PCM-2SL6X-CL Series Motherboard User Guide. Ver 1.0

Transcription

1 PCM-2SL6X-CL Series Motherboard User Guide Ver 1.0

2 Contents 1. Models and Attentions Models Attentions Specification Data Flow Jumpers / s and Connectors Definition of Jumpers / s and Connectors BIOS setup

3 1. Models and Attentions 1.1 Models This manual is applied to following models: Model Chipset COM LAN HDMI VGA USB Mini-PCIE LVDS PCM-2SL6X-CL-H 3855U Dual 24-bit PCM-2SL6X-CL 3855U Dual 24-bit 1.2 Attentions 1) Notes under a table or figure indicate the difference of models, or alternative definition of specific pin of the header (jumper/connector). 2) How to identify the first pin of a header or jumper Usually, there is a thick line or a triangle near the header s or jumper s pin 1. Square pad, which you can find on the back of the motherboard, is usually used for pin

4 2. Specification Model CPU Display Memory PCM-2SL6X-CL-H Intel Celeron 3855U, Dual-core, clock speed 1.6GHz, TDP 15W 1 * VGA 1 * Dual Channel 24-bit LVDS [1] Support LPDDR3-1866/1600, DDR3L-1600/1333, 1 * SO-DIMM Slot, Up to 8GB Storage 1 * SATA * msata [2] Ethernet Audio 1 * Realtek PCI-E NIC RTL8111F for 1000Mbps Realtek ALC Channel HDA Codec, Support MIC/Line-out Ports 1 * Amplifier, 6-W (per channel) into an 8-Ω Loads COM 4 * RS232 [3] USB: 2 * Rear I/O(USB3.0/USB2.0) + 2 * Rear I/O(USB2.0) [4] Other Ports Temperature BIOS + 5 * (USB2.0) [5] 8 * GPIO 1 * Parallel Pin 1 * PS/2 Pin 2 * Mini PCI-E [2] [5] 1 * SIM Card Slot 1 * Front Audio 1 * 12V/5V DC_OUT Power Output Connector 2 * 12V DC_IN Power Input Connector 1* Seavo IO Connector 1* Cash Drawer Pin Storage: -20~75 Operating: 0~60 AMI UEFI BIOS Factor Mini-ITX (170mm * 170mm) Notes: [1]: The LVDS supports a max resolution of 1920x1200.And it also can support EDP if specified. [2]: Mini PCI-E2 slot supports msata by default, msata and S_ATA1 share the same signal, if msata is desired, S_ATA1 should be removed. [3]: HDMI and COM1 (DB9) Connector on rear I/O share the same position and are mutually exclusive, when HDMI populated, COM1 is available via J_COM1 Pin. [4]: LAN2 and USB2.0 Connectors on rear I/O share the same position and are mutually exclusive, if LAN2 is desired, USB2.0 Connectors should be removed, one more front USB header can be supplied

5 [5]: Mini PCI-E1 slot supports Wifi and 3G by default, And if Mini PCI-E1 do not support 3G device, one more front USB header can be supplied (see page 8). 3. Data Flow DDR 3L SO-DIMM Slot PCI-E *1 Realtek 8111F RJ45 Port LVDS Dual 24Bit Bridge edp PCI-E *1 Realtek 8111F RJ45 Port VGA HDMI Bridge DDI2 DDI1 DP Intel PCI-E*1 USB2.0 *1 SIM UIM Mini PCI-E1 USB2.0 SATA Port2 SATA Port1 SATA2.0*1 SATA2.0*1 SKYLAKE SoC Celeron 3855U USB2.0 *1 LPC USB2.0 Seavo IO Connector Mini PCI-E2 Line out MIC Amplifier Audio CODEC USB2.0 *4 USB2.0 *2 USB2.0 *4 USB2.0 2Ports USB2.0 *2 COM 4Ports LPC USB2.0/USB3.0*2 USB3.0 2Ports LPT Super I/O PS/2-4 -

6 4. Jumpers / s and Connectors -5-

7 Jumpers / s and Connectors 1 DC12V Power Input Connector P 7 22 COM1 Pin P 12 2 LVDS Backlight Control Pin P 7 23 COM1 Pin1 Signal Select Jumper P 12 3 Cash Drawer Pin P 7 24 Front Audio Pin P 12 4 PS/2 Pin P 7 25 Amplifier Pin s P 13 5 System Fan Connector P 7 26 LVDS VDD Select Jumper P 13 6 DC12V/5V Power Output Connector P 8 27 LVDS Signal Pin P 13 LVDS Backlight PWM/CCFL Select 7 Front USB Pin s P 8 28 Jumper 8 Front Panel Pin P 9 29 VGA Pin P 14 9 SATA Power Pin s P 9 30 SO-DIMM Slot 10 CMOS Clear Jumper P 9 31 SATA 2.0 Connector 11 CPU Fan Connector P 9 32 Mini PCI-E2 Slot 12 ME Flash Pin 33 Mini PCI-E1 Slot 13 Parallel Pin P 9 34 Seavo IO Connector 14 GPIO Pin P SIM Card Slot 15 COM4 Pin9 Signal Select Jumper P DC 12V Power Input Connector 16 COM4 Pin P VGA Connector 17 COM4 Pin1 Signal Select Jumper P COM1 Connector [1] 18 COM3 Pin P USB3.0 Connectors 19 COM3 Pin1/9 Signal Select Jumper P USB2.0 Connectors [2] 20 COM2 Pin P LAN Connector 21 COM2 Pin1/9 Signal Select Jumper P Audio Connectors Note: [1]: HDMI and COM1 (DB9) Connectors on rear I/O share the same position and are mutually exclusive. [2]: LAN2 and USB2.0 Connectors on rear I/O share the same position and are mutually exclusive. P