AVR Development Tools. Shenzhen April 2005

Transcription

1 AVR Development Tools Shenzhen April 2005 Atmel Norway 2005

2 AVR Development Tools Shenzhen April 2005 Only one chain of tools is required... 1

3 2 AVR Studio Integrated Development Environment for AVR Includes Atmel Macro Assembler Front End for Atmel Starter Kits, Programmers, and Emulators C and Assembly Source Level Debugging Supports Third Party Compilers Maintains Project Information Available for free from

4 AVR Studio Shenzhen April ONLINE HELP FILES * ICE50 * ICE40 * JTAGICE mkii * JTAG ICE * AVRISP * STK500 * STK501 * STK502 DISASSEMBLER VIEW View mixed C and assembly code during debugging AVR Assembler integrated Trace supporting ICE50 I/O VIEW View details on Core and Peripherals SOURCE FILE EDITOR Assembly and C Statement Highlighting WATCH VIEW View variables and structs

5 4 JTAGICE mkii for On-Chip Debugging Real-time emulation in actual silicon Debug the real device at the target board Talks directly to the device through 4(5)-pin JTAG or 1pin debugwire interface Debugging access to: All internal peripheral units Internal and external RAM The internal register file Program counter EEPROM and Flash Memories Full execution control Single step, run, etc. Unlimited number of breakpoints Supported by AVR Studio

6 5 JTAGICE mkii Additional Features In-System Programming via JTAG High Speed: Comparable to Parallel Programming Example: ATmega16: 16kB Flash (write and verify approx 5sek) Full Support for LockBits and Fuses Only 4(5) lines required (Uses the JTAG Lines) Front-end software integrated in AVR Studio DOS command line front-end Firmware upgradeable from AVR Studio Auto detect old firmware Free

7 6 JTAGICE mkii for debugwire Debugging Communication speed auto detection No manual clock settings by user System clock not affected by debugwire OSCCAL can be changed during debugging Limited ISP support via SPI interface DWEN fuse enabling via ISP Chip erase via ISP DWEN disabling via debugwire Disable debugwire from AVR Studio

8 7 Connecting debugwire to an Application Recommended connector is 6pin ISP header Includes ISP communication pins, Vcc, GND and Reset Ensures all required ISP and debugwire pins on the same header Fit standard ISP programmers JTAGICE mkii SCK, MISO and MOSI are high impedance when running debugwire No disconnect of ISP pins are required while debugging MISO VTG SCK RST MOSI GND ISP6PIN

9 8 ICE50 Emulator AVR Studio as front-end Emulates all peripherals, both digital and analog Supports all instructions and peripherals real-time Jumperless Design All configuration done from AVR Studio Unlimited Number of Breakpoints Trace Profiling Source Level Debugging Supports all new MegaAVR and TinyAVR Products

10 9 AVR STK500 Starter Kit Integrated ISP and Parallel programmer for all AVRs Early support for new devices Supports all AVR devices up to 40 pin onboard Interfaces with AVR Studio Firmware upgradeable Software selectable voltage and frequency Push Buttons, LEDs & RS232 6 and 10 pin ISP output In-System Programming Onboard oscillator

11 STK500 Features Shenzhen April Software selectable Voltage and Frequency 6 and 10 pin ISP output for In-System Programming Command-line interface for production programming Expansion Headers for Plug-In modules and Prototyping Area Additional RS-232 Port For General Use Onboard Oscillator X-tal oscillator SW adjustable oscillator Firmware upgradeable from AVR Studio LEDs and Switches In-System Calibration of AVR s internal RC oscillator Only 4 lines required (Uses the ISP Lines) AVR053: Calibration of the internal RC oscillator

12 11 STK501 Top Module STK500 top module ATmega64 / ATmega128 / AT90CANm128 ZIF socket and PCB footprint for 64pin TQFP ( Footprint fitting ICE50 adapter ) JTAG connector Onboard 32kHz oscillator Additional RS-232C port Footprint for 128K XRAM Address latch included

13 STK502 Top Module Shenzhen April STK500 expansion module for ATmega169 ZIF socket and PCB footprint for ATmega169 ( Footprint fitting ICE50 adapter ) Onboard 32KHz oscillator Onboard LCD Glass Onboard temperature sensor AVR065: LCD Driver for the STK502 AVR064: STK502 - A Temperature Monitoring System with LCD Output

14 13 STK503 Overview Supports all upcoming 100 pin devices Same feature set as STK501 Pin-out for external SRAM 2 additional RS232 channels ZIF socket Onboard 32kHz crystal

15 14 STK504 Overview Expansion Module for 100-pin LCD parts ATmegaxx90 Onboard 32 khz Oscillator Supports all Programming modes Display Driver for STK504 available for download Versatile LCD display ZIF Socket

16 15 ATDVK90CAN1- CAN Development Board Development Board for AVR with CAN interface AT90CAN128 CAN port with RxCAN and TxCAN LEDs LIN port with RxLIN and TxLIN LEDs AVR Studio software interface ISP and JTAG connectors Dual RS-232C interface SPI and TWI port Available in Q205

17 16 ATADAPCAN01 - CAN Extension Adapter CAN add-on extension to STK500/STK501 CAN driver adapter for ATmega128CAN11 s CAN interface CAN transceivers, termination options, ++ Footprint for second transceiver on PCB All the electrical features necessary to seamlessly connect the AT90CAN128 to a CAN bus AT90CAN128 s CAN controller support BOSCH GmbH s Controller Area Network (CAN) specification

18 17 AVRISP for Low Cost In System Programming Supports All In-System Programmable Devices Front-end software integrated in AVR Studio Windows and DOS command line front-end Firmware upgradeable from AVR Studio 6 and 10 pin programming header Support 2.7V to 5.5V target voltage In-System Calibration of AVR s internal RC oscillator Only 4 lines required (Uses the ISP Lines) AVR053: Calibration of the internal RC oscillator

19 AVR Butterfly Shenzhen April Complete reference design based on ATmega169 Focus on Low Power Includes: UART, USI, SPI communication Boot loader, JTAG, ISP and Parallel Programming interfaces Light & temp sensors Graphics, LCD Sound, Piezo element Control, Joystick Supplied with source code Encourage SW dev. Demonstration tool Development tool Control module Gadget

20 AVR Application Notes Shenzhen April Released News AVR001: Conditional Assembly and portability macros AVR053: Calibration of the internal RC oscillator AVR054: Run-time calibration of the internal RC oscillator AVR068: STK500 Communication Protocol AVR097: Migration between ATmega128 and ATmega2561 AVR098: Migration between ATmega169 and ATmega329 AVR151: Setup and use of the SPI AVR230: DES Bootloader AVR310: Using the USI module as a I2C master AVR311: Using the TWI module as I2C slave AVR312: Using the USI module as a I2C slave AVR315: Using the TWI module as I2C master AVR317: Using the USART on the ATmega48/88/168 as a SPI master AVR318: Dallas 1-Wire master AVR319: Using the USI module for SPI communication AVR336: ADPCM Decoder AVR502: Migration between ATmega165 and ATmega Application notes for AVR are available from > 90 application notes

21 20 News - AVR001, AVR315 and AVR317 AVR001: Conditional Assembly and portability macros This application note describes the Conditional Assembly feature present in the AVR Assembler version 1.74 and later. Examples of how to use Conditional Assembly are included to illustrate the syntax and concept. AVR315: Using the TWI module as I2C master This Application Note describes a TWI master implementation, in form of a fullfeatured driver and an example of usage for this driver. AVR317: Using the USART on the ATmega48/88/168 as a SPI master Some applications might need more than one SPI module. This can be achieved using the new Master SPI Mode of the ATmega48/88/168 USART.

22 21 3rd Party Vendors Compilers 16+ companies (22+ products) C BASIC C++ PASCAL FORTH Programmers 35+ companies (53+ products) Real Time Operating Systems 8+ companies (10+ products) Adapters 5+ companies Emulator, Programming, Prototype and Logic Analyzer Adapters

23 22 AVR Compilers Third Parties Provide a Full-Scale of C Compilers Low Cost to High End Compilers High End Compilers IAR Embedded WorkBench AVR for AT90S and megaavr Low Cost Compilers ImageCraft ICCV7 for AT90S and megaavr ICCtiny for AVR devices with no on-chip SRAM CodeVisionAVR for AT90S and megaavr Rowley Crossworks for megaavr Freeware GNU AVR-GCC for tinyavr, AT90S, and megaavr

24 23 IAR EWAVR Kick Start Edition Free evaluation version Limited to 4kB code No time limit Available on AVR Technical Library CD C-Spy Full part support Same as full version AVR Studio UBROF-format

25 24 CrossWorks - New AVR Compiler Rowley Associates (UK) Integrated development environment platform Cross-Compiler and debug targets plugs in Faster timer to market Currently supports Windows platforms Linux x86 available soon, Mac OS X + Solaris (SPARC) planned

26 25 CrossWorks AVR at a glance An integrated tools suite for AVR development Source editor, project and symbol browser C-compiler with linker and code optimizer Pre- and post linker stage Debugger Debugging targets Simulator JTAGICE mki and mkii Proprietary object format ELF/DWARF support expected in 2005 Required for AVR Studio support EURO 712 (USD 910)

27 26 Highlights/Lowlights Very efficent Compiler Up to 39% smaller code size than IAR 3.20C ~39% on 3DES decode/encode Lots of options High getting started threshold May seem like overkill for simple projects Practical symbol browser Linked objects overview Source navigator Debugger has poor interface Compared to AVR Studio

28 Zigbee: 3rd Party Ember Developer Kit Shenzhen April Hardware 12 carrier boards and 12 EM2420 modules IAR full-function compiler seat (dongle license) Power-over-Ethernet injector Embedded Software [EmberNet and EmberZNet 1.0] EmberNet Stack FFD & RFD library EmberNet low level I/O source code and radio test software Rangetest low-level Gateway application Sample sensor and template applications PC Software EmberStudio GUI Gateway PC-side source code and library EmberPeek [beta] Java back-end to EmberStudio Documentation One Training Seat (2-day course) 60 Days Support

29 Zigbee: 3rd Party Ember Developer Kit Shenzhen April Full-featured Development Kits for Rapid prototyping Ethernet back-channel Sample applications Ping Traceroute

30 29 Need Help? Selection Guides, Flyers, Datasheets, Application Notes, FAQ, and Errata Sheets 3rd party web sites like Atmel and Third Party Tools AVR Experts Discussion Forum Software, User Guides and Links Design Notes and Reference Designs Consultants, Distributors and Atmel Representatives Customer Technical Support

31 AVR Development Tools Shenzhen April For more information about Atmel, AVR and AVR Development Tools : avr@atmel.com