Chapter 2 Review Questions

Similar documents
Subnetting Questions:

Chapter 9: Subnetting IP Networks

Packet Tracer - Subnet Scenario 2 Topology

IP Addressing - Subnetting

Chapter 8: Subnetting IP Networks CCENT Routing and Switching Introduction to Networks v6.0

Packet Tracer - Subnet Scenario 2 (Instructor Version)

Al-Mustansiriyah University Fourth Year ( )

Lab Subnetting Network Topologies (Instructor Version)

IP Addressing and Subnetting

The identifier used in the IP layer of the TCP/IP protocol suite to identify each device connected to the Internet is called the Internet address or

McGraw-Hill The McGraw-Hill Companies, Inc., 2000

IP subnetting exercise. By Reem Al-Kanhal

Chapter 8: Subnetting IP networks. Introduction to Networks v5.1

12. Sub- & Supernetting

CCNA Exploration Network Fundamentals. Chapter 10 Planning and Cabling Networks

Activity 6.4.1: Basic VLSM Calculation and Addressing Design

Linux System Administration

Tutorial 9. SOLUTION Since the number of supported interfaces is different for each subnet, this is a Variable- Length Subnet Masking (VLSM) problem.

CCNA 1 Chapter 9 v5.0 Exam Answers 2013

CENG393 Computer Networks Labwork 2

Subnetting And Supernetting

Figure 11 Two-level addressing in classful addressing

Chapter 6. Variable Length Subnet Masking (VLSM) Classless Inter-Domain Routing (CIDR) CCNA2-1 Chapter 6

COSC 6377 Mid-Term #2 Fall 2000

Table of Contents Chapter 1 IP Addressing Configuration

Creating a network Bridge

Lab 1.3.2: Review of Concepts from Exploration 1 - Challenge

Chapter 8: Subnetting IP Networks

1. What type of network cable is used between a terminal and a console port? cross-over straight-through rollover patch cable 2.

Why we need to divide network?

Cisco CCNA Basic IP Routing Part I

Subnetting/Supernetting and Classless Addressing

IP Addresses McGraw-Hill The McGraw-Hill Companies, Inc., 2000

The following steps should be used when configuring a VLAN on the EdgeXOS platform:

Configuring PPP over Ethernet with NAT

Lab : Challenge OSPF Configuration Lab. Topology Diagram. Addressing Table. Default Gateway. Device Interface IP Address Subnet Mask

Address Class (Exercise) B A

Copyright 2011 Sakun Sharma

Troubleshooting LAN Switching Environments

Lab 2.8.2: Challenge Static Route Configuration

Lab 9.6.2: Challenge EIGRP Configuration Lab

Chapter 8 ARP(Address Resolution Protocol) Kyung Hee University

Computer Network Addressing. The TCP/IP Layers and Addresses. Topics. The Internet Communication. The TCP/IP Layers and Addresses IP Address

CCNA Access List Questions

Lab 8 (IP Addressing)

Lab - Designing and Implementing a Subnetted IPv4 Addressing Scheme

Lab 5.6.2: Challenge RIP Configuration

Computer Networks Lecture -5- IPv4 Addresses. Dr. Abbas Abdulazeez

Chapter 4: VLSM and Classless Inter Domain Routing. ITE PC v4.0 Chapter Cisco Systems, Inc. All rights reserved.

NETWORK LAB 2 Configuring Switch Desktop

A specific IP with specific Ports and Protocols uses a dedicated WAN (Load Balance Policy).

Apple computers tend to have the WOL settings in the BIOS already enabled by default.

Layer 2 Engineering VLANs

VLANs Level 3 Unit 9 Computer Networks

Troubleshooting Can not access the router on

This document is exclusive property of Cisco Systems, Inc. Permission is granted to print and copy this document for non-commercial distribution and

QNAP Q center Assistant Monitor Your QNAP NAS behind a NAT Router with Q center

CC231 Introduction to Networks Dr. Ayman A. Abdel-Hamid. Internet Protocol Suite

April 24, Copyright 2010 by World Class CAD, LLC. All Rights Reserved.

Objectives. Note: An IP address is a 32-bit address. The IP addresses are unique. The address space of IPv4 is 2 32 or 4,294,967,296.

Quick Installation Guide of Acer WLAN 11b Broadband Router

This document is exclusive property of Cisco Systems, Inc. Permission is granted to print and copy this document for non-commercial distribution and

2 Preparation. 2.1 Items to Check Connecting PC with GP Setting PC Network Setting GP Network

Figure Untagged and 802.1Q-Tagged Ethernet frames

Antonio Cianfrani. Virtual LAN (VLAN)

Chapter 3 Review Questions

Configuring PPP over Ethernet with NAT

Remote Diagnostics with the ewon Cosy 131 Quick Start

IP Addressing and Subnetting NETWORK INFRASTRUCTURES NETKIT - LECTURE 2 MANUEL CAMPO, MARCO SPAZIANI

Configuring IPv4 Addresses

Network Layer/IP Protocols

Internetworking Basics

2 Preparation. 2.1 Items to Check Connecting PC with GP Setting PC Network Setting GP Network...

Lecture 8 Network Layer: Logical addressing

End-to-End Communication

Networking: Network Layer

All configuration in this document refers to the EZ Setup section.

Practice for Chapter 15: Analyzing Existing Subnet Masks

IP addresses and Subnetting

King Fahd University of Petroleum & Minerals Electrical Engineering Department EE 400, Experiment # 2

Setting up VPN connection: DI-804HV to DI-804V

Before installing this product, ensure that the following prerequisites are completed.

W7x Wireless Access Point Family

Configure a Site-to-Site Virtual Private Network (VPN) Connection on an RV340 or RV345 Router

VLSM Static routing. Computer networks. Seminar 5

CCNA Exploration Network Fundamentals. Chapter 06 Addressing the Network IPv4

Subnetting/Supernetting and Classless Addressing

Chapter 3 LAN Configuration

Before installing this product, ensure that the following prerequisites are completed.

KX-HTS SIP trunk setting template with Internet Telephony Service Provider

06/02/ Local & Metropolitan Area Networks 0. INTRODUCTION. 1. History and Future of TCP/IP ACOE322

Industrial Networking

Learn How to Configure EnGenius Wi-Fi Products for Popular Applications

Subnetting Questions with Detailed Answers: Subnetting Questions with Detailed Answers:

Next Generation Control - Wireless Network

Static NAT Mapping with HSRP

Dual-Band Wireless A + G Access Point. Network Layout

MAC Address Filtering Setup (3G18Wn)

TCP /IP Fundamentals Mr. Cantu

Configuring Tunneling on the RV130W

Transcription:

Chapter 2 Review Questions The following questions are designed to test your understanding of this chapter s material. For more information on how to get additional questions, please see www.lammle.com/ccn a. You can find the answers to these questions in Appendix B, Answers to Review Questions. 1. What is the maximum number of IP addresses that can be assigned to hosts on a local subnet that uses the 255.255.255.224 subnet mask? A. 14 B. 15 C. 16 D. 30 E. 31 F. 62 2. You have a network that needs 29 subnets while maximizing the number of host addresses available on each subnet. How many bits must you borrow from the host field to provide the correct subnet mask? A. 2 B. 3 C. 4 D. 5 E. 6 F. 7 3. What is the subnetwork address for a host with the IP address 200.10.5.68/28? A. 200.10.5.56 B. 200.10.5.32 C. 200.10.5.64 D. 200.10.5.0 4. The network address of 172.16.0.0/19 provides how many subnets and hosts? A. 7 subnets, 30 hosts each B. 7 subnets, 2,046 hosts each C. 7 subnets, 8,190 hosts each D. 8 subnets, 30 hosts each E. 8 subnets, 2,046 hosts each F. 8 subnets, 8,190 hosts each

5. Which two statements describe the IP address 10.16.3.65/23? (Choose two.) A. The subnet address is 10.16.3.0 255.255.254.0. B. The lowest host address in the subnet is 10.16.2.1 255.255.254.0. C. The last valid host address in the subnet is 10.16.2.254 255.255.254.0. D. The broadcast address of the subnet is 10.16.3.255 255.255.254.0. E. The network is not subnetted. 6. If a host on a network has the address 172.16.45.14/30, what is the subnetwork this host belongs to? A. 172.16.45.0 B. 172.16.45.4 C. 172.16.45.8 D. 172.16.45.12 E. 172.16.45.16 7. Which mask should you use on point-to-point links in order to reduce the waste of IP addresses? A. /27 B. /28 C. /29 D. /30 E. /31 8. What is the subnetwork number of a host with an IP address of 172.16.66.0/21? A. 172.16.36.0 B. 172.16.48.0 C. 172.16.64.0 D. 172.16.0.0 9. You have an interface on a router with the IP address of 192.168.192.10/29. Including the router interface, how many hosts can have IP addresses on the LAN attached to the router interface? A. 6 B. 8 C. 30 D. 62 E. 126

10. You need to configure a server that is on the subnet 192.168.19.24/29. The router has the first available host address. Which of the following should you assign to the server? A. 192.168.19.0 255.255.255.0 B. 192.168.19.33 255.255.255.240 C. 192.168.19.26 255.255.255.248 D. 192.168.19.31 255.255.255.248 E. 192.168.19.34 255.255.255.240 11. You have an interface on a router with the IP address of 192.168.192.10/29. What is the broadcast address the hosts will use on this LAN? A. 192.168.192.15 B. 192.168.192.31 C. 192.168.192.63 D. 192.168.192.127 E. 192.168.192.255 12. You need to subnet a network that has 5 subnets, each with at least 16 hosts. Which classful subnet mask would you use? A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248 13. You configure a router interface with the IP address 192.168.10.62 255.255.255.192 and receive the following error: Bad mask /26 for address 192.168.10.62 A. Why did you receive this error? A. You typed this mask on a WAN link and that is not allowed. B. This is not a valid host and subnet mask combination. C. ip subnet-zero is not enabled on the router. D. The router does not support IP. 14. If an Ethernet port on a router were assigned an IP address of 172.16.112.1/25, what would be the valid subnet address of this interface? A. 172.16.112.0 B. 172.16.0.0 C. 172.16.96.0 D. 172.16.255.0 E. 172.16.128.0

15. Using the following illustration, what would be the IP address of E0 if you were using the eighth subnet? The network ID is 192.168.10.0/28 and you need to use the last available IP address in the range. The zero subnet should not be considered valid for this question. A. 192.168.10.142 B. 192.168.10.66 C. 192.168.100.254 D. 192.168.10.143 E. 192.168.10.126 16. Using the illustration from the previous question, what would be the IP address of S0 if you were using the first subnet? The network ID is 192.168.10.0/28 and you need to use the last available IP address in the range. Again, the zero subnet should not be considered valid for this question. A. 192.168.10.24 B. 192.168.10.62 C. 192.168.10.30 D. 192.168.10.127 17. You have a network in your data center that needs 310 hosts. Which mask should you use so you waste the least amount of addresses? A. 255.255.255.0 B. 255.255.254.0 C. 255.255.252.0 D. 255.255.248.0 18. You have a network with a host address of 172.16.17.0/22. From the following options, which is another valid host address in the same subnet? A. 172.16.17.1 255.255.255.252 B. 172.16.0.1 255.255.240.0 C. 172.16.20.1 255.255.254.0 D. 172.16.16.1 255.255.255.240 E. 172.16.18.255 255.255.252.0 F. 172.16.0.1 255.255.255.0

19. Your router has the following IP address on Ethernet0: 172.16.2.1/23. Which of the following can be valid host IDs on the LAN interface attached to the router? (Choose two.) A. 172.16.0.5 B. 172.16.1.100 C. 172.16.1.198 D. 172.16.2.255 E. 172.16.3.0 F. 172.16.3.255 20. Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct network address? A. 172.16.16.0 B. 172.16.0.0 C. 172.16.24.0 D. 172.16.28.0