Features Mechanical Data TERMINALS : Solder plated, solderable per MIL-STD-7, method 6 POLARITY : Color band denotes positive end (cathode) omponents 76 Marilla Street Chatsworth!"# $%!"# Lead Free Finish/Rohs Compliant (Note) ("P"Suffix designates Compliant. See ordering information) Glass Passivated Junction Excellent Clamping Capability Built-in Strain Relief Low Inductance Halogen free available upon request by adding suffix "-HF" Epoxy meets UL 94 V- flammability rating Moisture Sensitivity Level SMAEZ.D THRU SMAEZ7D W Glass Passivated Junction Silicon Zener Diode.-7 Volts DO-4AC (SMA) (LEAD FRAME) H J Maximum Ratings @ o C Unless Otherwise Specified Steady Power Dissipation (Note ) PD Watts o o Derate above 7 C 6 mw/ C Peak Forward Surge Current 8.ms single half sine-wave superimposed on rated load (JEDEC Method) (Note ) IFSM Amps Operating And Storage Temperature Range T J,T STG - o C to + o C NOTES:. High Temperature Solder Exemptions Applied, see EU Directive Annex 7.. Mounted on.mm (.mm thick) land areas.. Measured on 8.ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum. F G E INCHES MM DIM MIN MAX MIN MAX NOTE A.79.96..44 B..64.7.6 C..8.. D ---. ---. E..6.76. F.6.9.6. G.89. 4.8.9 H.7.8 4. 4.6 J.9...9 SUGGESTED SOLDER PAD LAYOUT.9.8 A DIMENSIONS D B C.7" Revision: D 4// of
SMAEZ.D THRU SMAEZ7D ELECTRICAL CHARACTERISTICS(T A= O C unless otherwise noted)v F=.V max,i F=mA for all types. Type No. (Note.) Nominal Zener Test Maximum Zener Impedance (Note ) Leakage Current Voltage Vz @ I ZT Current Volts I Z ZT @ I ZT Z ZK @ I ZK I ZK I R V R ZT ma Ohms Ohms ma µa Max Volts (Note.) Maximum Zener Current Surge Current @TA= I ZM I ZSM-A ma (Note 4.) SMAEZ.D. 98.. 6 6. E./CV E.6/CV6 SMAEZ.6D.6 89.. 4. SMAEZ6.D 6. 8. 7 9. SMAEZ6.8D 6.8 7. 7 4 66.9 SMAEZ7.D 7. 66. 7 4.66 SMAEZ8.D 8. 6. 7 6.44 SMAEZ9.D 9.. 7 7. SMAEZD. 7. 7.6 8. SMAEZD 4. 4 7. 8.4 66.8 SMAEZD 4. 4. 7. 9..66 SMAEZD 8. 7. 9.9 8.4 SMAEZ4D 4.7. 7..6.4 SMAEZD.4 7 7..4. SMAEZ6D 6. 8 7.. 4. SMAEZ7D 7 9.4 9 7. 7.8 SMAEZ8D 8 7.8 7..7. SMAEZ9D 9 6. 7. 4.4 9. SMAEZD 7.. 9 SMAEZD.8 7. 6.7 8.9 SMAEZ4D 4.8 7. 8. 76.8 SMAEZ7D 7 8. 8 7..6 68.74 SMAEZD 6.6.. 6.67 SMAEZD....6 SMAEZ6D 6.9. 7.4 6 SMAEZ9D 9.8. 9.7 47 SMAEZ4D 4.6..7 4.4 SMAEZ47D 47.6 4..8 9.4 SMAEZD 9.8 48. 8.8 6.9 SMAEZ6D 6 9. 4.6.6 SMAEZ6D 6 8. 6. 47. 9. SMAEZ68D 68 7.4 7..7 7.9 SMAEZ7D 7 6.7 9. 6 4.7 Device Marking E6./C6V E6.8/C6V8 E7./C7V E8./C8V E9./C9V E/C E/C E/C E/C E4/C4 E/C E6/C6 E7/C7 E8/C8 E9/C9 E/C E/C E4/C4 E7/C7 E/C E/C E6/C6 E9/C9 E4/C4 E47/C47 E/C E6/C6 E6/C6 E68/C68 E7/C7 Notes:. TOLERANCES - Suffix indicates % tolerance any other tolerance will be considered as a special device.. ZENER VOLTAGE (Vz) MEASUREMENT - guarantees the zener voltage when measured at 4 ms from the diode body, and an ambient temperature of centigrade degrees..zener IMPEDANCE (Zz) DERIVATION - The zener impedance is derived from the 6 cycle ac voltage, which results when an ac current having an rms falue equal to % of the dc zener current (I ZT superimposed on I ZT or I ZK. or I ZK )is 4. SURGE CURRENT (Izsm) NON-REPETITIVE - The rating listed in the electrical characteristics table is maximum peak, non-repetitive, reverse surge current of / square wave or equivalent sine wave pulse of / second duration superimposed on the test current, IZT, per JEDEC standards, however, actual device capability is as described in Figure. Revision: D of 4//
RATING AND CHARACTERISTICS CURVES SMAEZ. D THRU SMAEZ7D MCC PD, MAXIMUM DISSIPATION (WATTS).... 7 7 TL, LEAD TEMPERATURE ( C) Fig. -POWER TEMPERATURE DERATING CURVE PPK, PEAK SURGE POWER(WATTS) RECTANGULAR NONREPETITIVE WAVEFORM TJ = PRIOR TO INITIAL PULSE... IR, REVERSE LEADAGE(μAdc) @VR AS SPECIFIED IN ELEC. CHAR. TABLE............ K P.W. PULSE WIDTH (ms) NOMINAL VZ (VOLTS) Fig. -MAXIMUM SURGE POWER Fig. -TYPICAL REVERSE LEAKAGE 8 VZ, TEMPERATURE COEFFICIENT(mV/) @ IZT 6 4 RANGE - -4 4 6 8 VZ, ZENER VOLTAGE @IZT (VOLTS) VZ, TEMPERATURE C OEFFICIENT(mV) @ IZT 4 RANGE 4 6 8 4 6 8 VZ, ZENER VOLTAGE @IZT (VOLTS) Fig. 4-UNITS.9 TO VOLTS Fig. -UNITS TO VOLTS Revision: D 4// of
RATING AND CHARACTERISTICS CURVES SMAEZ. D THRU SMAEZ7D MCC.... 4 6 7 8 9 4 6 7 8 9 Fig. 6-VZ =.9 THRU VOLTS Fig. 7-VZ = THRU 8 VOLTS.. 4 6 8 JL, JUNCTION-LEAD THERMAL RESISTANCE (/W) 8 7 6 4 PRIMARY PATH OF CONDUCTION IS THROUGH THE CATHODE LEAD /8 /4 /8 / /8 /4 7/8 L, LEAD LENGTH TO HEAT SINK (INCH) Fig. 8-VZ = THRU VOLTS Fig. 9-TYPICAL THERMAL RESISTANCE Revision: D 4// 4 of
Ordering Information : Device Part Number-TP Packing Tape&Reel: 7.Kpcs/Reel Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF ***IMPORTANT NOTICE*** Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications, enhancements, improvements, or other changes. Corp. does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights,nor the rights of others. The user of products in such applications shall assume all risks of such use and will agree to hold Corp. and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. of Revision: D 4//