Enhanced Data Recorder

Transcription

1 Product Summary McLaren Technology Centre Chertsey Road Woking Surrey GU21 4YH UK 2014 Suite 115 Bostick Building 9801 West Kincey Avenue Huntersville NC USA Page 1 of 7

2 The is a compact, self-contained data logger developed specially for on-board racing applications. The unit provides 42 direct inputs, and additional inputs via CAN-linked sensor interface units. The unit comes with 1Gbytes integrated logging memory, GPS and integrated 115.2kbps telemetry option. Additional functionality may be added by the customer using our Graphical Development Environment (GDE) to auto generate applications from Matlab/Simulink control modules. For compatibility with existing units and expansion potential, please refer to the application notes. Application General data logging and control. Electrical Supply Voltage 7.5 to 16.0V DC Supply Voltage not to exceed 17V continuous (the unit is protected against transients and reverse polarity) TAGOS 32-bit Real Time Operating System Internal Data logging memory capacity 1Gbytes Maximum logging data rate 100Kbytes/sec Up to 200 channels can be logged. Maximum sample rate 1KHz per channel GPS with 4Hz update rate (maximum) Mechanical Case material Aluminium, anodised black Weight 550g (605g including telemetry option) Connection Definition Integral, sealed, military standard connectors Other Features One ATLASLite licence supplied with each unit One System Monitor configuration software licence supplied per team 2014 USA: Page 2 of 7

3 Connector Details (A) Sensor Group 32 Analog inputs 5V sensor supply (x2) Analog Ground (x2) (B) Chassis Group 1 Lap Trigger 7 DHE speed 2 K type thermocouples PCU-6 supply 5V general purpose supply Digital Ground (x1) 4 High/Low sides 3 Low sides 1 Ethernet 2 CAN 1 RS232 Power Grounds Ignition switch Unit supply H-Bridge supply QMA Group GPS Antenna (active) SMA Group Telemetry Antenna Environmental Splash resistant to standard motorsport fluids Lids sealed with o-rings and screws sealed with silicone rubber Maximum humidity 95% non-condensing Minimum operating temperature -10 C Internal temperature not to exceed 70 C as measured by internal diagnostic sensors Storage temperature -10 to +85 C Vibration 100 to 1000Hz, all axes, 24hrs Electro-Magnetic Compatibility Complies with the essential protection requirements of EMC Directive 2004/108/EC Telemetry Option Integrated 902 to 928MHz FHSS transceiver Peak data rate 115.2kbps (19.2 to 115.2kbps settings) Maximum 1W output power (programmable) 2014 USA: Page 3 of 7

4 Car antenna O Pit antenna O CBR-400 Modem Receiver (O ) Sensor Inputs Seven DHE Speed Sensors 22 Analog (0 to 5V) Four Pt1000 temperature sensors (programmable as analogs) Three NTC temperature sensors (programmable as analogs) Three switch inputs (programmable as analogs) Two K-type thermocouples Lap Trigger Outputs Two H-Bridges or four High/Low side drivers (programmable) Three Low side drivers External sensor supplies PCU-6 drivers (requires two High/Low-side drives and the three Low-side drivers) Communications One Ethernet (up to 100Mbps) Two CAN 2.0B bus (up to 1Mbps) One RS232 (up to 230kbps) One bi-directional telemetry option (19.2 to 115.2kbps settings) Data Logging 1 Gbyte logging memory Diagnostics Sensor readings are checked for out of range and open circuit The following internal parameters are monitored: Board temperatures Unit supply voltages Bridge/High side currents HS/LS output status GPS system status 2014 USA: Page 4 of 7

5 2014 USA: Page 5 of 7

6 Description Ordercode O USA: Page 6 of 7

7 Description Ordercode T (with telemetry option) O USA: Page 7 of 7