Handsfree Speaker Kit with Bluetooth Wireless Technology. Instruction Manual Model Number: ABHK-014 AUS

Transcription

1 Handsfree Speaker Kit with Bluetooth Wireless Technology Instruction Manual Model Number: ABHK-014 AUS Model: ABHK-014 Product Code: /2015

2 Welcome Congratulations on choosing to buy an ONIX product. All products brought to you by ONIX are manufactured to the highest standards of performance and safety and, as part of our philosophy of customer service and satisfaction, are backed by our comprehensive 1 Year Warranty. We hope you will enjoy using your purchase for many years to come. 2 AUS Model: ABHK-014 Product Code: /2015

3 Contents Welcome 2 General Safety Instructions 4 Product Overview 5 Getting Started 6 Instructions 8 Other Useful Information 10 AUS Model: ABHK-014 Product Code: /2015 3

4 General Safety Instructions Read this manual thoroughly before first use and keep it in a safe place for future reference, along with the completed warranty card, purchase receipt and carton. Charger: Use only the supplied charger to charge this Handsfree Kit with Bluetooth Wireless Technology; using any other charger will be hazardous. Battery: Do not attempt to force open the built-in battery since this could damage the product. Protect from heat: Do not leave this Handsfree Kit exposed to strong direct sunlight, which could warp the plastic housing. Sun visor: Frequent attaching and detaching of the clip that holds the kit in place may leave a marking/indentation on a padded sun visor. Installation: Never place or store the Handsfree Kit above any area in the car where a safety airbag is deployed, as it may cause serious injury if the airbag deploys. Safe driving: While this product allows you the freedom to make phone calls in your car, always ensure to operate the vehicle in a safe manner. Do not become distracted by phone calls while driving, and always be fully aware of all driving conditions. If a phone call is likely to distract your attention, pull over in a safe and legal manner and location. Usage restriction: This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance by a person responsible for their safety. Children: Supervise young children to ensure they do not play with the product. Storage: Be sure to store the Handsfree Kit in a dry place, free from extreme temperatures, humidity and dust. 4 AUS Model: ABHK-014 Product Code: /2015

5 Product Overview Front View Top View 9 7 Bottom View 10 8 (1) Speaker (2) LED indicator (blue and red) (3) Volume increase button [ + ] (4) Volume decrease button [ - ] (5) Multifunction button [ MFB ] (6) Microphone (7) Mute button (8) Charging socket (5 Pin Mini USB) (9) Mini USB cable (10) Car charger (11) Visor clip 11 AUS Model: ABHK-014 Product Code: /2015 5

6 Getting Started Introduction This Handsfree Kit with Bluetooth Wireless Technology gives you the freedom to make phone calls in your car without using your hands. The Handsfree Kit: Is compatible with most Bluetooth enabled mobile phones Can be paired with up to eight Bluetooth enabled devices Features Bluetooth technology for wireless communication Features HD-Voice and DSP technology for crystal-clear, pure sound Is easy to install, with the supplied visor clip, on the sun visor of your car. Is designed with your safety in mind. While it allows you the freedom to make or answer important phone calls in your car, we strongly recommend you keep your phone calls to a minimum and focus your attention to driving and the traffic around you. Charging The Handsfree Kit contains a rechargeable lithium battery, which should be fully charged before first use. Charging via computer: Insert the Mini USB connector of the USB cable into the charging socket on the Handsfree Kit, and the USB connector into the USB port on your computer. Charging in the car: Plug the USB connector into the supplied car charger, then insert the charger into your car's DC connector (cigarette lighter socket). The LED indicator will illuminate red and will remain on during charging. It will turn off when the unit is fully charged; this will take approximately two hours. The Handsfree Kit will need to be recharged when the LED indicator starts flashing red once every three seconds. Continued use of the product may reduce the battery lifespan and standby time, and eventually the system will shut down when the battery has insufficient charge. We recommend charging the Handsfree Kit before the battery power is completely drained to prolong the battery life. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by Hands (IP) Holdings Pty Ltd is under license. Other trademarks and trade names are those of their respective owners. 6 AUS Model: ABHK-014 Product Code: /2015

7 Getting Started (Cont.) LED Indicator Light Mode Ready to be paired LED Indication The red and blue LED flash alternately. Paired The blue LED will blink twice every 5 seconds. Standby (connected to a Bluetooth enabled device) Low voltage standby Charging Charging finished The blue LED flashes once every 3 seconds. The red LED flashes once every 5 seconds. The red LED is constantly on. The blue LED is constantly on. Installation Step 1: Lightly push the supplied visor clip open and slide it from the top down into the two grooves at the back of the Handsfree Kit until it clicks into place. Step 2: Clip the unit to your car's sun visor, making sure the mute button is facing the driver. AUS Model: ABHK-014 Product Code: /2015 7

8 Instructions Powering On/Off Turning on: Turning off: In OFF mode, press and hold the MFB for 1 second until you hear a short beep. The product will then automatically connect with the last mobile phone it connected with. In STANDBY mode (when the product is connected to a mobile phone), press and hold the MFB for 5 seconds until you hear a short beep. The product will then shut down. NOTE: After being disconnected from a mobile phone, the product will shut down automatically after 10 minutes. Pairing and Connecting a Mobile Device Prior to using the product for the first time, the Handsfree Kit must be paired and connected manually with a Bluetooth enabled mobile phone. To do so, proceed as follows: In OFF mode, press and hold the MFB for 5-6 seconds until the blue and red LED indicator flashes alternately. This indicates that the Handsfree Kit is ready for pairing. With your mobile phone turned ON, activate the Bluetooth function and search Bluetooth enabled devices (for more instructions, consult your phone's user guide). When your phone has found the Handsfree Kit, it will stop searching. Select "ABHK-014" on the phone's list of found devices. If a password is required, enter "0000" to confirm pairing. If pairing cannot be completed within ten minutes, the Handsfree Kit will automatically power off. In that case, repeat the steps above to attempt pairing again. After successful connection to the host (Handsfree Kit), you can now answer or make phone calls, or play music, from your mobile device via the Handsfree Kit. When using the Handsfree Kit, ensure the distance between the kit and the phone is within 10 metres and there are no obstacles between the two devices. If the Handsfree Kit had paired with your phone but disconnected, the kit will connect the paired phone automatically next time you turn it on again within operation range. 8 AUS Model: ABHK-014 Product Code: /2015

9 Instructions (Cont.) Making Phone Calls To answer an incoming call To end a call To reject an incoming call To dial the last dialled number To adjust the volume Press the MFB once. (If the Handsfree Kit is in OFF mode, it will power on automatically, connect to the paired device and answer the call.) Press the MFB once. Press and hold the MFB for one second. Press the MFB twice in quick succession. While talking, press and hold the [ + ] or [ - ] buttons to increase or decrease the volume. Playing MP3 Music Files When you are playing music from your mobile device, you can operate playback controls via the Handsfree Kit. In STANDBY mode: Press the MFB twice to start music play. While music is playing: Press the MFB to pause playback. Press and hold the [ + ] or [ - ] button to go to the next or previous music track. Press the [ + ] or [ - ] button to adjust the volume. AUS Model: ABHK-014 Product Code: /2015 9

10 Other Useful Information Important Note While the Handsfree Kit complies with the Bluetooth version specified below, compatibility of all functions on every Bluetooth enabled device cannot be guaranteed. Please check your device's user manual for compatibility and functionality. Technical Specifications Bluetooth specification Operating frequency Output power Protocols supported Standby time Talk time Charging time Charging voltage Battery V2.1+A2DP 2.4GHz~2.48GHz Class 2, 10 metres HSP and HFP, A2DP Up to 800 hours Up to 8 hours 2-3 hours (approximately) DC 5.0V, 400 ma 650mAh (BL-5B) Responsible disposal At the end of its working life, do not throw this appliance out with your household rubbish. Electrical and electronic products contain substances that can have a detrimental effect on the environment and human health if disposed of inappropriately. Observe any local regulations regarding the disposal of electrical consumer goods and dispose of it appropriately for recycling. Contact your local authorities for advice on recycling facilities in your area. 10 AUS Model: ABHK-014 Product Code: /2015

11 AUS Model: ABHK-014 Product Code: /

12 Warranty returns Should you for any reason need to return this product for a warranty claim, make sure to include all accessories with the product. Product does not work? If you encounter problems with this product, or if it fails to perform to your expectations, make sure to contact our After Sales Support Centre on before returning it to the store for a refund. AUS Model: ABHK-014 Product Code: /2015