Telematic Gateway TGW2.1 3G+WIFI W Hardware User Manual

Transcription

1 Telematic Gateway TGW2.1 3G+WIFI W Hardware User Manual

2 CONTENTS 1. INTRODUCTION Scope Audience PRODUCT DESCRIPTION AND SAFETY Electrical connectors Pinning Description Telematic gateway-description Product specification Product installation ABBREVIATION

3 1. INTRODUCTION 1.1. Scope This manual ensures you to familiarise the hardware features and functions of Telematic Gateway TGW2.1 3G+WIFI W, assisting you in the safe or accurate operation in the vehicle Audience This manual is intended to owners or drivers without professional or specialised knowledge on Telematic Gateway TGW2.1 3G+WIFI W. Note: Antenna is not commercialized with TGW2.1 but is necessary for the good working of it. Antennas noticed in this document are subject to changes.

4 2. PRODUCT DESCRIPTION AND SAFETY 2.1 Electrical connectors Picture not contractual SIM- card An externally accessible SIM card drawer is meant for SIM card interface. WLAN Antenna The cable from roof mounted WLAN antenna is connected to this port to ensure WLAN connectivity. Main GSM antenna The cable from roof mounted GSM antenna is connected to this port to ensure GSM connectivity. Backup GSM Antenna This is a back-up to main GSM antenna. GPS Antenna The cable from roof mounted GPS antenna is connected to this port to ensure GPS connectivity. USB The driver identification cable is connected to this port. The other end of the cable is located on the dashboard switch panel and will allow the driver to connect a pen drive with his identification credentials. Ethernet The Ethernet port is connected to Telematics Extended Service Platform (TESP) Main Connector The main 40 pinned connector, facilitates the electrical and communication essentials of Telematic Gateway TGW2.1 3G+WIFI W, with Vehicle electrical system.

5 2. PRODUCT DESCRIPTION AND SAFETY Main connector Pinning Description Pin Signal Name Description Power supply (+30 / Ubat) 2 DR Key input 3 D_IN1 Digital input (Spare) 4 D_IN2 Vehicle CAN2 H ( Duplicate pin ) 5 J1708B Vehicle connection & diag 6 J1708A Vehicle connection & diag 7 ASSISTANCE_BUTTON_STS Emergency assistance call feedback to driver 8 RI_GSM Full RS232 interface 9 DSR_GSM Full RS232 interface 10 DCD_GSM Full RS232 interface 11 DTR_GSM Full RS232 interface 12 CTRL_UBAT_V Full RS232 interface 13 Vehicle CAN1 H CANH (Vehicle connection & diag) 14 Vehicle CAN1 L CANL (Vehicle connection & diag) 15 Vehicle CAN2_H CANH (Functional CAN) 16 Vehicle CAN2_L CANL (Functional CAN) 17 GND 3 wires RS232 interface 18 RXD_2 3 wires RS232 interface 19 Audio line out_n 20 Audio line out_p Audio line output-differential N GSM voice out Audio line output- differential P GSM voice out 21 D_IN_CHARGER Vehicle CAN2 L ( Duplicate pin ) 22 D_IN3 Vehicle CAN2 H Strap 23 D_IN_BAT_STAT Vehicle CAN2 L Strap 24 R Key input 25 ASSISTANCE_BUTTON Emergency assistance call 26 D_OUT1 Digital output (Spare) 27 INFO_IF Driver activity 28 CTS_GSM Full RS232 interface 29 RXD_GSM Full RS232 interface 30 RTS_GSM Full RS232 interface 31 TXD_GSM Full RS232 interface 32 GND Full RS232 interface 33 Vehicle CAN1 H Strap Vehicle connection & diag 34 Vehicle CAN1 L Strap Vehicle connection & diag 35 GND System Gnd / Power Gnd 36 Vehicle CAN1 H Vehicle connection & diag 37 Vehicle CAN1 L Vehicle connection & diag 38 TXD_2 3 wires RS232 interface 39 Microphone GND ecall using GSM 40 Microphone ecall using GSM in

6 2.PRODUCT DESCRIPTION 2.2 Description Telematic Gateway TGW2.1 3G+WIFI W is an on-board un it used for data logging and communication between the vehicle and truck server. The telematics gateway will transfer the information to support the vehicle related s ervic es. To enable the communication to the truck server Telematic Gateway TGW2.1 3G+WIFI W services must be activated. AND SAFETY GSM-Communication: Telematic Gateway TGW2.1 3G+ WIFI W has a n integrated GSM module for the data c om m unic atio n t o and from the vehicle. The Telematic Gateway TGW2.1 3G+WIFI has a slot for a SIM-card. The GSM antenna is placed on the truck roof (combined GSM/GPS/WLAN-antenna). NOTE Do not place any metal objects over the antenna on the roof. Picture not contractual Picture not contractual NOTE Do not place any other transmitting antennas closer than 30 cm from the GPS/GSM/ WLAN antenna. Telematic Gateway 3G+WIFI Wcan determine geographic vehicle position through GPS -positioning. The GPS unit calculates the position with the help of signals from at least three satellites. The system consists of: GPS Satellite positioning The accuracy of calculation 1. SIM card 1. Antenna increases as the number of satellites 2 Telematic gateway TGW2.1 3G+WIFI W 2. Satellite the GPS unit is in contact with the 3 Antennas (GPS, GSM, WLAN) & 6. GPS, GSM & WLAN connectors vehicle s system. 5. Telematic Gateway TGW2.1 3G+WIFI W

7 2. PRODUCT DESCRIPTION AND SAFETY WLAN-Communication: Telematic Gateway TGW2.1 3G+WIFI W has an integrated WLAN module for the data c om m unic atio n to and f rom the vehicle for remote warehouse applications. The WLAN antenna is placed on the truck roof (combined GSM/GPS/WLAN-antenna). 2.3 Product specification Product Features GSM: 3G World variant: Quad-Band GSM/GPRS/EDGE: 850 / 900 / 1800 / 1900 MHz Tri-Band UMTS/ HSPA+, (WCDMA/FDD): 800/850, 900 and 2100 MHz Output power: Class 4 (2W) for GSM850 / 900 Class 1 (1W) for GSM1800 / 1900 Class 3 for UMTS 800/850/900/2100 and WCDMA FDD bands I /III / V / VI Operating frequency 3G US variant: Quad-Band GSM/GPRS/EDGE: 850 / 900 / 1800 / 1900 MHz Dual-Band UMTS/ HSPA+, (WCDMA/FDD): 850 and 1900 MHz Output power: Class 4 (2W) for GSM850 / 900 Class 1 (1W) for GSM1800 / 1900 Class 3 for UMTS 850 /1900 and WCDMA FDD bands II / V GNSS: GPS L1 Band GLONASS f 1576,443 MHz WLAN: 2400 f 2485 MHz Physical Characteristics Dimensions 179 x 162.2x 33 mm Mounting Three Ø6.5 mm holes. Mounting position will vary with respect to the truck model. Weight Environmental Parameters Operating Temperature Storage Temperature Operating Voltage 750 grams -40 C to +75 C -40 C to +85 C 10V to 36V 2.4 Product installation No fuse is enclosed in the product. Thus an external 3A protective fuse shall be installed outside of the unit, between the truck battery and the unit, on the power supply lines. The equipment is intended to be installed in restricted access locations, with at least 20cm or more away from person s body. For ADR vehicles: Power supply lines shall not bypass the ADR battery master switch.

8 3. ABBREVIATIONS ADR BAT CAN CTRL CTS DCD DR DSR GND GPS GSM R RI SIM WLAN Accord européen relatif au transport international des marchandises Dangereuses par Route ( Dangerous goods transportation European regulation ) Battery Controller Area Network Control Clear to Send Data Carrier Detect Drive Data Set Ready Ground Global Positioning System Global System for Mobile Communications Radio Ring Indicator Subscriber Identity Module Wireless Local Area Network