display, 4 buttons, Modbus -RTU gateway for connection of Modbus -RTU resolution 0,1 C and resistance up to 6553,5

Transcription

1 Modulare I/O System with Modbus RTU or Ethernet Modbus TCP/IP Application The from EAP is an I/O System consisting of one basic module with LCD, buttons and MicroSD card slot, which is able to control up to expansion modules (max. I/O s). Outputs on basic module can be controlled menudriven on the basic module with buttons and the LCD display, respectively controlled by hand on the expansion modules with toggle switch (and poti). This I/O system is the consequent further development of the central and decentral fieldbus devices. Just as well as the fieldbus devices this system is used for the construction of distributed systems (fieldbus systems) in industry., building technology and HVAC. These devices could be arranged central or decentral and are read or written via gateway RS Modbus RTU or Ethernet Modbus TCP/IP from a central CPU (PLC, PC) respectively from a Hakko Touch Panel. Technical data Voltage supply: V DC 0% No load current: b0 0mA, B0 0mA Max. power input: see table Bus protocol: rs Modbus RTU, Ethernet Modbus tcp/ip with galvanic isolation Transfer rate: Baud Basic module: b0 with Modbus RTU, LCD display, buttons, MicroSD cardslot and DI V (pnp or npn) b0 with Modbus TCP/IP Port Switch, LCD display, buttons, Modbus RTU gateway for connection of Modbus RTU sensors microsd cardslot and DIV (pnp or npn) Enclosure basic module: mm sidebyside installation WxHxD 0x90x mm Display: LCD display plain text Handlayer: LCD display plain text buttons menudriven operation / control of outputs, display of current states resp. actual values Expansion module: Input digital: V DC, ma (pnp or npn) incl. counting function up to 00Hz and toggle register Input analogue: PT00/000: MB: C, NI000, ni000 TK000, KTY0, KTY0, resolution 0, C and resistance up to, ntckohm, NTC0kOhm, NTC0kOhm resistance up to, mohm, 0...0V (resolution mv),...0ma (resolution µa) Ausgang digital: open Collector V DC npn / A, shortcircuitproof EOC max. frequence khz 0,% resolution, EOC max. frequence 0Hz % resolution OCP V DC pnp (incl. tolerances) /,A/ channels on, shortterm,a, shortcircuit proof, thermally protected,a / if only channel/plug is active, parallel connection allowed, current is added accordingly B... Basic module B0.DI.Modbus TCP/IP integrated Modbus RTU gateway for connection of Modbus RTU sensors menudriven integrated operation / control of outputs display of current states resp. actual values E... Expansion module LED for Mode as standard statusbar LED at DI/DO mechanical handlayer DO/AO via toggle switch (and poti) RS CO Fühler RS EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax 900

2 Modulare I/O System with Modbus RTU or Ethernet Modbus TCP/IP RS CO Fühler RS Technical data prosecution Output digital: tr (Triac) 00V AC 0/0 Hz / 0, A/ channel on, startup current 0A/0ms, A/ sec pulse package control with zero cross control, not shortcircuit and not overload proof. relay 0V AC / A ohm resistive load 0V AC / 0, A cos phi 0, relay changer 0V AC/ A ohm resistive load 0V AC / 0, A cos phi 0, Output analoge: 0...0V (unit mv)),...0ma (unit µa) Enclosure expansion mm side by side installation WxHxD: module:,x90xmm Statusbar: DUOLED (red, green, yellow and invertable for DI/DO included as standard, x LED for mode, quantity according to the module type see table Handlayer: mechanical control of outputs with toggle switch and poti Terminals: plug terminals with pushin connection up to, mm² Mounting: DIN Rail TS Ambient temperature: C Accuracy: < 0, %, resolution analogue: 0, C EMC: acc. EN Protection type: ip0 s: ce Conformity Our customer appreciate following advantages: complete new design brought to the lates technological level designed for open networks (no supplier relationship) flexible configuration of I/O s to an unbeatable price / performance ratio The basic unit with Ethernet Modbus TCP/IP connection is with integrated switch ( sockets for looping through ) higher flow rate at the data transfer and integrated gateway Modbus RTU for connection of Modbus RTU sensors labelling fields, plug terminals with pushin connection up to,mm² Basic module B0.DI Modbus RTU MicroSD card slot allows loading of the current firmware New: EDI.DOR/H (incl. handlayer) New: EDOTR/H (incl. handlayer) New: EDOOCP/H (incl. handlayer) EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax 900

3 Modulare I/O System with Modbus RTU or Ethernet Modbus TCP/IP with RS Modbus RTU or Ethernet Modbus TCP/IP Type Article No Input digital B0.DI.Modbus RTU 00 xv Input analogue Output digital Output analogue Statusbar DI/DO Handlayer DO/AO LCDdisplay LCDdisplay B0.DI.Modbus TCP/IP w. switch ModbusRTU gateway 0 xv EDI 0 xv EXI xxi* LED LCDdisplay LCDdisplay EXI.AOU xxi* x00v EXI.AOU/H xxi* x00v TS/ Poti EDI.DOR NEW xv EDI.DOR/H NEW xv npn/pp ENPTC 0 xnptc* xrelay xrelay EDOR xrelay EDOR/H xrelay LED LED TS LED LED TS EDOW xrelay changer EDOW/H xrelay changer LED EDOOC xoc npn LED LED TS EDOOC/H xoc npn LED TS EDOOCP NEW xocp pnp LED EDOOCP /H NEW xocp pnp LED TS EDOOC xoc npn LED EDOTR NEW xtriac LED EDOTR/H NEW xtriac LED TS EAII.AOI x..0ma x...0ma EAII.AOI/H x...0ma x...0ma TS/ Poti EAOU x00v RS CO Fühler RS EAOU/H x00v TS/ Poti EDI.XI.AOU.DOR 9 xv EDI.XI.AOU.DOR/H 9 xv xxi* xxi* EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax 900 xrelay xrelay x00v LED x00v LED TS/ Poti XI* universal inputs configuration possible as 00V, resistance 0, Ohm, PT000, NI000, NI000TK000, TSsensor, PT00, KTY0, KTY0 *NPTC configuration possible as NTCkOhm, NTC0kOhm, NTC0kOhm, resistance 0, mohm, PT00, PT000, NI000, NI000TK000, KTY0, KTY0

4 Modulare I/O System with Modbus RTU or Ethernet Modbus TCP/IP Labelling fields Labelling field for BFT Connecting cable 0cm Subprint Connecting cable for control panel for door installation RS CO Fühler RS control panel door installation TS LED ModeLED Accessories Type Article description Article No. BFT Labelling fields expansion modules ( TE) 90 BFT Labelling fields basic modules ( TE) 9 SUBPRINT0P Subprint up 0pin plug to x pin plug RM,mm with screw terminals 9 SUBPRINT0P Subprint 9 below 0pin plug to x pin plug RM,mm with screw terminals 9 SUBPRINTP Subprint up pin plug to pin plug RM,mm with screw terminals 9 SUBPRINTP Subprint below pin plug to pin plug RM,mm with screw terminals 9 BUSKABEL 0cm BFTSW BFTLED BFTPOT BUSKABEL BFT control panel door installation LED ModeLED Connecting cable 0cm (for nd row in switch cabinet from right up to left below) 90 Control panel door installation x toggle switch A0 DuoLED (red/green)mode LED, dimensions: 9xmm Control panel door installation x DuoLED (red/green) Mode LED, dimensions: 9xmm Control panel door installation x toggle switch MA0 x poti Mode LED, dimensions: 9xmm control panel doore installation TS poti ModeLED Connecting cable for control panel door installation 9 BFBFT Labelling field for BFT xx EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax 900

5 Connection example / max. power input Max. power input at open bus basic module Type ArticleNo. ma B0.DI.ModbusRTU 00 0 Kanal B0.DI ModbusTCP/IP 0 0 Kanal Max. power input at open bus expansion module Type ArticleNo. ma EDI 0 0/channel EXI 0/channel EXI.AOU 0/channel Max. power input at open bus expansion module Type Article No. ma EDOW 00/channel EDOW/H 00/channel EDOOC 00/channel EDOOC/H 00/channel EDOOCP,/channel EDOOCP/H,/channel EDOTR /channel EDOTR/H /channel EXI.AOU/H 0/channel EAII..AOI 0/channel EDI.DOR 0/DI0/DO EDI.DOR/H 0/DI0/DO ENPTC 0 00/channel EDOR 00/channel EDOR/H 00/channel EAII.AOI/H 0/channel EAOU 0/channel EAOU/H 0/channel EDI.XI.AOU.DOR 9 0/DI0/DO EDI.XI.AOU.DOR/H 9 0/DI0/DO EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax RS Connection example B0.DI Modbus RTU CO Fühler RS (V) (pnpanschluss) npn Versorgung V DC V V 0V 0V C DI DI DI DI DI DI DI DI C Eingänge digital V DC Buchse RJ Switch Buchse RJ Modbus TCP/IP MikroSD Kartenslot Abschlusswiderstand R C RS ModbusRTU Gateway p n Connection example B0.DI Modbus TCP/IP

6 Connection example C XI XI XI XI XI XI XI XI C universal Eingänge 00V/PT/Ni universal Eingänge 00V/PT/Ni C XI9 XI0 XI XI XI XI XI XI C Connection example EXI RS CO Fühler RS Connection example EDI C XI XI XI XI XI XI XI XI C Universaleingänge 00V/PT/Ni Ausngänge analog 0...0V U0 U0 U0 U0 C Connection example EXI.AOU (V) (pnp) npn C Eingänge digital VDC Relaisausgänge 0V~ A C p n L N Connection example EDI.DOR EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax 900 0

7 Connection example C Widerstandseingänge NTC, PTC C Widerstandseingänge NTC, PTC C 9 0 C Connection example ENPTC EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax 900 Connection example EDOR OC OC OC OC C Open Collector 0 V DC npn/a 0 V RS Open Collector 0 V DC npn/a OC OC OC OC C Connection example EDOOC V V Open Collector V DC pnp/,a U 0 V U U Open Collector V DC pnp/,a U CO Fühler RS Connection example EDOOCP

8 Connection example Triacausgänge potentialfrei 00V~ 0,A Triacausgänge potentialfrei 00V~ 0,A Connection example EDOTR V AI AI AI AI C Eingänge analog 0mA passiv, Bürde = 0 Ohm aktiv, Bürde < 00 Ohm Ausgänge analog 00 ma AO AO AO AO C V 0V Connection example EAII.AOI RS CO Fühler RS (V) (pnp) npn p n DI A0 A0 A0 A0 C Ausgänge analog 00V Ausgänge analog 00V A0 A0 A0 A0 C Connection example AOU DI DI DI C XI XI Ausgänge analog 00V Relaisausgänge 0V A UO UO C R R R R XI Eingänge digital V DC universal Eingänge 00V /PT/Ni XI C ~ L N Connection example EDI.XI.AOU.DOR EAP electric GmbH Florianistraße, A 0 Bruck / Leitha office@eapelectric.at Web Tel 90 Fax 900