1 Camera (for BVD-403CPL only) 3 Microphone. 4 CALL button 5 Illuminated ring 6 Speaker

Size: px

Start display at page:

Download "1 Camera (for BVD-403CPL only) 3 Microphone. 4 CALL button 5 Illuminated ring 6 Speaker"

Vivien Nicholson
5 years ago
Views:

1 VD-0, VD-0PL OPERTING INSTRUTION Doorstation VD-0х is intended for operation within VIZIT doorphones / video doorphones (Series omfort). The following models are available: - VD-0А -doorstation to connect apartment handset UKP - VD-0СPL -video doorstation with colour camera to connect video monitor bbreviations used in the model names: - No camera С - olour camera P - Pinhole lens L - Illumination for camera amera (for VD-0PL only) 6 IR LEDs ( illumination for camera in VD-0PL) Microphone LL button Illuminated ring 6 Speaker Figure - Doorstation VD-0x FETURES Illuminated LL button eep in the doorstation and monitor / apartment handset when the LL button is pressed Duplex intercom Door zone video monitoring ( VD-0СPL) Remote door unlocking by pressing the button on the monitor / apartment handset during intercom eeps to indicate door lock release IR illumination for the camera ( VD-0СPL) Subscriber devices are VIZIT trademarked products: - apartment handsets UKP - video monitors VIZIT-М of Series 00 SFETY INSTRUTIONS The product does not contain voltage above V. Do not make any connections or repair, when the power is on. Take care not to spill any liquids or chemically active substances on the product. Switch the power off before cleaning the product. lean by wiping with dry soft cloth. Do not use any liquid cleaners, aerosol cleaners or abrasive agents. www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) / 9

2 PRTS LIST x x x VD-0х Skew ase Operating Instruction Fasteners for doorstation VD-0х and skew base x x x x Screw Мх6 Gag Screw - х0 nchor 6x0 INSTLLTION ORDER For qualified installation, wiring and servicing refer to technical and commercial partners of VIZIT TM. The list of companies is given on VIZIT.EU ( The doorstation is mounted on a wall near your entrance door. The skew base provides 0 turn, and allows either leftside or right-side mounting. To protect the doorstation against the sun, rain or snow, installation of specially designed Mounting Kit MK-0 is recommended. Installation order of the doorstation together with its sun/rain shield is described in the Mounting Kit MK-0 installation manual. 7 6 Doorstation Skew base Screw Мх 6 ( х) 6 7 Hole ( х) 6 mm in diameter 0 mm deep nchor ( х) Screw - х 0 ( х) Gag ( х) Fasteners are supplied. Figure - Doorstaton wall-mounting on the left from the entrance door www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) / 9

3 Mounting on the right from the entrance door is performed in the same manner. Figure - Doorstation wall-mounting on the right from the entrance door +Е Ev/VO L INE +Е VO Ev Еc - Intercom line - Ground - - Video out ( for VD-0 Supply voltage for Doorstation PL) - Supply Voltage for outdoor camera (for VD-0А) - Supply voltage for built-in camera - Lock control. Figure - Terminals layout and marking www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) / 9

4 Locate the doorstation so as to avoid: - direct rays of the sun or other sources of light; - direct hit of rain or snow. 0 cm 0 cm 0 cm 0 cm 0 cm 80 cm 80 cm Figure - Recommended doorstation position and camera field of view Wiring diagrams for doorphone / video doorphone are shown in the section EXMPLES OF WIRING DIGRMS. Use copper wires for connections in accordance with the recommended lengths and cross-sections given in the section EXMPLES OF WIRING DIGRMS. To reduce possibility of external noises influencing image, use 7-Ohm coaxial cable for video circuits. www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) / 9

5 EXMPLES OF WIRING DIGRMS Doorstation VD-0 Ev/VO UKP-(M) + - Electromechanical lock / strike V / 0.6 max. N007 D Power Supply Unit PD8/ Note. If an electromechanical lock / strike has no built-in damper diode, the diode shall be set additionally between terminals of the lock /strike as shown in the diagram. Wire +D Length, m ross-section, mm Figure 6 - Doorstation VD-0 with partment Handset UKP-( М), Power Supply Unit PD8/-- and electromechanical lock /strike www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) / 9

6 Outdoor camera V / 0. А max. VO VG * - video monitors that may be used in this diagram: VIZIT-M0, VIZIT-M0M, VIZIT-MM, VIZIT-M6, VIZIT-M6M, VIZIT-M7M. Doorstation VD-0 Ev/VO LN+ LN- VI DT VI Monitor VIZIT* Electromechanical lock / strike V / 0.6 max. N007 D Note. If an electromechanical lock / strike has no built-in damper diode, the diode shall be set additionally between terminals of the lock /strike as shown in the diagram. Wire + +D Length, m ross-section, mm Power Supply Unit PD8/ Figure 7 - Doorstation VD-0 with outdoor camera, Video Monitor VIZIT, Power Supply Unit PD8/-- and electromechanical lock /strike www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) 6 / 9

7 Doorstation VD-0PL Ev/VO * - video monitors that may be used in this diagram: VIZIT-M0, VIZIT-M0M, VIZIT-MM, VIZIT-M6, VIZIT-M6M, VIZIT-M7M. LN+ LN- VI DT VI Monitor VIZIT* Electromechanical lock / strike V / 0.6 max. D Power Supply Unit PD8/ Note. If an electromechanical lock / strike has no built-in damper diode, the diode shall be set additionally between terminals of the lock /strike as shown in the diagram. Wire + +D Length, m ross-section, mm Figure 8 - Doorstation VD-0PL with Video Monitor VIZIT, Power Supply Unit PD8/-- and electromechanical lock /strike www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) 7 / 9

8 Electromagnetic lock VIZIT-ML0-0 Red lack lue White Reader RD- ( RD-F) Green lue White lack Red utton EXIT 00M D ontrol Unit KТМ60М -DL +DL E IP RD OP E Doorstation VD-0PL LN+ Monitor LN- VIZIT* VI VO DT VI Wire + D Length, m ross-section, mm * - video monitors that may be used in this diagram: VIZIT-M0, VIZIT-M0M, VIZIT-MM, VIZIT-M6, VIZIT-M6M, VIZIT-M7M. Figure 9 - Doorstation VD-0PL with RF ontroller VIZIT-KTM60R ( VIZIT-KTM60F), Video Monitor VIZIT, Electromagnetic Lock VIZIT-ML0-0 and utton EXIT 00M www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) 8 / 9

9 FUNTIONL HEK ND OPERTING ORDER efore switching the power on, verify all electric connections. Turn the power supply unit on. To make a call to the subscriber, press the LL button on the doorstation. call sound is ringing both in the monitor (apartment handset) and doorstation, while the LL button remains pressed. Image appears on the monitor s screen. Pick up the handset and check duplex intercom. heck image on the monitor s screen. djust image brightness, contrast and saturation, if needed. Press the on the monitor (apartment handset) to release the door lock. The doorstation produces a beep, and the lock stays released while the button remains pressed. Release the button to return to the intercom mode. Hang up the handset. The system goes to the stand-by mode. Note. When called, the subscriber can press the button to release the door lock without picking up the handset. The system goes to the stand-by mode after the button is released. Intercom is available within (60 ± ) seconds after picking up the handset. If the handset is not picked up in 60 seconds, the system returns to the stand-by mode automatically. The subscriber can activate door zone video monitoring at any time. For details please refer to the operating instruction on your monitor. During video monitoring the subscriber can also activate duplex intercom by picking up the handset. The system will return to the stand-by mode with hanging up the handset, or automatically in 60 seconds. SPEIFITIONS Operating voltage: Power consumption: Dimensions (W)x(H)x(D): Weight: Weight with package: 6... VD W Max x x 0 mm 0. kg 0. kg The built-in camera parameters (VD-0PL) are given below: amera Parameters Lens ngle of view (diagonal) Scanning system olour system Resolution Minimal illumination Pinhole 90 СIR PL 700 TVL 0 Lux (IR LED ON, 0. m range) Day-Night feature YES Output voltage Vp-p at 7 Оhm OPERTING ONDITIONS mbient temperature range: - VD-0А - 0 to + - VD-0PL - 0 to + Relative humidity of air: up to 98% at www. vizit-group.com VD-0, VD-0PL Operating Instruction (revision 0-) 9 / 9

OPERATING INSTRUCTION. -video doorstation with colour camera to connect 1 video monitor. Figure 1 - Doorstation BVD-405x FEATURES

OPERATING INSTRUCTION. -video doorstation with colour camera to connect 1 video monitor. Figure 1 - Doorstation BVD-405x FEATURES VD-0-, VD-0P- OPERTING INSTRUTION Doorstation VD-0х is intended for operation within VIZIT doorphones / video doorphones (Series omfort). The following models are available: - VD-0А- - doorstation to connect