POWER CONNECTOR RS MODULE PORT* CONNECTORS WIRING РАЗЪЕМ ПИТАНИЯ МОДУЛЯ INPUTS/OUTPUTS PORT RED CONNECTOR (2PIN)**

Transcription

1 Temperature SENSOR* (DS18B0) USB port Additional NETWORK DEVICE* MICROPHONE* SIM card chip down GlONASS GPS BTS Wi-Fi etc. NETWORK DEVICE PORT INPUTS/OUTPUTS PORT 5A FUSE * *OPTION CONNECTORS WIRING r e d black b l u e white BLACK CONNECTOR** +1 V, A Ground Rx Tx РАЗЪЕМ ПИТАНИЯ МОДУЛЯ r e d +1 V 1 black Ground RED CONNECTOR (PIN)** INPUTS/OUTPUTS PORT yellow g r e y g r e e n brown OUTPUT (+), A OUTPUT 1 ( ), A INPUT (+) INPUT 1 ( ) WHITE CONNECTOR** NETWORK DEVICE PORT 4 +3,3 V 3 Ground Rx 1 Tx BLUE CONNECTOR** TEMPERATURE SENSOR CONNECTOR ,3 Вольт Масса DATA WHITE CONNECTOR (3PIN)** MICROPHONE CONNECTOR 1 MIC +1, Вольт MIC Масса WHITE CONNECTOR (PIN)** ** rib side view Remote start Telema c control module Wiring diagrams

2 1. StartFone module MINIMUM DELIVERY SET. cable with connectors StartFone Fortin climate 3. cable StartFone 4. INPUTS/OUTPUTS PORT cable StartFone LED INDICATION (VISIBLE THROUGH SEMI-TRANSPARENT HOUSING) Operation LED response Red Blue Green White Modem restart Solid during seconds StartUP program data exchange Active in time UART port data exchange Flashing in time Remote start Solid Modem data acquisition Flashing in time Shock sensor activation Short flashes GPS receiver connected Long flashes Location fixed Short flashes Firmware GPRS downloading Solid Data storing Flashing

3 AUTOMATIC TRANSMISSION ONLY STANDARD Fortin EVO-ALL CONNECTION FUSE 5A + 1 V Ground 4-pin blue WITH T-HARNESS T-HARNESS -pin red Cut off connectors and splice wires color--color Connect EVO-ALL module to the FlashLink Updater (sold separately) and use the Flash Link Manager software to enable options B и С1. Options «by default» ( A1...A11) must be installed. Do not activate D1 option! It this case the running time is defined by StartFone only. 3

4 Fortin EVO-ONE CONNECTION INPUTS/OUTPUTS PORT INPUT Green (+) Brake -pin red 4-pin black Connect StartFone to PC by USB cable, start StartUP program and set up FORTIN protocol via menu: Settings» Type of bus protocol» Bus protocol: FORTIN If the SIM card had been installed earlier and StartFone is registered in the GSM net you can achieve the same result by direct SMS command like: PASS*974*1# (where PASS is the access code equals to 134 by default). Connect EVO-ONE module to the FlashLink Updater (sold separately) and use the Flash Link Manager software to enable option С1 (Bypass) Install option 38.4 (Remote-Starter). It this case the running time is defined by StartFone only. You must synchronize EVO-ONE и StartFone modules after it: STEP 1 STEP STEP 3 STEP 4 X1 STEP 5 STEP 6 X5 ПОДОЖДИТЕ Turn the Ignition on. Press and hold the valet switch until the sound confirmation, then release. The parking lights will turn on, the red LED flash rapidly. Press and release the valet switch 5 times. Each pressure will be confirmed by siren chirp, parking lights spark and red LED flash. Press and release the brake-pedal once. The red LED will flash once. The synchronization process will start automatically. One can see four parking lights and LED flashes during it. Turn the Ignition off. 4

5 climate (MERСEDES) CONNECTION AUTOMATIC TRANSMISSION ONLY -pin red 4-pin black Connect StartFone to PC by USB cable, start StartUP program and set up MB-RUN protocol via menu: Settings» Type of bus protocol» Bus protocol: MB-RUN If the SIM card had been installed earlier and StartFone is registered in the GSM net you can achieve the same result by direct SMS command like: PASS*974*3# (where PASS is the access code equals to 134 by default). One must install climate SMARTKEY REMOTE START function to OFF position (Programming» SmartKey» OFF). It this case the running time is defined by StartFone only. 5

6 TEC CANTEC-XL CONNECTION FUSE 5A + 1 V Ground Cut off connectors and splice wires in accordance with the following: Red - Red Black - Black Blue - Green White - Blue Connect StartFone to PC by USB cable, start StartUP program and set up XL / SIGMA protocol via menu: Settings» Type of bus protocol» Bus protocol: XL / SIGMA If the SIM card had been installed earlier and StartFone is registered in the GSM net you can achieve the same result by direct SMS command like: PASS*974*# (where PASS is the access code equals to 134 by default). Functionality of CANTEC-XL module is defined by it s original firmware.. 6

7 StarLine Sigma 10/15 CONNECTION FUSE 5A + 1 V Ground Cut off connectors and splice wires in accordance with the following: Red - Red Black - Black Blue - Green White - Blue Connect StartFone to PC by USB cable, start StartUP program and set up XL / SIGMA protocol via menu: Settings» Type of bus protocol» Bus protocol: XL / SIGMA If the SIM card had been installed earlier and StartFone is registered in the GSM net you can achieve the same result by direct SMS command like: PASS*974*# (where PASS is the access code equals to 134 by default). Functionality of SIGMA 10 & SIGMA 15 modules is defined by it s original firmware. 7

8 NOTES STARTFONE.SU TECHNICAL SUPPORT: +7(800) Rev