TDM over IP. International Department

Transcription

1 TDM over IP International Department

2 RAISECOM TDM over IP TDMoIP Specification 4 E1/T1 TDMoIP product 1 E1/T1 TDMoIP product How to config Nview NNM V5 GUI

3 TDMoIP product family Central RC1201-2GESTM1 RC1201-2FEV35 Remote RC1201-2FEE1T1 RC1201-4FE4E1T1 RC1201-GE16E1T1 1 E1T1 4 E1T1 16 E1T1 STM1/OC-3 E1T1 capacity

4 TDMoIP specification Support SAToP, CESoPSN, TDMoIP, and HDLC PSN type: MPLS, IP, and Ethernet Maximum bundle number: 64 E1/T1 clock mode: internal, loopback, adaptive, external, and common Compliant to G.823, G.824 Unbalanced/balanced E1, balanced T1 Configurable jitter buffer Compliant to G.8261, support 2% scrambling and packet loss Configurable Ethernet transmission unit

5 Ethernet specification Maximum transmission unit: 1632 bytes Rate limiting per port, 62k 1000M non-linear Broadcast, multicast and DLF storm control per port 4K active 802.1Q VLAN, double tagging (Q-in-Q) 802.3x and back pressure flow control 8K MAC address table entry, 30 static MAC addresses Configurable MAC address learning per port Configurable MAC aging time s QoS support, 4 output queues Port isolation BPDU, LACP and 802.1x transparent relay Ethernet port loopback detection

6 E1 specification Compliant to G.703, G.704, G.706, G.732 and G.823 Connector type: BNC for unbalanced, RJ45 for balanced Impedance: 75 Ohm unbalanced, 120 Ohm balanced Data rate: 2.048Mbps Line code: HDB3 Frame structure: unframed, framed, multiframe, with or without CRC4 Clock compliant to G.823 Jitter compliant to G.823 Electrical characteristic: G.703 Transform characteristic: G.823 Unbalanced/balanced auto sensing

7 T1 specification Compliant to ANSI T1.403, AT&T TR-62411, ITU-T G.703, G.704 and G.824 Connector type: RJ45 for balanced Impedance: 100 Ohm balanced Data rate: Mbps Line code: B8ZS, AMI, B7ZS Frame structure: unframed, SF, and ESF Clock compliant to G.824 Jitter compliant to AT&T TR-62411, G.824 Electrical characteristic: G.704 Transform characteristic: G.824

8 Basic clocking mode Internal timing mode Loopback timing mode

9 Basic clocking mode (cont.) Adaptive timing mode External timing mode

10 RC1201-4FE4E1T1 front panel SNMP port Console port Gigabit Ethernet interface Fast Ethernet interfaces Power supply module 1U 19 standalone in metal enclosure, single power supply, less than 13W Transmit 4 x E1/T1 services over PSN network (IP, MPLS, Ethernet) 4 x FE and 1 x GE (SFP) for local and line Ethernet connection CLI/SNMP management

11 RC1201-4FE4E1T1 rear panel Unbalanced BNC Balanced RJ45 4 x E1/T1 interfaces Expansion slot Unbalanced and balanced E1 interfaces Balanced T1 interfaces Expansion card for E1/T1 clock input/output

12 Expansion cards RC1201-SC-SYNC E1/T1/2MHz clock input/output, CC3 connector

13 RC1201-2FEE1T1/V35 front panel SNMP port Console port Gigabit Ethernet interface Fast Ethernet interfaces Power supply module 1U 19 standalone in metal enclosure, single power supply, less than 13W Transmit 1 x E1/T1 or V.35 services over PSN network (IP, MPLS, Ethernet) 2 x FE and 1 x GE (SFP) for local and line Ethernet connection CLI/SNMP management

14 RC1201-2FEE1T1 rear panel Unbalanced BNC Balanced RJ45 1 x E1/T1 interfaces Unbalanced and balanced E1 interfaces Balanced T1 interfaces V.35 interface 1 x V.35 interfaces

15 Application Point to muti-point transmission application based on Packet Switched Network

16 Application (cont.) Point to point transmission application based on Packet Switched Network Transmission based on Packet Switching Networks for voice and Ethernet multiplexer

17 Application (cont.) Serial data services moved to Packet Switched Networks

18 RAISECOM TDM over IP TDMoIP Specification 4 E1T1 TDMoIP product 1 E1T1 TDMoIP product How to config Nview NNM V5 GUI

19 Device basic configuration current running configuration of this nodes: snmp-server community public ro //SNMP MGT configuration snmp-server community private rw device description RC1201-4FE4E1T1-Raisecom^Technology^Co.,^Ltd. double-tagging tpid 9100 no use-core-tag trunk disable mac-address-table aging-time 0 mac-address-table learning disable qos qos queue fix-priority qos map cos-queue ip-address //IP address of the device device clock master osc device clock fallback osc!post-config commands: exit clock timezone + 8 0

20 E1/T1 interface configuration Interface ID: 1 Interface Descr: tdm port-1 //description PortSendcode: e1hdb3 //line code Interface type: balance //interface connector type Ds1 type: E1 //interface type <E1/T1> Loopback config: no Loopback Frame mode config: unframed //frame mode for E1/T1 CRC4 config: enable //E1 CRC4 status T1 Signaling mode config: none //T1 signaling DS0 idle code: 255 //TDM port unuse ds0 idle code Tx Clock Source Config: recovery clock //transmit clock source Clock Recover Bundle: 1 //bundle id used for adaptive clock LineStatus: LOS //link status

21 Bundle configuration Raisecom(config-bundle/0/1)# sho interface Bundle ID: 1 //bundle ID Bundle Descr: bundle-1 //description Bundle Connection Config: enable //connection status Destination Bundle ID: 1 //destination bundle ID Jitter Buffer: 8 //jitter buffer size Bundle Payload Type: SAToP //bundle payload type SAToP Frame Length: 32 //payload length in the frame TDM Port Index: 1 //E1/T1 port number Bundle PSN Type: UDP/IP //PSN type IP Version: IPV4 //IP version Destination IP Address: //destination IP address IP TOS: 0 //IP ToS IP TTL: 255 //IP time to live Next Hop Address Type: IP //next hop address type Next Hop Address: //next hop address Tag Vlan Mode: Untag //VLAN mode Bundle Status: Normal //current bundle status Bundle Statistic: //bundle statistics Bundle Transmit Packet: Bundle Receive Packet: Bundle Discard Packet: 0

22 Bundle info. Raisecom(config-bundle/0/1)# show bundle info Jitter Buffer Underflow:...(7) Jitter Buffer Overflow:...(0) Max jitter buffer level(ms):...(252.33) Min jitter buffer level(ms):...(0.00) Max jitter buffer deviation(ms):...(250.00) //statistics JB in last time quantum Packet per second:...(426) //Frame per second Required IP bandwidth(bps):...( ) //calculate IP BW of Bundle Required Ethernet bandwidth(bps):...( ) //calculate ETH BW of Bundle Packetization delay(ms):...(2.34) //packet creation time End to End delay(ms):...(253.34) //single trip delay

23 Ethernet interface configuration Interface ID :1 Descr :Slot 0 eth interface 1 Interface type :electrical Port enable(command) :enable Port enable status :enable AutoMdi config :enable AutoMdi status :enable Link status :cross Autonego config :enable Autonego status :enable Duplex config :full-duplex Duplex config status :half-duplex Duplex status :half-duplex Speed config status :10M Speed status :10M Flow control config:off Flow control status:off Link :linkdown RJ45 interface Interface ID :1 Descr :Slot 0 fx-ge interface 1 Interface type :optical Port enable(command) :enable Port enable status :enable Flow control config:off Flow control status:off Als config:enable SFP fiber interface

24 SNMP MGT configuration Interface:snmp Administration Status : up Operation Status : down //status Description: SNMP-MGT-Interface //description Internet address: Netmask: //IP address Ethernet address: 00:01:02:03:04:05 //MAC address Duplex:full-duplex Speed:100baseT Autonegotiation:enable

25 In-band MGT configuration interface vcc ip address //IP address of VCC vlan id 101 //VLAN ID of VCC

26 RAISECOM TDM over IP TDMoIP Specification 4 E1T1 TDMoIP product 1 E1T1 TDMoIP product How to config Nview NNM V5 GUI

27 Nview NNM V5 GUI Topology Management function of TMN

28 Nview NNM V5 GUI Initiated device management view

29 Nview NNM V5 GUI Equipment Snapshot

30 Nview NNM V5 GUI TDM interface configuration

31 Nview NNM V5 GUI FE port Configuration & SFP interface management

32 Nview NNM V5 GUI Alarm management

33