DS 201P. Electronic Pressure Switch. Pressure Port With Flush Welded Stainless Steel Diaphragm. accuracy according to IEC 60770: 0.

Transcription

1 Pressure Port With Flush Welded Stainless Steel Diaphragm accuracy according to IEC 600: 0. % FSO Nominal pressure from bar up to 00 bar Contacts, or independent PNP contacts, freely configurable Analogue output wire:... 0 ma wire: 0 ma / 0 0 V Special characteristics The electronic pressure switch is the successful combination of intelligent pressure switch digital display and is designed for universal applications in the mechanical engineering and other industries where a flush stainless steel diaphragm is necessary. This can be the case, for example, with higher viscous or slightly contaminated fluids. For usage with higher media temperature optionally a cooling element up to 00 C is available. Preferred areas of use are indication of measured values on a digit LED display rotatable and configurable display module Plant and Machine Engineering Food Industry versions ISversion Ex ia = intrinsically safe for gases cooling element up to 00 C specific versions Preferred used for Viscous and pasty media BD SENSORS GmbH BDSensorsStraße Telefon +9 (0) 9 / D 999 Thierstein Telefax +9 (0) 9 / 98 info@bdsensors.de

2 Input pressure ranges Nominal pressure gauge/abs. [bar] Overpressure [bar] Burst pressure [bar] Contact PNP contact Options independent PNP contacts independent PNP contacts (possible with Mx, 8pin for... 0 ma/wire; V/wire on request) Max. switching current... 0 ma / and wire: contact rating ma, shortcircuit resistant; V switch = V S V V / Leiter: contact rating ma, shortcircuit resistant Accuracy of contacts 0. % FSO Repeatability 0. % FSO Switching frequency max. 0 Hz Switching cycles > 00 x 0 6 Delay time sec max. contact for wire current signal with plug ISO 00 as well as wire current signal with Exprotection no contact possible with wire in combination with plug ISO 00 accuracy according to IEC 600 limit point adjustment (nonlinearity, hysteresis, repeatability) Analogue output (optionally) / Supply wire current signal... 0 ma / V S =... 6 V DC permissible load: R max = [(V S V Smin ) / 0.0 A] response time: < 0 msec wire current signal with... 0 ma / V S =... 8 V DC Exprotection permissible load: R max = [(V S V Smin ) / 0.0 A] response time: < 0 msec wire current signal... 0 ma / V S = V DC adjustable (turndown of span max. :) permissible load: R max = 00 response time: < 0. sec wire voltage signal V / V S =... 6 V DC permissible load: R min = 0 k response time: < 0 msec without analogue output V S =... 6 V DC accuracy 0. % FSO with turndown of span the analogue signal is adjusted automatically to the new measuring range Thermal error (offset and span) / Permissible temperatures Thermal error ± 0. % FSO / 0 K in compensated range C Permissible temperatures medium: 0... C for filling fluid silicone oil 0... C for filling fluid food compatible oil electronics / environment: C storage: C Permissible temperature filling fluid silicone oil overpressure: 0 00 C vacuum: C medium for cooling element 00 C filling fluid food compatible oil overpressure: C vacuum: C an optional cooling element can influence thermal effects for offset and span depending on installation position and filling conditions max. temperature of the medium for overpressure > 0 bar: 0 C for 60 minutes with a max. environmental temperature of 0 Electrical protection Shortcircuit protection permanent Reverse polarity protection no damage, but also no function Electromagnetic compatibility emission and immunity according to EN 66 Mechanical stability Vibration g RMS ( Hz) according to DIN EN Shock 00 g / msec according to DIN EN Filling fluids silicone oil food compatible oil with FDA approval (Mobil SHC Cibus ; Category Code: H; NSF Registration No.: 00) Materials Pressure port stainless steel. (6 L) Housing stainless steel.0 (6 L) Display housing PA 6.6, Polycarbonate Seals standard: FKM (for media temperature 00 C) option: FFKM 6 (for media temperature > 00 C) Diaphragm stainless steel. Media wetted parts pressure port, seals, diaphragm 6 for pressure ranges P N 00 bar pressure and level

3 DS 0 P Explosion protection (only for 0 ma / wire) Approval AXDS 0 P IBExU06ATEX00 X zone : II G Ex ia IIC T Gb (connector) / II G Ex ia IIB T Gb (cable) Safety technical maximum values U i = 8 V, I i = 9 ma, P i = 660 mw, C 0 nf, L i 0 µh Max. switching current 0 ma Max. temperatures for environment... 0 C Connecting cables cable capacitance: signal line/shield also signal line/signal line: 00 pf/m (by factory) cable inductance: signal line/shield also signal line/signal line: µh/m the real switching current in the application depends on the power supply unit Miscellaneous Display digit, red segmentled display, digit height mm, range of indication ; accuracy 0. % ± digit; digital damping 0. 0 sec (programmable); measured value update sec (programmable) Current consumption wire signal output current: max. ma (without contacts) wire signal output current: approx. ma + signal current wire signal output voltage: approx. ma Ingress protection IP 6 Installation position any (standard calibration in a vertical position with the pressure port connection down) Weight min. 00 g (depending on mechanical connection) Operational life > 00 x 0 6 cycles CEconformity EMC Directive: 0/0/EU Pressure Equipment Directive: 0/68/EU (module A) 8 ATEX Directive 0//EU 8 This directive is only valid for devices with maximum permissible overpressure > 00 bar. Wiring diagrams wiresystem (current) wiresystem (current/voltage) p supply + p supply + V S I supply contact contact A V S I/U supply signal + contact contact contact contact A/V Pin configuration Electrical connection Supply + Supply Signal + (only for wire) Contact Contact Contact Contact Shield Mx plastic via pressure port Electrical connections (dimensions in mm) Mx metal plug housing/ pressure port Mx plastic (8pin) 6 via pressure port ISO 00 ground contact Binder series plug housing/ pressure port cable colours (IEC 60) wh (white) bn (brown) gn (green) gy (grey) pk (pink) bu (blue) rd (red) gnye (greenyellow) cable outlet PVC Ø =.9mm cable outlet PUR Ø =.mm Mx Mx (8pin) ISO 00 Binder series cable outlet 9 9 different cable types and lengths available, permissible temperature depends on kind of cable; standard: m PVC cable (without ventilation tube, permissible temperature:... 0 C)

4 Mechanical connection (dimensions in mm) metric threads and other versions on request 0 for pressure ranges P N 60 bar G/" flush G/" flush G" flush G" flush cooling element with radial oring 00 C 0 06 BD SENSORS GmbH The specifications given in this document represent the state of engineering at the time of publishing. We reserve the right to make modifications to the specifications and materials. DS0P_E_086 pressure Telefon and +9 level (0) 9 / Telefax +9 (0) 9 / 98 info@bdsensors.de

5 Ordering code Pressure gauge absolute Input [bar] Analogue output without 0 ma / wire 0 0 V / wire 0 ma / wire, adjustable Intrinsic safety 0 ma / wire 0 E Contact, contact contacts, contacts Accuracy 0. % Electrical connection Male plug Mx / plastic version N 0 Male plug Mx (8pin) / plastic version M 0 Male plug Mx / metal version N Male and female plug ISO 00 Male plug Binder series Cable outlet incl. cable T A Mechanical connection G/" DIN 8 with Z 0 0 G/" DIN 8 with Z 0 G" DIN 8 with Z G /" DIN 8 with rad. oring and Z Diaphragm Stainless steel. (6L) 9 Seals FKM FFKM Filling Fluids Silicone oil food compatible oil Special version standard 6 with cooling element up to 00 C with Ex version max. contact is possible with connector ISO 00 and output wire version only max. contact possible; with wire version no contact possible contacts and Mx, 8pin only possible in combination and together with... 0 ma/wire; V/wire on request standard: m PVC cable without ventilation tube (permissible temperature: 0 C), possible for nominal pressure ranges P N 00 bar 6 cooling element up to 00 C not possible for pressure range P N > 60 bar BD SENSORS GmbH The specifications given in this document represent the state of engineering at the time of publishing. We reserve the right to make modifications to the specifications and materials.