TS8000. DeviceNet Option 8000/DN/00 HA Issue 1

Transcription

1 TS8000 DeviceNet Option 8000/DN/00 HA Issue 1

2 Copyright SSD Drives, Inc All rights strictly reserved. No part of this document may be stored in a retrieval system, or transmitted in any form or by any means to persons not employed by an SSD Drives company without written permission from SSD Drives, Inc. Although every effort has been taken to ensure the accuracy of this document it may be necessary, without notice, to make amendments or correct omissions. SSD Drives cannot accept responsibility for damage, injury, or expenses resulting there from. Companies, names and data used as examples herein are fictitious unless otherwise stated. All trademarks and copyrights are acknowledged as the property of their respective owners.

3 Table Of Contents Table of Contents Product Overview... 3 General Description... 3 Safety Information... 4 Contents Of Package... 4 Specifications... 5 Power Requirements... 5 Communications... 5 Environmental Conditions... 5 Construction... 5 Installation Requirements... 5 Installation Instructions... 7 The Option Card Label... 8 Power Supply Requirements... 8 Communications... 9 Configuring An Option Card... 9 DeviceNet Port Protocols... 9 Shield Connection... 9 DC Voltage Connection... 9 Software / Unit Operations LEDs Troubleshooting The Option Card Version Page i

4

5 Product Overview Product Overview Configured with DSI8000 software. Digitally isolated DeviceNet Port capable of communicating with any DeviceNet master. Powered and configured from TS8000 operator interface terminals. Installation and connection hardware included with card. General Description The TS8000 expansion card slot provides a high-speed parallel architecture that extends the functionality and flexibility of the TS8000 series HMI. This approach allows the TS8000 series to evolve concurrently with the latest advances in communication standards, without sacrificing performance. This high bandwith channel has significantly greater throughput when compared to the traditional (external) serial gateway approach. The 8000/DN/00 option card is easily installed by removing the rear cover of the TS8000 operator interface, attaching the card using three screws and connecting a single cable. Adding this card gives the operator interface a DeviceNet communications port. It is built with digital isolation to protect the operator interface from the DeviceNet network, and vice versa. It provides the ability to communicate to any high speed DeviceNet master device. A connector housing is provided to function as a strain relief for the wires that terminate into the five position connector. The connector is pluggable for easy removal of the TS8000 operator interface from the DeviceNet network, without disturbing communications with other devices on the bus. Page 3

6 Product Overview Safety Information All safety related regulations, local codes and instructions that appear in the manual or on equipment must be observed to ensure personal safety and to prevent damage to either the instrument or equipment connected to it. If equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired. Do not use the controller to directly command motors, valves, or other process actuators not equipped with safeguards. To do so can be potentially harmful to persons or equipment in the event of a fault to the controller. Contents Of Package The option card will come shipped with the following additional equipment: 8000/DN/00 option card with pluggable connector. Bus cable (attached to option card). Hardware mounting packet. Page 4

7 Specifications Specifications The following specifications pertain to the TS8000 series option cards. SSD Drives retains the right to modify specifications at any time, without prior notice. Power Requirements Power is supplied to the option card from the main board of the TS8000 operator interface. Communications DeviceNet Port: Format and baud rates are software programmable up to 500kb. Protocol: DeviceNet slave. Port Isolation: 1000vDC for 1 minute. Environmental Conditions Operating Temperature Range: 0 to 50 deg C. Storage Temperature Range: -20 to 80 deg C. Operating and Storage Humidity: 80% maximum relative humidity (non-condensing) from 0 to 50 deg C. Altitude: Up to 2000 meters. Construction Installation Category I, Pollution Degree 2. Installation Requirements Card must be installed inside the rear cover of a TS8000 series HMI with the hardware provided. Page 5

8

9 Installation Instructions Installation Instructions The following specifications pertain to the TS8000 series option cards. SSD Drives retains the right to modify specifications at any time, without prior notice. Caution Risk Of Electric Shock: The inverter board, attached to the mounting plate, supplies the high voltage necessary to operate the backlight. Touching the inverter board may result in injury. Please exercise caution while working inside of the unit. Caution: The circuit board contains static sensitive components. Before handling the operator interface without the rear cover attached, discharge static charges from your body by touching a grounded bare metal object. Ideally, handle the operator interface at a static controlled, clean workstation. Do not touch the surface areas of the circuit board. Dirt, oil, or other contaminants may adversely affect circuit operation. Each TS8000 option card comes with a cable for communication and three screws for attaching the option card to the inside of the TS8000 s rear cover. To install the option card, remove all power and I/O communication cables from the unit. The TS8000 Getting Started manual (HA471056U001) contains instructions for removing the rear cover. Refer to the Battery And Timekeeping section. Using the three screws provided, connect the option card to the rear cover as shown in Figure 1 below. Page 7

10 Installation Instructions Connect the cable from the option card to CN11 on the main board of the TS8000 as shown in Figure 2. Be sure that both ends of the cable are firmly seated into their appropriate connector housings. Carefully replace the rear cover by reversing the instructions for removing the rear cover. The Option Card Label Place the option card label on the rear cover in the space indicated by the dashed lines and labeled COMMS EXPANSION MODULE. Power Supply Requirements The option card draws all of its power form the main board of the TS8000 HMI. The specifications of the TS8000 account for the power needs of the option card. Page 8

11 Communications Communications The following specifications pertain to the TS8000 series option cards. SSD Drives retains the right to modify specifications at any time, without prior notice. Configuring An Option Card The option card is configured using DSI8000 software. DSI is included in the software CD that comes packaged with each unit, or is also available from SSD Drives. Updates to DSI8000 are posted on the SSD Drives website as they are made available. By configuring the option card using the latest version of DSI8000, you are assured that the unit has the most up-to-date feature set. DSI software can configure the option card through the RS-232 PGM port, USB port, Ethernet Port, or the CompactFlash socket. DeviceNet Port Protocols The option card has one DeviceNet port. Currently, this port may be configured for the DeviceNet slave protocol. Port pin-outs are shown in Figure 3 below. Shield Connection Position 3 of the pluggable connector is provided for optional shield connections. This position is available only to tie shield wires together, or to earth ground. There is no internal connection to earth ground. The SHLD position is not to any internal circuitry of the option card, or the TS8000. DC Voltage Connection Position 5 of the pluggable connector is provided for optional 24vDC connections. This position is available only to tie 24vDC wires together, or to earth ground. The option card neither provides 24vDC power nor uses 24vDC power through this connection. The V+ position is not to any internal circuitry of the option card, or the TS8000. The TS8000 has one RS-422/485 port. This port can be configured to act as either RS- 422 or RS-485, depending upon the user s needs. Page 9

12

13 Software / Unit Operations Software / Unit Operations LEDs The following specifications pertain to the TS8000 series option cards. SSD Drives retains the right to modify specifications at any time, without prior notice. The green RUN LED will illuminate when the option card establishes communications with a DeviceNet master node. The red ERROR LED will illuminate if no communications have been established with other DeviceNet masters. Troubleshooting The Option Card If for any reason you have trouble operating, connecting, or simply have questions concerning your new TS8000 option card, contact SSD Drives technical support. Limited Warranty SSD Drives warrants the goods against defects in design, materials, and workmanship for the period of 12 months from the date of delivery on the terms detailed in SSD Drives Standard Conditions of Sale IA058393C. SSD Drives reserves the right to change the content and product specification without notice. Page 11

14 UK SSD Drives Ltd New Courtwick Lane Littlehampton West Sussex BN17 7RZ Tel: +44 (0) Fax: +44 (0) CANADA SSD Drives Inc 880 Laurentian Drive Burlington Ontario L7N 3V6 Tel: +1 (905) Fax: +1 (905) CHINA SSD Drives Ltd Room 1603, Hua Teng Edifice 302# Jin Song San Qu Chaoyang District, Beijing P.R. China DENMARK SSD Drives AB Enghavevej 11 DK-7100 Vejle Tel: +45 (0) Fax: +45 (0) FRANCE SSD Drives SAS 15 Avenue de Norvège Villebon sur Yvette F Courtaboeuf Cedex Paris Tel: Fax: GERMANY SSD Drives GmbH Von-Humboldt-Strasse Heppenheim Tel: +49 (6252) Fax: +49 (6252) ITALY SSD Drives SPA Via Gran Sasso Lentate Sul Seveso Milano Tel: +39 (0362) Fax: +39 (0362) SWEDEN SSD Drives AB Montörgaten 7, SE Halmstad Tel: +46 (0) Fax: +46 (0) U.S.A. SSD Drives Inc 9225 Forsyth Park Drive Charlotte North Carolina Tel: +1 (704) Fax: +1 (704) /11/04 Local availability and service support also in: ARGENTINA AUSTRALIA AUSTRIA BELGIUM BRAZIL CHILE CHINA COLOMBIA CYPRUS CZECH REPUBLIC EGYPT GREECE HONG KONG HUNGARY ICELAND INDONESIA IRAN IRELAND ISRAEL JAPAN KENYA KOREA LITHUANIA MALAYSIA MOROCCO NETHERLANDS NEW ZEALAND NORWAY PHILIPPINES POLAND PORTUGAL ROMANIA SINGAPORE SOUTH AFRICA SPAIN SWITZERLAND TAIWAN THAILAND TURKEY UNITED ARAB EMIRATES Local Address *HA471056U001* TS8000 DeviceNet Option Card