PlaneTRack 19" Professional ADS B Receivers

Transcription

1 PlaneTRack 19" Professional ADS B Receivers

2 High performance ADS B Receiver FPGA and Linux Single Board Computer driven Mechanical input filter with DC short protection Complete ADS B decoder compliant to ICAO Annex 10, DO 260/A/B, DOC 9871, ED 129A** Additional decoding of Mode S and TCAS frames Variety of data output formats via Ethernet Undecoded raw data Fully decoded data in ASCII CSV or JSON formats Eurocontrol Asterix CAT021 format* Built in Google Maps/Earth server for test purposes Integrated GPS receiver for accurate timestamps Multilateration capability* Industry grade 19" 2U enclosure from aluminum, VDE and CE compliant Integrated Ethernet surge protector Industry grade high reliability power supply, MTBF 20 years Dual independant receivers and power supplies with automatic switchover* Remote access (SSH) and SNMP V2c status interrogation and traps* Alarm loop potential free contact*

3 PlaneTRack Antennas and Accessories Professional 1090 MHz and GPS antennas and mounts, designed to withstand high wind loads and corrosion Clamps in land (chromed brass/aluminum) or maritime (AISI 316)* quality N connectors throughout the antenna path 1/2" high flex low loss cable 0.7dB/10m, cable lengths up to 50 meters* Optional: Active Antenna with 23 db gain (not for maritime use) for difficult reception sites* Gas tube lightning surge protectors for ADS B and GPS antenna paths PlaneTRack additional services 6, 24* or 48* months warranty packages with guaranteed in/out replacement times* EU compliant documentation with individual operating and maintenance manual Private internet site for all relevant documentation Free upgrades for Operating System and Decoder Software during warranty period Allowance for customized output format variations (CSV or JSON) *Options

4 Typical PlaneTRack ADS B Receiving System Setup

5 PlaneTRack Built In Google Maps Quick Viewer

6 PlaneTRack 19" ADS B Receiver front and rear views (Example for Type BDM with dual independant power supplies)

7 PlaneTRack Technical and Environmental Data Power Supply Input voltage 88 ~ 264VAC IEC60320 connector type C 14 Surge withstand Input frequency 300VAC surge for 5sec 47 ~ 63Hz Power Consumption Type B Type BDM typ. 230VAC / 17 W typ: 230VAC / 25 W RF receiver Antenna input impedance 50 Ohms N type connector (female) Input filter passband attenuation Input filter bandwidth Sensitivity at antenna port Lightning protection < 0.5 db < 9 3 db better than 93 dbm DC short inside filter Number of receivers 1 Receiver center frequency 1090 MHz Data processor and decoder

8 Hardware platform Processor CPU speed On board Flash memory On board RAM Linux SBC Beaglebone Black Rev. C 32 bit Cortex A8, Texas Instruments AM3358 Sitara 1 GHz 4 GB emmc 512 MB DDR3L Operating System Linux Debian 8 Kernel 4.1 Power up boot delay ADS B message formats processed and decoded Mode S message formats processed and decoded ACAS/TCAS message formats processed and decoded Decoder output formats Decoder latency to output Packet throughput GPS receiver ca. 30 secs DF17, DF18, DF19* DF4, DF5, DF20, DF21 DF0, DF16* Raw data, ASTERIX Cat 021 V0.23*, Cat 247*, ASCII CSV, ASCII JSON, KML, KMZ, customized < 10 ms > packets/sec DO 260/A/B, ICAO Doc 9871 (*DF19 not decoded) ICAO Annex 10 Part IV, ICAO Doc 9871 ICAO Annex 10 Part IV, ICAO Doc 9871 (*DF16 altitude decoded only) (*requires Software Option) (*Option MLAT only)

9 Antenna/power supply Active antenna with 5VDC power N type connector (female) Network connection Ethernet type Cat. 5e, 10/100BaseTX RJ45 connector Surge protection clamping voltage 7.5V / 70V IEC Max. surge discharge current Peak pulse current Cable length Data protocols Configuration protocols IP address 10 ka (8/20 µs) 100 A (10/1000 µs) < 100 meters TCP/IP, UDP/IP, HTTP HTTP/HTML, SSH Fixed or DHCP Alarm contact Contact type Potential free 2 screw clamps max. switchable power max. switchable voltage 24W / 24VA 24V / 1A SNMP interface Device base object id Specification V2c Dimensions Type of enclosure 19" rack insert, 2 U EIA 310 D, IEC 60297,

10 DIN Front panel width Front panel height Enclosure width Enclosure height mm 88.3 mm ca mm ca. 88 mm Enclosure length ca. 300 mm without handles Gross Weight ca. 4.5 kgs receiver only; ca. 6.5 kgs all components Ambient temperature 0 to +40 C 32 F to 104 F Relative humidity <= 80% Cooling Enclosure ingress classification natural convection, no fan IP52 Purpose Disclaimer: Planevision Systems PlaneTRack ADS B equipment is not intended and not certified for air traffic control, navigational purposes, other essential aircraft on board services or other life critical services and in no case may be used for any other but sole information purposes.