20-Key Aluminium RF Controller

Transcription

1 20-Key Aluminium RF Controller Item Model: H-RGBC-20RF This RGB RF (Radio Frequency) Controller and Remote is designed for controlling LED lighting products such as flexible strips, glass curtains, wall lights and wall washers and provides an easy to use solution for switching lights on or off and choosing lighting colours. Using the RGB Controller/Remote, you can wirelessly control the settings on your LED lights, choosing from one of 8 static colours or 6 dynamic modes. Because it uses Radio Frequency the controller does not require a direct line of sight in order to work which means the receiver can be discretely tucked away or concealed inside a cupboard without the degrading the signal. The unit is easy to install and comes in two parts: a receiver, which installs between the LED lights and the power supply, and a wireless remote, which can be used to set the colour, brightness and speed. Before installing this product, please read this manual carefully to ensure full understanding of the specification to avoid unnecessary damage.

2 Directions for use The supply voltage for this product is DC 12V-24V, never connect to a mains voltage. Always connect the load first then apply the power taking care not to short circuit. Lead wires should be connected according to the connection diagram. Do not overload the controller. Refer to technical specifications. Remove the isolation tab from the remote control battery. Features Mode select Brightness controls Technical Specifications Controller: Operating Temperature: -20 C +60 C Supply Voltage: DC 12V - 24V Output: 3 channels Connection Mode: Common Anode Static Power Consumption: <1W Output Current: 4A x 3Ch = 12A 4A per channel Output Power: 12V: <144W, 24V: <288W Controller Dimensions: L 130 x W 64 x H 24mm Size: L 137 x W 80 x H 54mm Net Weight: 180g Gross Weight: 210g Remote Control: Power Supply Mode:3 x AAA Batteries Remote Control Dimensions: L x W 55 x H 18mm

3 External dimensions: Controller Packaging Size

4 Interface Specifications: Standard DC Power Input Power input interface (port 2): Load output interface:

5 Remote Control Instructions: Brightness + Brightness - Pause On/Off Static Red Static Green Static Blue Static White Static White Static Yellow Static Cyan Static Purple Auto run Three base colour jump Three colour gradually change Speed + Flash Seven base colour jump Seven colour gradually change Speed -

6 Typical Applications Application Circuit 1: Application Circuit 2: DC+: For power input +(power supply voltage12v-24v) DC-: For power input - Notes: The load voltage, current and power must be consistent with the product. Please make the connection as per the diagram above ensure you connect the load wire before connecting the power. When in use avoid short circuits.

7 Common Problems Problems Possible cause Solution 1. Lamp does not light after applying power. Power cord is not properly connected or there is output from the power supply. Connect the power cord properly or re-apply the power. Lamp power cord is not connected or has short circuited. Connect lighting power cord. 2. After connecting the load the controller does not work. The connected load is too large. It has damaged some of the components in the controller. Replace components or replace the controller.