CPC1510GSTR. Single-Pole, Normally Open Relay with Integrated Current Limit INTEGRATED CIRCUITS DIVISION. Description

Transcription

1 CPC Single-Pole, Normally Open Relay with Integrated Current Limit Parameter Rating Units Blocking Voltage 2 V P Load Current 2 ma rms / ma DC On-Resistance (max Features Integrated Active Current-Limit Protection Thermal Shutdown Linear AC or DC Operation Low Power Consumption Clean, Bounce-free Switching High Surge Capability Low Power Drive Requirements Surface Mount version available Tape & Reel packaging available Applications General Telecom Switching Hook Switch Ringing Relay Dial Pulsing Ground Start Ground Fault Protection Instrumentation Automatic Tuning/Balancing Flying Capacitor Analog Multiplex Peripherals Automatic Tuning/Balancing Transducer Driver Security Medical Equipment Pin Configuration + Control 6 Load 2 Control Do Not Use 3 Do Not Use 4 Load Description The CPC is a single-pole, normally open (-Form-A Solid State Relay with an integrated current limit feature that can replace electromechanical relays while enhancing the robustness of wireline-interface applications. The relay is constructed using a GaAIAs LED for actuation control and an integrated monolithic die for the switch output. The die, fabricated in a high-voltage dielectrically isolated technology, comprises a photodiode array, switch control with active current limiting circuitry, and MOSFET switches. The active current limit circuitry in the CPC also provides a thermal shutdown feature offering excellent power cross immunity for improved survivability in harsh environments. These enhancements greatly improve the robustness of end systems using this device compared to systems using relays without the integrated current limit. In addition, the active current limit circuitry enables the CPC to pass FCC and other regulatory voltage surge requirements when adequate overvoltage protection is provided. The CPC relay may be used in both unidirectional DC applications as well as bi-directional AC applications. Approvals UL Approved Component: File # E7627 CSA Certified Component: Certificate # 727 EN/IEC 69- Certified Component: Certificate B Ordering Information Part # CPCG CPCGS CPCGSTR Description 6-Pin.2" Wide, Through Hole (/Tube 6-Pin.2" Wide, Surface Mount (/Tube 6-Pin.2" Wide, Surface Mount (/Reel DC Only Configuration + Control 6 2 Control 3 Do Not Use 4 + Load Load Switching Characteristics of Normally Open Devices Form-A 9% Pb e3 I LOAD % DS-CPC-R3 t on t off

2 CPC Absolute Maximum 2ºC Parameter Ratings Units Blocking Voltage 2 V P Reverse Input Voltage V Input LED Current Continuous ma Peak (ms A Input Control Current ma Input Power Dissipation mw Total Power Dissipation 2 8 mw Absolute Maximum Ratings are stress ratings. Stresses in excess of these ratings can cause permanent damage to the device. Functional operation of the device at conditions beyond those indicated in the operational sections of this data sheet is not implied. Isolation Voltage, Input to Output 37 V rms Operational Temperature -4 to +8 C Storage Temperature -4 to +2 C Derate Linearly.33 mw/ºc 2 Derate Linearly.67 mw/ºc Recommended Operating Conditions Parameter Symbol Configuration Min Nominal Max Units Load Current, Continuous AC/DC ma I rms / ma DC L DC-Only ma DC Input Control Current - 3 ma Operating Temperature Range T A ºC Electrical 2ºC Parameter Conditions Symbol Min Typ Max Units Output Characteristics Current Limit =ma, V L =±V, I DC Configuration t=ms LMT ma P On-Resistance 6 =ma, I L =ma R DC Configuration ON Off-State Leakage Current V L =2V I LEAK -.2 µa Switching Speeds Turn-On t =ma, I L =ma on.3 - Turn-Off t off.6 2 ms Output Capacitance =ma, V L =.V, f=mhz 2 Input Characteristics =ma, V L =V, f=mhz C O - - pf Input Control Current to Activate I L =ma ma Input Control Current to Deactivate I L =ma ma LED Forward Voltage =ma V F V Common Characteristics Input to Output Capacitance - C I/O pf R

3 CPC PERFORMANCE DATA* 3 Typical LED Forward Voltage Drop (N=, =ma =2ºC 2 Typical Turn-On Time (N=, =ma, I L =ma DC =2ºC 2 Typical Turn-Off Time (N=, =ma, I L =ma DC =2ºC Device Count (N Device Count (N 2 Device Count (N LED Forward Voltage Drop (V Turn-On (ms Turn-Off (ms 2 Typical for Switch Operation (N=, I L =ma DC =2ºC 2 Typical for Switch Dropout (N= =2ºC 3 Typical On-Resistance Distribution (N=, =ma, I L =ma DC =2ºC Device Count (N 2 Device Count (N 2 Device Count (N LED Current (ma LED Current (ma On-Resistance (.8 Typical LED Forward Voltage Drop.4 Typical Turn-On Time vs. LED Forward Current =ma DC.2 Typical Turn-Off Time vs. LED Forward Current =ma DC LED Forward Voltage Drop (V =ma =ma =ma Turn-On (ms Turn-Off (ms Forward Current (ma LED Forward Current (ma Load Current (ma Maximum Load Current DC Configuration =ma =ma =ma =ma Turn-On (ms Typical Turn-On =ma DC =ma =ma Turn-Off (ms Typical Turn-Off ( =ma, I L =ma DC *The Performance Data shown in the graphs above is typical of device performance. For guaranteed parameters not indicated in the written specifications, please contact our application department. R3 3

4 CPC PERFORMANCE DATA* On-Resistance ( 2 2 On-Resistance =ma DC =ma =ma LED Current (ma Typical for Switch Operation =ma DC LED Current (ma Typical for Switch Dropout =ma DC On-Resistance ( On-Resistance DC-Only Configuration =ma DC =ma =ma Load Current (ma - - Typical Load Current vs. Load Voltage (T A =2ºC, =ma Load Voltage (V Leakage ( A Typical Leakage (Measured Across Pins 4& Current Limit (ma P Typical Current Limit ( =ma DC Configuration Load Current (A Energy Rating Curve ( =ma μs μs ms ms ms s s s Time *The Performance Data shown in the graphs above is typical of device performance. For guaranteed parameters not indicated in the written specifications, please contact our application department. R3 4

5 CPC Manufacturing Information Moisture Sensitivity All plastic encapsulated semiconductor packages are susceptible to moisture ingression. IXYS Integrated Circuits Division classified all of its plastic encapsulated devices for moisture sensitivity according to the latest version of the joint industry standard, IPC/JEDEC J-STD-2, in force at the time of product evaluation. We test all of our products to the maximum conditions set forth in the standard, and guarantee proper operation of our devices when handled according to the limitations and information in that standard as well as to any limitations set forth in the information or standards referenced below. Failure to adhere to the warnings or limitations as established by the listed specifications could result in reduced product performance, reduction of operable life, and/or reduction of overall reliability. This product carries a Moisture Sensitivity Level (MSL rating as shown below, and should be handled according to the requirements of the latest version of the joint industry standard IPC/JEDEC J-STD-33. Device Moisture Sensitivity Level (MSL Rating CPCG / CPCGS MSL ESD Sensitivity This product is ESD Sensitive, and should be handled according to the industry standard JESD-62. Reflow Profile This product has a maximum body temperature and time rating as shown below. All other guidelines of J-STD-2 must be observed. Device CPCG / CPCGS Maximum Temperature x Time 2ºC for 3 seconds Board Wash IXYS Integrated Circuits Division recommends the use of no-clean flux formulations. However, board washing to remove flux residue is acceptable. Since IXYS Integrated Circuits Division employs the use of silicone coating as an optical waveguide in many of its optically isolated products, the use of a short drying bake could be necessary if a wash is used after solder reflow processes. Chlorine- or Fluorine-based solvents or fluxes should not be used. Cleaning methods that employ ultrasonic energy should not be used. Pb e3 R3

6 CPC CPCG Mechanical Dimensions ±.38 (.33 ±. 2.4 ±.27 (. ±. Pin.6 ±.24 (.6 ±. 6.3 ±.27 (.2 ± ±.24 (.3 ± TYP (.28 TYP 9.44 ±.8 (.36 ±.2.24 ±.27 (. ± DIA. (6 -.3 DIA. 6.3 ±.27 (.2 ±. PCB Hole Pattern 2.4 ±.27 (. ±..8 ±.27 (.2 ± ±.27 (.3 ± ±. (.3 ±.2.47 ±.76 (.8 ± TYP (.6 TYP Dimensions mm (inches CPCGS ±.38 (.33 ±. 2.4 ±.27 (. ±..63 ±.27 (.2 ±. PCB Land Pattern 2.4 ( ±.8 (.37 ±.2 Pin 3.32 ±. (.3 ±.2.47 ±.76 (.8 ±.3.6 ±.24 (.6 ±. 6.3 ±.27 (.2 ± ±.24 (.3 ±..24 ±.27 (. ±..6 ( ( ( ±.24 (.7 ±..6 ±.24 (.6 ±. Dimensions mm (inches R3 6

7 CPC CPCGSTR Tape & Reel 33.2 Dia (3. Dia Top Cover Tape Thickness.2 Max (.4 Max W=6. (.63 B =. (.398 Embossed Carrier Embossment K = 4.9 (.9 K = 3.8 (. P = 2. (.472 User Direction of Feed A =. (.398 Dimensions mm (inches NOTES:. All dimensions carry tolerances of EIA Standard The tape complies with all Notes for constant dimensions listed on page of EIA-48-2 For additional information please visit our website at: IXYS Integrated Circuits Division makes no representations or warranties with respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any time without notice. Neither circuit patent licenses nor indemnity are expressed or implied. Except as set forth in IXYS Integrated Circuits Division s Standard Terms and Conditions of Sale, IXYS Integrated Circuits Division assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right. The products described in this document are not designed, intended, authorized or warranted for use as components in systems intended for surgical implant into the body, or in other applications intended to support or sustain life, or where malfunction of IXYS Integrated Circuits Division s product may result in direct physical harm, injury, or death to a person or severe property or environmental damage. IXYS Integrated Circuits Division reserves the right to discontinue or make changes to its products at any time without notice. 7 Specification: DS-CPC-R3 Copyright 22, IXYS Integrated Circuits Division OptoMOS is a registered trademark of IXYS Integrated Circuits Division All rights reserved. Printed in USA. 2/6/22