DX7 Special Edition ROM Install Guide

Transcription

1 DX7 Special Edition ROM Install Guide Table of Contents Required Tools/ Getting Started... p. 2 Installation... p.3-7 Opening the DX7... p. 3 Locating the Original ROM... p. 4 Removing the Original ROM... p. 5 Installing the Special Edition ROM...p. 6 Finishing with LCD Message... p. 7 Read the entire document before beginning the installation process. Take your time, take notes, and take photos whenever the need arises. Be sure to unplug the machine before working on the inside, the voltages inside have the potential to be very dangerous! Continue at your own risk! The author of this document cannot be held responsible for any damages caused by the information contained within this document. 1

2 Required Tools Phillips Head Screwdriver Flat Head Screwdriver Fig. 1 - Required Tools Before getting Started Be sure to back up any data from your DX7 Read up on electrostatic precautions before proceeding You may even want to consider wearing an antistatic wrist strap I will continue to repeat this, power off and unplug the DX7 before starting *I personally did not choose to wear an antistatic wrist band during the installation. 2

3 Fig. 2 - Opening the DX7 Step 1: You will need to remove 5 screws in order to open the DX7. Four screws are located on the top face of the DX7 circled in red in the photo above and one is located on the back beside the power switch. Remove these screws using a phillips head screwdriver. ****************************************************************** Be sure to unplug the machine before working on the inside, the voltages inside have the potential to be very dangerous! ****************************************************************** Once all 5 screws have been removed lift upward on the hinged DX7 face to open it. 3

4 Step 2: Fig. 3 - IC14 and IC15 location Now that the DX7 is opened, locate IC14 and IC15. They are very close to the internal battery and are marked in the photo above with a red box around them. Also on the circuit board they are marked with IC14 and IC15 in white silkscreen. One side of IC14 has a notch in it as shown in the photo above. Make note of the orientation of the notch on IC14 as you will need to install the Special Edition ROM with the same orientation. *This guide does not cover older models which have both IC14 and IC15 chips installed; it only covers models which only have IC14 installed as shown above in the photo. If you have one of the older model DX7s refer to the original Yamaha Special Edition ROM guide which can be found using the link below glitchscience.com/guides/dx7/yamaha_ser7_rom.pdf 4

5 Fig. 4 - Prying up the Original ROM Step 3: Time to remove the original ROM chip IC14 from its socket. Using a flat head screwdriver, gently pry up slightly on one side, then pry up the other side of IC14 ROM chip. Continue to pry up on one side, then the other side, until you are able to remove IC14 from its socket. It is a good idea to take your time and gently pry in order not to bend any of the pins on the original IC14 ROM chip. Set the original chip aside. 5

6 Fig. 5 - Special Edition ROM installed into IC14 socket Step 4: Now install the Special Edition ROM into the IC14 socket making sure that the orientation matches that of the original with the notch on the correct side as shown in the photo above. 6

7 Fig. 6 - The LCD message when powered up Step 5: After installing the Special Edition ROM close the DX7, plug it in, and power it up. The LCD upon starting should show the message "WELCOME TO DX7 SPECIAL EDITION" as shown in the photo above. Install the screws back in place. The installation is now completed. 7

8 This guide is not to be distributed or redistributed without explicit permission from the owner of the document. contact: glitchscience[at]gmail[dot]com with inquiries 8