Photodetector unit with built-in power supply and amplifier

Transcription

1 Photodetector unit M-100 series Photodetector unit with built-in power supply and amplifier Photodetector unit M-100 series is an optical measuring instrument that uses the light detecting element of high sensitivity and builds a power supply and a special amplifier into. ) An optical incident type is personally a standard. C mount lens, FC or the SMA connector can be installed in the option. It is possible to use it by connecting it with the microscope and the optical fiber. Accessory There are various options. Diameter 20mm C mount lens Optical fiber connection. Spectral sensitivity and gain characteristics can be selected. AC adaptor BNC cable Feature: -The element with high sensitivity in visible light and near infrared rays is built into. *The temperature correction circuit is built into for the APD element. -Stability is operated for the temperature change. The high pressure is built into. -AC adaptor: Standard attachment. *AC85-240V input. Products: - Space light input type - C mount lens input type Connection of space light and microscope, telescope, and optical system - FC connector input type / SMA connector input type - With built-in high-speed amplifier. - It is addition in module bottom M6 screw hole. - It is possible to set it up in the optical bench.

2 Introduction of wavy observation Data Analyzer" For DC-10MHz: The direct detection is possible by the unit of optical power. The observation of the frequency spectrum is also possible. USB connection Usage example on optical bench Data analyzer (optional) PC Products In the incidence of light, the direct input type is a standard. Additionally, three kinds can be selected. Please specify it when you order. 1. C mount lens input type Parallel light connects the focus with the photoelectron surface of detector. The light that enters diagonally might not enter into the light detecting element. Please confirm use conditions. Image Lens Illuminant Incident light Photodetector module (light detecting element)

3 2. Optical fiber input type (FC input type and SMA input type) When the optical fiber cable is used, the optical measurement system with a high flexibility is obtained. Source of luminescence under very bad environment Optical fiber Detector Source of luminescence The light that entered in the angle of incidence degree of the optical fiber is detected. Advantage that uses optical fiber. It is possible to set it up by separating the source of luminescence and the detector. Even if it is poor surroundings (high temperature, high pressure, and electromagnetic trouble, etc.), the stability operation is done. When you use the optical fiber as a guide of light. The large core fiber of the step index type (about um) is chiefly used. FC connector input type SMA connector input type

4 The list of basic unit Spectrum Spectrum response Model Bandwidth Bandwidth response A B C D E F M100-APD- -1 A,C,E DC-250MHz 7.6x x x x M100-PD - -1 B DC-250MHz Φ0.2 Φ0.4 Φ0.5 Φ0.2 M100-APD- -2 A,C,D,E,X DC-100MHz 3.1x x x x x x M100-PD - -2 B,F DC-100MHz M100-APD- -3 A,C,D,E,X DC-10MHz 1.5x x x x x x M100-PD - -3 B,F DC-10MHz M100-APD- -4 A,C,D,E,X DC-0.5MHz 4.7x x x x x x M100-PD - -4 B,F DC-0.5MHz M100-APD- -5 A,C,D,E,X DC-0.2MHz 1.1x x x x x x M100-PD - -5 B,F DC-0.2MHz Spectrum response Explanatory notes 7.6x10 2 Φ0.2 Peak sensitivity (V/W) Diameter of detection element (mm) 100 A B C D E F sensitivity(%) Wavelength(nm) Ultraviolet rays Visible light Near Infrared rays Order number Please specify the following point when you order. Series name, light detecting element, spectral response, bandwidth, and method of optical incidence etc. Specification example M100 - APD - A FC Series name Detecting element APD: Avalanche photodiode PD: Photodiode Spectral response A: nm B: nm C: nm D: nm E: nm F: nm Band width 1 :DC-250MHz 2 :DC-100MHz 3 :DC-10MHz 4 :DC-0.5MHz 5 :DC-0.2MHz Method of optical incidence D: Direct input type CL: C mount lens input type FC: FC connector input type SMA: SMA connector input type

5 Size Direct input type C mount lens input type FC connector input type SMA connector input type Common accessory AC adaptor BNC cable (50Ω type) 2m Notes. This specification might be changed without a previous notice because of the advancement of the improvement and the technology. Last update date : 2013/02/25 SCIENTEX Inc. Sales department (Business hour 9:00~18:00) Shinmiyakoda Kita-ku Hamamatsu-city Shizuoka-pref Japan URL info@scientex.co.jp