BT210 BLUETOOTH HEADSET. User s manual. Version 1.0 T R U S T. C O M L I F E I S M O R E! T R U S T U S

Transcription

1 BT210 BLUETOOTH HEADSET U K User s manual Version 1.0 L I F E I S M O R E! T R U S T U S T R U S T. C O M

2 BT210 BLUETOOTH HEADSET Thank you for your purchase. Register your product via our Internet site at so that you will be eligible for optimal guarantee and service support. You will also be automatically informed of the development of your and other Trust products. U K L I F E I S M O R E! T R U S T U S T R U S T. C O M

3 BT210 BLUETOOTH HEADSET Fig. 1 L I F E I S M O R E! T R U S T U S T R U S T. C O M

4 1 Introduction This instruction manual is for users of the TRUST BT210 BLUETOOTH HEADSET. The Bluetooth Class 2 technology means that the TRUST BT210 BLUETOOTH HEADSET can be used as a wireless headset with a maximum distance of 10 metres between the wireless headset and your Bluetooth compatible device, such as a mobile telephone (the distance also depends on the type of mobile telephone), to give you greater freedom of movement. 2 Safety Carefully read the following instructions before use: - The TRUST BT210 BLUETOOTH HEADSET does not require any special maintenance. Use a slightly damp, soft cloth to clean the headset. - Do not use aggressive substances, such as white spirit, to clean the device. These may harm the material. - Do not use this device near water. - Do not repair this device yourself. - Nowadays, there are an increasing number of wireless products (video, audio, convenience, computer, etc.) which work in the same frequency range as this device. It may, therefore, be possible that the functionality of this device is limited by or is limiting for other wireless devices. This can only be avoided by paying attention to the distance between devices and, where possible, by changing channels. - Be careful when using wireless devices if you have a pacemaker or are dependent on other life-saving, sensitive electronic equipment, because this product transmits radio signals. U K 1

5 3 Approval This device meets the essential requirements and other relevant conditions of the applicable European directives. The Declaration of Conformity (DoC) is available at - This wireless device works at a frequency of 2.4 GHz. It meets the essential requirements and other relevant conditions of R&TTE Directive 1999/5/EC and can be used in all EU countries: Great Britain, Germany, Belgium, France, Spain, Portugal, Italy, Switzerland, Austria, Denmark, Norway, Sweden, Finland, the Netherlands, Iceland, Ireland, Greece and Luxembourg. - There may be restrictions for the use of this device outside of the EU. If this device is used outside of the EU, check whether this device meets local regulations. Frequency: GHz; 2.440~2.4835, Bandwidth: 1MHz (Bluetooth Standard), Power: 1 mw. 4 Functions 4.1 Headset functions Use table 1 in combination with figure 1. No. Description Function 1 On/Off button - Press this button for a couple of seconds to turn the headset on or off. - Answer/end telephone conversation. 2 Increase volume button Increases the volume. 3 Decrease volume button Decreases the volume. 4 Status LED 5 Ear clip 6 Power adapter input 7 Microphone Microphone 8 Speaker Speaker Table 1: Headset functions Indicates the status of the headset (see table 2). Use this to attach the headset to your ear. This headset can be attached to either the left or right ear. Connect the adapter here to recharge the headset. 2

6 4.2 Headset functions LED Flashing Blue Flashes 4 times Blue & red Alternating Flashing Red Lit constantly Table 2: Description of the status LED Description Headset is turned on. An incoming or outgoing conversation has been detected. The headset is attempting to make a connection with your mobile telephone. The battery is almost empty. The headset s battery is being charged. U K 5 Using for the first time Note: This chapter uses a Bluetooth mobile telephone as an example of a Bluetooth device. This chapter explains how to create a connection and hold a telephone conversation using the Bluetooth headset. 5.1 Charging the battery Charge the headset s battery using the power adapter before use (see step 1 of the Quick Installation Guide). The status LED will be lit red continuously. The status LED will go out once the headset has been charged. Note: Note: It takes 2-3 hours to charge the battery. Whilst charging the battery, it is not possible to create a Bluetooth connection between the headset and your mobile telephone. 5.2 Use Registering the headset on the mobile telephone Note: During registration, the distance between the headset and your mobile telephone must not be greater than 1 metre. If you wish to use the headset, a connection must first be created with your mobile telephone (see steps 2 and 3 of the Quick Installation Guide). 3

7 5.2.2 Answering and ending a telephone conversation Once a call is received, the status LED on the headset will start to flash. Press the On/Off button (1, figure 1) to accept the call (see step 4 of the Quick Installation Guide). Press the On/Off button again to end the call Altering the volume Press the + button (2, figure 1) on the headset to increase the volume. Press the button (3, figure 1) on the headset to decrease the volume. See step 5 of the Quick Installation Guide Turning off the microphone To turn the microphone off during a conversation, press the + button (2, figure 1) and the button (3, figure 1) until two short beeps are heard. The microphone will then be turned off. To turn the microphone back on, follow the procedure required to turn the microphone off Making an automatic call Note: This option only works in combination with Sony Ericsson mobile telephones. Carry out the following to make an automatic call using voice recognition: 1. Record your voice and link it to the desired telephone number stored on your mobile telephone (see the instruction manual provided with your mobile telephone). 2. Turn on your headset as described in steps 2 and 3 of the Quick Installation Guide. 3. Press the On/Off button (1, figure 1) until a short, high pitched tone is heard. 4. You may then hear another signal (depends on the type of mobile telephone). 5. Speak the name of the person that you wish to call Turning the headset on and off Press the headset s On/Off button (1, figure 1) for a couple of seconds until the red status LED starts to flash. The headset is now turned off. Follow the same procedure to turn the headset on again. 4

8 6 Using the headset with a computer This headset can be used in combination with a PC USB dongle. Make sure the headset has been enabled in the dongle s software (see the instruction manual provided with the dongle for more information). 7 Troubleshooting Method 1. Read the solutions given below. 2. Check for up-to-date FAQs, drivers and instruction manuals on the Internet ( Problem Cause Possible solution The Bluetooth headset is not detected by the mobile telephone. The headset is turned off. Turn the headset on (see chapter 5.2.1). The PIN code does not work. The sound is too low. The sound is poor or keeps fading. The problem is not listed here. The distance between the headset and the mobile telephone is too great. The wrong PIN code has been entered. The volume has been set too low. The distance between the headset and the mobile telephone is too great. There may be other wireless devices active, such as a wireless network, which affect the connection between the headset and the mobile telephone. There is a poor GSM connection. The latest FAQs are available on the Internet. When creating a connection, make sure the headset and the mobile telephone are no more than 1 metre apart. Enter 0000 as the PIN code. Increase the volume using the volume buttons on the headset (see chapter 5.2.3). Reduce the distance. Go to a different location. Turn the other wireless devices off. Go to a different location. Make the call again.! Go to for FAQs and other product information. U K If you still have problems after trying these solutions, please contact one of the Trust Customer Care Centers. You can find more information at the back of this instruction manual. Please have the following information available: The item number. This is A good description of what does not work. A good description of when the problem occurs. 5

9 8 Warranty conditions - Our products have a two-year manufacturer's warranty which is effective from the date of purchase. - If there is a fault, return the product to your dealer and include a description of the fault, the proof of purchase and all the accessories. - During the warranty period, you will receive a similar product, if one is available. If no similar product is available, your product will be repaired. - Please contact our help desk for missing components, such as the instruction manual, software or other components. - The warranty becomes invalid if the product has been opened, if there is mechanical damage, if the product has been misused, if alterations have been made to the product, if the product has been repaired by a third party, in the case of negligence or if the product has been used for a purpose other than that originally intended. - Excluded from the warranty: Damage caused by accidents or disasters, such as fire, flood, earthquakes, war, vandalism or theft. Incompatibility with hardware or software not stated in the minimum system requirements. Accessories, such as batteries and fuses (if applicable). - Under no circumstances will the manufacturer be held responsible for any incidental or consequential damage, including the loss of income or other commercial losses resulting from the use of this product. 6

10 CUSTOMER CARE CENTERS 24 HOURS free service: Residents in the UK and Ireland should contact: Mon - Fri From 8:00-16:00 UK Office Phone +44-(0) I residenti in Italia possono contattare: lun - ven 9:00-13:00 / Ufficio italiano Telefono :00-18:00 Fax Les habitants de la France et de l Afrique du Nord peuvent contacter : Lundi-vendredi De 9:00 à 17:00 Bureau français Téléphone +33-(0) Kontaktadresse für Einwohner Deutschlands: Mo Fr 9:00-17:00 Deutsche Geschäftsstelle Telefon TRUST ( ) Los habitantes de España pueden ponerse en contacto con: Oficina española lun viernes De las 9:00 a las Teléfono +34-(0) :00 horas Osoby mieszkające na terytorium Polski powinny skontaktować się: Od pon. do pt. w godz 09:00-17:00 Biuro w Polska Tel +48-(0) Inwoners van Nederland kunnen contact opnemen met: ma vr 9:00-17:00 uur Kantoor Nederland Telefoon 0800-BELTRUST ( ) All other countries / Alle anderen Länder / Tous les autres pays Tutti gli altri paesi / Todos los demás países / Alle andere landen European Head Office Mon - Fri Phone +31-(0) From 9:00-17:00 L I F E I S M O R E! T R U S T U S T R U S T. C O M