CertShiken という認定試験問題集の権威的な提供者. CertShiken.

Transcription

1 CertShiken という認定試験問題集の権威的な提供者 CertShiken

2 Exam : CWNA-107 Title : Certified Wireless Network Administrator Vendor : CWNP Version : DEMO Get Latest & Valid CWNA-107 Exam's Question and Answers 1 from Certshiken.com. 1

3 NO.1 A client STA must choose the best AP for connectivity. As part of the evaluation, it must verify compatible data rates. What can the client STA use to verify that an AP supports the same data rates that it supports? A. Authentication frames transmitted by the other client STAs B. Beacon frames transmitted by the AP C. Data frames sent between the AP and current client STAs D. Probe request frames transmitted by other client STAs NO.2 You are deploying a WLAN monitoring solution that utilizes distributed sensor devices. Where should sensors be deployed for best results? Choose the single best answer. A. Closer to the APs B. Closer to the client devices C. Every 20 feet and alongside each AP D. IN critical areas where WLAN performance must be high Answer: A NO.3 The IEEE standard requires VHT capable devices to be backward compatible with devices using which other physical layer specification (PHY)? A. HR/DSSS B. DSSS C. ERP-PBCC D. OFDM Answer: D NO.4 When replacing the antenna of a WLAN device with a similar antenna type that has a higher passive gain, what antenna characteristic will decrease? A. Active gain B. Beam width C. Range D. Fresnel Zone size E. Receive sensitivity NO.5 When a client station sends a broadcast probe request frame with a wildcard SSID, how do APs respond? A. After waiting a SIFS, all APs reply at the same time with a probe response. B. Each AP checks with the DHCP server to see if it can respond and then acts accordingly. C. Each AP responds in turn after preparing a probe response and winning contention. D. For each probe request frame, only one AP may reply with a probe response. NO.6 ABC Company is planning a point-to-multipoint bridge deployment with standalone Get Latest & Valid CWNA-107 Exam's Question and Answers 2 from Certshiken.com. 2

4 (autonomous) bridge units X/EAP will be used for bridge authentication. A Linux-based RADIUS server will be used for authentication. What device in the bridge implementation acts as the X Authenticator? A. All non-root bridges B. The root bridge C. The Ethernet switch D. The RADIUS server NO.7 In addition to coverage analysis result, what should be included in a post-deployment site survey report to ensure WLAN users experience acceptable performance? A. WAN interface analysis results B. Application Layer protocol availability analysis results C. Capacity analysis results D. Layer 4 protocol availability analysis results NO.8 A non device is suspected of causing interference on the WLAN. You are not certain of the location or type of device. What is the best solution for locating this non device? A. Laptop-based spectrum analyzer with a directional antenna. B. Laptop-based spectrum analyzer with an omni-directional antenna. C. Access point spectrum analyzer D. Laptop-based spectrum analyzer with an omni-directional antenna NO.9 A natural disaster has occurred in a remote area that is approximately 40 miles from the response team headquarters. The response team must setup a local wireless network using WLAN access points. What is the best method, of those listed, for implementation of network backhaul for communications across the Internet in this scenario? A. Cellular/LTE B. Temporary wired cable C bridging D. Temporary wired DSL Answer: A NO.10 You are evaluating a connection that states the data rate is 150 Mbps. What is the expected throughput of this connection? A. 54 Mbps because that is the actual maximum throughput of an connection B. 150 Mbps because the data rate is equal to the throughput C. Less than 150 Mbps because of overhead and contention D. More than 150 Mbps because of compression Get Latest & Valid CWNA-107 Exam's Question and Answers 3 from Certshiken.com. 3

5 NO.11 In a mesh BSS (MBSS), according to the standard, what device connect the mesh to an Ethernet network? A. Mesh Router B. Mesh Portal C. Mesh Gate D. Mesh Switch NO.12 When using an RF splitter to connect one transceiver to sector antennas loss is incurred. What is this loss called? A. Conversion loss B. Intentional loss C. Active loss D. Through loss Answer: D Get Latest & Valid CWNA-107 Exam's Question and Answers 4 from Certshiken.com. 4