 1 patch RJ45/RJ45 (RM600-8) Standard CE Prepared by KIT Page 3 of 5

4 1. TECHNICAL SPECIFICATIONS CONNECTORS LAN Input Connectors: RJ45 CABLE TYPES 1 UTP, FTP: twisted pairs cables 2 Cable category: from CAT5/ CAT6 3 Maximum cables length : 255m (836 ft) WIRE MAPPING DETECTED CONDITIONS Fault Description Mapping Display Condition OPEN PAIR One or both conductors of the pair are interrupted (open) SHORTED CABLES Two conductors are in short circuit between each other MISWIRES SPLIT PAIRS Generic cabling error, such as for example two conductors belonging to different pairs are exchanged The pin to pin correspondence is hold, but physically the conductors of two pairs are crossed CABLE LENGTH MEASURMENT Range: up to 255 m (836 ft) Resolution: 0.1 m (ft) Unit: meter and foot 1Typical accuracy: ± 10%+1m (3 ft) Prepared by KIT Page 4 of 5

5 2. GENERAL SPECIFICATIONS CABLE TESTER MECHANICAL FEATURES Display: 42mm(W)*33mm(L) Monochrome LCD with backlight Dimensions: 130 (L) x 56 (W) x 38 (H) mm Weight: 170 g REMOTE CABLE IDENTIFIER MECHANICAL FEATURES Input connector: RJ45 Dimensions: 75 (L) x 20 (W) x 23 (H) mm Weight: 25 g POWER SUPPLY Battery type: 1 x 9V IEC6F22 or NEDA1604 alkaline battery Battery life: about 200 hours Shutoff Rate Power: 1uA Operate Maximum Power: 20mA Auto power off: after 2 minutes with no key activity ENVIRONMENT Environment working conditions Working temperature: 5-40 C Relative humidity: <80% Storage temperature: C Storage humidity: <70% BST Caltek Industrial Ltd Flat G, 2/F., Block 4, Golden Dragon Industrial Centre, Tai Lin Pai Road, Kwai Chung, N.T., Hong Kong sales@caltek.com.hk TEL: (852) FAX: (852) Prepared by KIT Page 5 of 5