Complete Lighting Control

Transcription

1 Complete Lighting Control simple to install easy to operate very flexible creates the perfect mood

2 Complete Lighting Control Imagine the Scene... a boardroom presentation... an intimate dinner at your favourite restaurant... checking-in at your hotel s reception desk... an office meeting... All these activities require different lighting levels to create an appropriate mood. Helvar s DIGIDIM range gives you the products to fulfil any lighting control requirement. From a single office to a cruise liner; a living room or a hotel reception; DIGIDIM products are - lighting the way forward. Key Features Dimmers and output units to suit any load type. Flexible design with DIN rail mounted modules. No special cables required. Cost effective with easy installation. Control panels available in a wide range of finishes. Choice of push button, rotary or slider controls. Infrared receiver on all control panels. Control panels fit into a standard UK and most European backboxes. Customised control panels and finishes available to order. UK designed & manufactured. All dimmers are voltage and frequency output stabilised. Thermal cut-out protection on all dimmers in the event of overheating.

3 Welcome Coop Organisation Building - Stockholm Giorgio Armani store - Milano Studio B bar - Voyager of the Seas, Royal Caribbean Cruises Kämp Hotel Library - Germany

4 Keeping it simple DIGIDIM 4 is a single room solution for up to four lighting circuits, suitable for tungsten, tungsten halogen, wirewound fed low voltage tungsten or neon loads. An idea solution for small restaurants, bars, cafes and even single rooms in modern houses. Additional control panels can be installed in rooms with multiple entry points. Benefits Dimmer, control panel and remote control all supplied in a single boxed solution Control panels available in a choice of modern decorative finishes No special cabling requirements Pre-programmed to function as soon as installed The DIGIDIM4 package contains a four circuit dimmer; a four scene, raise, lower and on/off control panel; and an infrared remote controller. Scene selection is achieved via push buttons on the control panel or from the comfort of your armchair using the handset. The system leaves the factory with default settings to allow instant operation once installation is complete Lancaster Gate Luxury Apartments - London

5 Single Room Dimmable Load Outputs Capable of dimming most common load types including tungsten, mains voltage tungsten halogen and transformer fed low voltage tungsten halogen (provided transformer manufacturer approves use with thyristor, leading edge, dimmers). The Dimmer Unit A compact four channel dimmer suitable for installation in any convenient location. The dimmer is fitted with overheat protection, status indication and an override input. Infrared Handset A small hand held remote control provides the same functionality as the pushbutton panel. Pushbutton Panel Allows simple programming and selection of scenes. Up to five panels maybe connected, ideal for rooms with multiple entry points.

6 Keeping it Simple For multi-room applications the DIGIDIM range offers the ultimate in flexibility. Dimmers, output units, contactors and input units can all be incorporated to suit the customer s requirements. Control can be via pushbutton, sliders or rotary control panels. All control panels can be customised to suit individual requirements or special customer needs. Benefits A totally flexible solution Configured to specific customer needs Cost effective Solution Dimmable Load Outputs Unit can be fitted with modules suitable for all load types including non-dimmable circuits such as curtain controllers. AV Interface Touch screen panels, such as Crestron or AMX, can be interfaced with the lighting system which is particularly useful in either residential or boardroom applications. Fully assembled and tested prior to installation at customers premises Universal Infrared Handset Can be programmed to control lighting circuits in addition to audio and video equipment removing the need for multiple remote controls. Particularly useful in home theatre applications. The Royal National Institute for the Blind Headquaters - London

7 Multiple Room Switched Loads/inputs Automatic gate control Security Alarms AV System Integration Modular Enclosure A cost-effective enclosure for the required modules, circuit breakers and cable terminations. Multi-sensor Useful for presence detection and/or constant light control in situations where energy efficiency is a requirement. Pushbutton Panel A wall mounted control panel supplied in a range of button combinations from two to eight buttons; all panels are fitted with an infrared receiver.

8 Keeping it simple Using modules from the DIGIDIM range a system can be designed to enhance any office environment, increasing personal comfort and productivity. Control panels allow manual selection of pre-programmed scenes for different office tasks. Using a multi-sensor a constant light level can be maintained and when combined with presence detection the office becomes more energy efficient. Benefits Selectable light levels for different tasks Increased energy efficiency Improved personal comfort and productivity Easily reprogrammed to suit changing workplace requirements ITN Television Neworks head office - London Infrared Handset A small hand held remote control provides the same functionality as the pushbutton panel with the added ability of scene modification.

9 Office Multi-sensor Unit Ideal for automatic control of lighting by using the in-built presence and constant light detectors. Multiple sensors can be set in a co-operative mode for use in large open plan offices. Pushbutton Panel A wall mounted control panel supplied in a range of button combinations from two to eight buttons; all units are fitted with an infrared receiver. Digital DALI ballast A high frequency ballast conforming to the DALI standard providing smooth step-less dimming from 1% to 100% with in-built intelligence that communicates light level, lamp and ballast condition to the control system.

10 Keeping it simple For a professional audio-visual installation a DIGIDIM solution can integrate all elements of the system. Lighting, projectors and curtains can all be simultaneously controlled at the touch of a button maximising the overall effect on the audience. Benefits Professional integrated presentations Fire Alarm System Integration Room configuration can be changed at the touch of a button Single or multiple points of control Easy integration of touch screen panels for the ultimate in sophistication Security System Integration Modular Panel Range A modular range of control panels comprising pushbutton, rotary or slider combinations in a range finishes. Thomson Holidays, Head Office boardroom - London

11 Boardroom Dimmable Load Outputs Curtain Control Projection Screen Control DIGIDIM Modules (From left to Right) Input Unit 1kW Dimmer 1kW Dimmer 1-10V/DSI Converter Relay Unit Power Supply AV Interface The AV Interface facilitates full integration of touch screen panels provided by third party manufacturers such as AMX and Crestron. This gives full integration of lighting, sound, vision and other room controls onto one convenient touch screen.

12 Single gang Panels Satin White (200) Brass (201) Stainless Steel (202) Stainless steel + Carbon Fibre (203)

13 Product Gallery Double Gang Panels The double gang panel options contain up to any three control module combinations. They are available as standard in Satin White Plastic or Carbon Fibre + Satin Stainless Steel. The panels are also available to special order in Lacquered Polished Brass or Satin Stainless Steel. Please see the Modular Panel data sheet for further details of the available panel configurations. Single Gang Facia Double Gang Facia 88mm x 88mm 160mm x 88mm Multi-sensor (312) The Multi-sensor module contains the required sensors to provide the energy saving benefits of an automated o o lighting control system; a constant light sensor, passive infra-red presence detector and infra-red remote control receiver. Constant Light Range of Lux Viewing angle 40 or 100 PIR Detector Omni-directional External Diameter 65.00mm Fixing Aperture 52.00mm for mm tile 55.00mm for >2.0mm tile IR Remote Control (303) The remote control is designed to operate basic system functions and to provide simple programming facilities. The remote has the following functions: On/off button Raise (modifier button) Lower (modifier button) Four scene recall/configuration buttons Modular Enclosure Using our in-house project engineering team we have developed a range of DALI Standard Solutions, which enable us to offer a complete packaged solution to all your DALI requirements. This just leaves you to fit the cabinet to the wall and make the necessary control and load connections. This is the fastest way to a fully engineered solution for your project. Note: Standard Metalwork finish - Mild Steel spangled Galvanised, Other finishes available subject to special order.

14 16A Digital Dimmer (416) Single channel thyristor dimmer (leading edge) suitable for tungsten, tungsten halogen, wirewound (inductive) fed low voltage tungsten or neon lighting loads. Supply Voltage Supply Frequency Maximum Load Output Relay Product Dimensions VAC or 58-62Hz 16A Single pole 16A 274mm x 200mm x 72mm 25A Digital Dimmer (425) Single channel thyristor dimmer (leading edge) suitable for tungsten, tungsten halogen, wirewound (inductive) fed low voltage tungsten or neon lighting loads. Supply Voltage Supply Frequency Maximum Load Output Relay Product Dimensions VAC or 58-62Hz 25A Single pole 25A 274mm x 200mm x 72mm 1 kw Universal Dimmer (452) Single channel universal dimmer suitable for any type of load by selecting the appropriate operating mode (leading or trailing edge). Supply Voltage Supply Frequency Maximum Load Product Dimensions VAC 45-65Hz 1000W 90mm x 70mm x 58mm

15 Product Gallery 500W Digital Dimmer (455) Single channel thyristor dimmer (leading edge) suitable for tungsten, wirewound (inductive) fed low voltage or neon lighting loads. Supply Voltage Supply Frequency Maximum Load Product Dimensions VAC 48-62Hz 500W 90mm x 35mm x 58mm DIGIDIM 4 (8040/1/2/3) DIGIDIM 4 consists of a four-circuit 10 Amp dimmer unit, a pushbutton control panel and an infra-remote control in a single package. The pushbutton control panel comes with an optional choice of finishes; satin white plastic, polished brass, brushed stainless steel or brushed stainless steel & carbon fibre. Supply Voltage VAC Supply Frequency 48-62Hz Maximum Load 10A No of Channels 4 SDIM Converter (460) Each DALI-SDIM converter allows up to 16 channels of Ambience TM or Imagine TM dimmers, output units or relay units to be connected to a DALI system.this gives dimming capacities of up to 40A per channel. Supply Voltage VAC Supply Frequency 48-62Hz DALI power supply 250mA maximum SDIM channels 1-16 Product Dimensions 90mm x 70mm x 58mm 1-10V/DSI Converter (472) DALI to 1-10V and DSI Converter suitable for controlling electronic ballasts thus enabling a DIGIDIM system to operate and to integrate into analogue or DSI systems. Supply Voltage Supply Frequency Output Relay Rating Product Dimensions VAC 48-62Hz Single pole 10A resistive load (maximum 15 HFC ballasts) 90mm x 70mm x 58mm 15

16 Relay Unit (494) Provides 4 independent single pole, volt free contacts for switching external devices from a DIGIDIM system. No of Output Channels Supply Voltage Supply Frequency Output Relay Rating Product Dimensions 4 single pole, normally open VAC (absolute) 48-62Hz 16A resistive 10A inductive 90mm x 88mm x 58mm R LONWORKS Gateway (430) Allows DIGIDIM products to be controlled and monitored by a LonWorks BMS. DALI power LON power Cable length Product Dimensions supplied via DALI (2mA max) supplied via the LON bus (1 LPUL maximum) 300m (maximum) 90mm x 35mm x 58mm Input Unit (440) Allows the connection of customer specified switches (latching or momentary), time clocks or other on/off control devices to be incorporated into a DALI system. No of input channels 8 Cable length 50m (max) Product Dimensions 90mm x 71mm x 58mm

17 Product Gallery Mini Input Unit (444) Allows the connection of customer specified switches (latching or momentary), time clocks or other on/off control devices to be incorporated into a DALI system. No of Input Channels 4 Cable Length 200 mm Product Dimensions 30mm x 20mm x 10mm Note: Cable length must not be increased. 250 ma DALI Power Supply (402) A DIN rail mounted power supply for DALI control systems. Supply Voltage Supply Frequency DALI Power Supplied Product Dimensions VAC Hz 250mA 90mm x 35mm x 58mm Note: If a power supply unit is connected to a system no other source of power may be used. Power Supply (401) A ceiling mounted power supply for DALI control systems. Supply Voltage Supply Frequency DALI Power Supplied Product Dimensions VAC Hz 250mA (maximum) 100mm x 63mm x 51mm Note: If a power supply unit is connected to a system no other source of power may be used. RS232 AV Interface (503) Allows the connection of RS232 devices such as an AV Touch Screen to a DALI system. The interface modules power requirements are derived from the connecting systems. Isolation (RS232 & DALI) 3 kv Byte Format 19,200 Baud 8 data bits (no parity, 1stop bit) DALI power Supplied via DALI (10 ma) RS232 power Supplied via RS232 (3mA)

18 System Guidelines Up to 63 addresses per system Up to 250mA current per system 10mA / panel 15mA / multi-sensor 2mA required per load interface Up to 300m total cable length 2 2 wire mm standard mains cable Each system maybe configured with up to 16 groups Every load within a Digidim system maybe programmed with up to 16 scene settings Multiple Digidim systems maybe joined together under Building Management System control Cable Specification DALI connections of up to 300m can be made with any 2 wire mm 2 mains rated cable. NOTE: The Digidim panels must be earthed as shown in the installation instructions. (In rare instances where the environment may be electrically noisy, due to adjacent circuits carrying high switching currents, we recommend a 2 wire twisted pair screened

19 Guidelines & System Programming DIGIDIM Toolbox (502) The DIGIDIM Toolbox is a Microsoft Windows based application that provides a simple method of configuring DIGIDIM systems. Graphical User Interface On-line Mode Off-line Mode! Based on the look and feel of Windows Explorer! Devices created with a single click of a button! Configure devices by simple drag and drop operations! Directly connected to the DIGIDIM system! Changes effective immediately! Useful for fine tuning of system! Allows simulations of DIGIDIM systems! Using virtual devices system can be configured prior to installation! Design can be simply transferred to real system when built System Configuration! All devices in the system can be given meaningful names! When on-line Toolbox displays a representation of all devices! Toolbox tracks actual system status in real time Infrared Remote Control The DIGIDIM Infrared Remote control is a hand held unit and is fitted with seven buttons that can be used to control basic system functions. The remote control can also be used for programming systems with up to four groups, four scenes and associated fade times.

20 ISO9001:2000 Registered Helvar Merca Limited Hawley Mill Hawley Road Dartford Kent DA2 7SY United Kingdom Tel: +44 (0) Fax: +44 (0) Visit our website: Due to a policy of continuous improvement, Helvar reserve the right to alter specifications without notice at anytime. LIT.133iss2 GB