Trio Q. Licensed UHF Ethernet and Serial data radio. QP450 Hot Standby Half Duplex

Transcription

1 Trio Q Licensed UHF thernet and Serial data radio QP450 Hot Standby Half Duplex

2 1 Trio Q Data Radios are advanced, high-speed licensed digital data radios, providing both thernet and serial communications for complex and demanding applications in Point-to-Point and Point-to-Multipoint (Multiple Address Radio) Telemetry and remote SCADA systems. Features such as ChannelShare+ and web-based user configuration, together with powerful remote diagnostics and Network Management, make Trio Q Data Radios the complete licensed radio solution that works with leading host systems and remote equipment. Combining both thernet and serial connectivity, Trio Q Data Radios are suitable for use with the latest SCADA technology as well as providing a smooth transition from serial-based infrastructure to IP/thernet. Complimenting the QR450 half duplex remote radio, the QP450 half duplex radio is ideal for deployment at base & repeater sites in systems using single frequency (simplex) operation. In high duty cycle applications, the QP450 delivers maximum rated transmitter power in ambient temperatures up to +70 C (158 F).

3 Specifications 2 Trio QP450 Radio Frequency Range Frequency Splits Channel Selection Channel Spacing Frequency Accuracy Aging Radio Modes Transmitter Tx Power Modulation Tx Keyup Time Timeout Timer Tx Spurious PTT Control Receiver AFC Tracking Mute Connections Serial Interface 1/ MHz (L-and) or MHz (H-and) Various frequency splits - configurable 3.125kHz channel steps 12.5 and 25kHz (software selectable) ±0.5ppm, -40 to +70 C (-40 to 158 F) ambient <= 1ppm/annum Simplex or Half duplex 0.05 to 10W (+17 to +40dm) +/- 0.1d configurable with over-temperature and high VSWR protection Narrow band 2, 4, 8 and 16-level continuous phase modulation <1ms Configurable 0 to 255 seconds <= -37dm Auto (Data) Digital receiver frequency tracking Configurable digital mute 1 x D9 female connector providing 2 x RS wire serial ports or 1x RS485 serial port (shared connector). Serial Interface Speeds Serial Interface Flow Control Serial Interface DCD Control From 600bps up to 115,200bps Configurable hardware / 3-wire interface Configurable DCD operation : activated on RF carrier or from user data output thernet Port 3 x RJ45: 10/100 Mbps (auto-mdix sensing) compliant with I Antenna Power LD Display thernet Refer to diagram at end of datasheet for detailed information - 2 x N female bulkhead (Refer Option ) - 1 x N female bulkhead (Refer Option ) 10-pin locking, mating connector (11-30 V DC) Multimode Indicators for DC Power, Transmit, Receive, Synchronised Data, Serial Interface 1 & 2 Transmit & Receive Data, thernet 1 & 2 Transmit & Receive Data Supported Protocols thernet Repeating Operating Modes thernet Traffic Filtering Compression Terminal Server IP Configuration SNMP Modbus Gateway thernet (including UDP, TCP, DHCP, ARP, ICMP, STP, IGMP, SNTP & TFPT) Automatic Peer to Peer repeating Layer-2 thernet ridge mode / Layer-3 IP Router mode Configurable: No Filtering / Unicast Traffic & ARP Only / Unicast Traffic Only / List of approved MAC addresses Automatic data compression Legacy RS-232/RS-485 serial support via embedded terminal server (UDP/TCP) Auto (DHCP) and Manual SNMP V1,V2c, RFC 1213-compliant & radio diagnostics parameters (with notifications) Configurable MODUS/TCP to MODUS/RTU Gateway Time Server Specifications continue on the next page NTP Client / Server / Client-Server / Manual modes

4 Specifications 3 Modem Trio QP450 RF Channel Data Rate 1 Regulatory Region andwidth (KHz) Speed (Kbps) RF 1x10-6 R Sensitivity (dm) FCC/IC ACMA/TSI Dynamic Speed Selection Operating Modes Collision Avoidance ackward Compatibility 2 Firmware Security ncryption 3 HTML Interface Console Interface Password Protection Hot Standby Change-over control QoS/RSSI based Automatic Speed Selection or Fixed speed mode ase, remote, repeater or store n forward Channelshare+ - Advanced dynamic supervisory collision avoidance system Carrier Sense - Carrier sense based collision avoidance system ackward compatible with Trio -Series radios Local and over-the-air flash-based firmware upgradable patches with support for broadcast updates 256-bit AS Password Protected HTTP and HTTPS configuration and management interface Password protected Telnet, SSH and Serial console interface Password protected configuration sessions Manual (front panel switch) / automatic upon alarm / automatic upon timer / remote (software driven) Alarm Monitoring Diagnostics Diagnostics Overview Logging Diagnostics & Configuration Ping Tester Specifications continue on the next page Transmitter / General Alarms / Power Supply Network management and diagnostic Windows GUI software Network-wide operation from any remote terminal Non intrusive protocol runs simultaneously with the application Storage of data error and channel occupancy statistics mbedded rror Rate testing capabilities Diagnostics parameters available Transmitter Power Received Signal Strength DC Supply Voltage Received Frequency Offset Radio Temperature VSWR mbedded event and performance logs including time stamped data statistics and channel occupancy Configuration via embedded HTTP, HTTPS web interface & or Telnet/SSH/Serial console mbedded ping test facility

5 QP450 QP450 RLAY (Coaxial Transmitter Switch) Hot Standby Options Product Data Sheet Trio QP450 Specifications 4 Trio QP450 General Operating Temperature Range Cooling Input Voltage Input Power (Tx typical) Input Power (Rx typical) Housing & Dimensions Weight -40 to +70 C (-40 to 158 F) ambient uilt in temperature controlled fan 11-30V DC 55 30dm, 71 37dm, 85 40dm 14W 19 (483mm) 1 RU rack mount. Without mounting brackets, D:424 x H:44.45 x W:436.5mm (D:16.7 x H:1.75 x W:17.18 ) 5kg (11lbs.) Warranty 3 years on parts and labor Approvals and Certifications urope (TSI) TSI N , N , N United States (FCC) FCC PART 15, PART 90 Canada (IC) Australia (ACMA) IC RS119, ICS-001 ACMA AS (Data)

6 Model 5 TURQP4HN-001L0 represents a typical part number Model TURQ P Trio Radio Q450 Q Data Radios Select: Unit Type Half Duplex Hot Standby Radio RU Select: Generic Frequency and 4 UHF: MHz and Select: Sub and - UHF L H Low and : 400 to 450MHz High and : 450 to 518MHz Select: Reserved for future use N Reserved for future use Select: Regulatory Region 1 00 TSI/ACMA Region F00 FCC Region Select: ncryption 3 N 1L 256-bit AS encryption (standard) No encryption Select: Licensed Feature thernet & Serial (Two thernet & two Serial Ports) Select: Power Supply V DC Select: Hot Standby Options Duplicated Ports Common switched Port xample: TURQP4LN-001L0 specifies: Trio QP450 Hot Standby half duplex radio, 400 to 450MHz, TSI/ACMA Regulatory Region, 256 bit ncryption enabled, three thernet & two Serial Ports, 11-30V DC power supply, Duplicated Ports. Radio Regulatory Standards: FCC Federal Communications Commission IC Industry Canada TSI uropean Telecommunication Standards Institute ACMA Australian Communications and Media Authority Note 1: Availability of radio models is dependent on country of deployment. Local and regulatory conditions may determine the performance and suitability of the radio in different countries. It is the responsibility of the buyer to ensure the radio model meets the regulatory conditions required. Contact your local Schneider lectric sales office for more details. Note 2: ackward compatibility is not available for all types & models of Trio radio. Not all features are available when operating in backward compatible mode. Contact your local Schneider lectric sales office for more details. Note 3: xport and import restrictions may apply. Note 4: Other country and radio regulatory regional approvals are available upon request. Contact your local Schneider lectric sales office for more details. Disclaimer: Not all product features are available in every mode of operation. Schneider lectric reserves the right to change product specifications. For more information visit

7 Dimensions and Options 6 QP450 - Hot Standby Half Duplex Radio - Dimensions QP450 - Hot Standby Half Duplex Options QP450 QP450 RLAY (Coaxial Transmitter Switch) Hot Standby Options QP450 Hot Standby Option Descriptions Description Duplicated Ports Common Switched Port Antenna Type Duplicated Antennas Common Antenna 2014 Schneider lectric. All Rights Reserved. Schneider lectric, Trio, and ChannelShare+ are trademarks and the property of Schneider lectric S, its subsidiaries and affiliated companies. All other trademarks are the property of their respective owners. February 2015 Telemetry & Remote SCADA Solutions Part Number TULM v11 Document number 0100R1424