Mainframe Parts Impulse-12: (Domestic) -1X (Export) Impulse-20: (Domestic) -2X (Export)

Transcription

1 uto Reset Hold Start Stop Timer PCIFIC RESERCH & ENGINEERING Remote Selector VU PPM -4 VU Peak VU PPM -4 VU uto Feed Telco Telco 2 Telco 1 Control Room Headphone Control Room Monitor Peak Studio Studio Monitor Talkback Meter Select Headphone Mainframe Parts Impulse-12: (Domestic) -1X (Export) Impulse-2: (Domestic) -2X (Export) /talkback speaker: 23-2 Grill: : : :. Program-1 Program-2 / 3 METER PNEL Impulse meter panel assy: * Front panel metal only: ack panel metal only: Power Supply: -21 Power Entry Module: C Cord: 3-49 Left shoulder: or argraph/clock/timer assy: 99-1 Clock/Timer Lens: argraph Lexan: (x2) 1-LED Display: 12-9 Cable Tray Kit: x # Right shoulder: or Control Surface assy: x # Telco Mix "Coffee Guard": x # Copystands: x # Palm Rest: x WIRING Flex cable, 18-cond: 19-8 Flex cable, 18-cond: 19-9 Flex cable, 18-cond: 19-6 Flex cable, 6-cond: Timer cable: speaker cable: argraph meter cable: DC power cable: * Complete assembly, with meters, cue speaker, clock/timer and all wiring for either frame size. # -1 is Impulse-12, -2 is Impulse-2 FRME Impulse console assy: x # Lower Chassis assy: x # 4." x 2.2" user panel: (standard) 4." x 6" user panel: (standard) 3" x 6" user panel: " x 6" user panel: Screws, 4-4 x 1/4 hex: washers: 38-1 Manual: 7-42 Service CD-ROM: Connector Kit: (Impulse-12) Connector Kit: 76-9 (Impulse-2) Tool Kit: Shipping crate: (Impulse-12) (Impulse-2) ver. 3-8/1

2 Internal oard Settings Parlex Cables " RLS/Timer, 18 conductor (left end) " Monitor/Meter, 18 conductor (right end) " Dual Channel, 18 conductor " Talkback, 6 conductor pin Motherboard Interconnect PC pin Motherboard Interconnect PC Output PC: x3 connectors (x1): x4 connector: DIP switch: Trimpot, 2k (x7): Trimpot, 1k: uf e-cap (x23): TRIMPOTS (RV1, etc.) RV1- RV4 (Mic 1- Mic 4) nalog Card 99-1 Timer/argraph PC E1 / E2 Header Mic Preamp Card x Digital Cards, ES/EU (-1), Optical (-2) nalog Output Interface Card TRIMPOTS (RV1, etc.) Channel Logic & CR Logic DIP switches (13 places on Impulse-12, 21 places on Impulse-2) Switches shown set to the On position Config Jumpers (Jxx), (2 places on Impulse-12, 24 places on Impulse-2). Refer to text on page 12 for specific information on jumper positions. DS1 DS2 DS3 DS4 DS DS6 DS7 DS8 DS1 DS2 DS3 DS4 RV1 J1 J2 Mono Source Select Jumpers RV2 J6, J64, J63 Talk to CR & HP Output Jumpers Routing Jumper J J33 J33 DS DS J43, J44, J4 J46 J47 J48 J49 J32 J31 J36 J32 J3 RV Left DSP & Center DSP Main DSP 32-pin M Jumper: pin M Jumper: ver. 3-8/1

3 Channel Controls (Use for analog input, for ES or S/PDIF digital inputs or for EIJ optical input) Dual PC: / switch (white): 2-83 Pgm switches (white): 2-83 Offline switch (orange): 2-86 switch (yellow): Fader assembly: Fader knob (white): Mounting screws: lternate Knob Colors lack: Red: Yellow: Green: lue: Gray: Orange: On switch w/buttoncap: * Off switch w/buttoncap: * buttoncap: * buttoncap: * Lamp assy. (lamp & housing): 12-9 are lamp: * no suffix for blank buttoncap, -CU for custom engraving. Two lines per buttoncap, 4 1/2 characters max. per line. ver. 3-8/1

4 Telco Channel Controls Dual Telco PC: uto Feed utofeed switch (red): 2-84 / switch (white): 2-83 Pgm switches (white): 2-83 Offline switch (orange): 2-86 switch (yellow): 2-8 Telco Upgrade kit: Telco FPG: DSP FPG: Extraction Tool: 7-13 Install Doc: Fader assembly: Fader knob (white): Mounting screws: lternate Knob Colors lack: Red: Yellow: Green: lue: Gray: Orange: Telco 2 Telco 1 On switch w/buttoncap: * Off switch w/buttoncap: * buttoncap: * buttoncap: * Lamp assy. (lamp & housing): 12-9 are lamp: * no suffix for blank buttoncap, -CU for custom engraving. Two lines per buttoncap, 4 1/2 characters max. per line. ver. 3-8/1

5 Monitor Controls Monitor/Meter switchboard: Select Switch (white) (x14): 2-83 Control Room Telco Mix Studio Meter Select pot assy: Pot only: knob: cap: Mic w/cable: Mic element only: 23-1 Grill: H/P pot assy: Pot only: 24-1 Knob: Skirt: Cap: Headphone CR Monitor pot assy: Pot only: 24-1 Knob: Skirt: Cap: Control Room Monitor Studio Monitor Studio Monitor pot assy: Pot only: 24-1 Knob: Skirt: Cap: Talkback Headphone H/P jack assy: Jack only: Talkback Switch assy: Switch: 2-86 Lamp assy. (lamp & housing): 12-9 are lamp: ver. 3-8/1

6 Timer & RLS Controls Timer/RLS PC: Switch (white) (x19): 2-83 uto Reset Hold Start Stop Timer Remote Selector Mic Preamp PC s 3 & 4 s 1 &2 Outputs 4, 3, 2, 1 PC: x3 connector (x6): Preamp IC: Op amps: Trimpots: DIP switch: uf e-cap (x12): uf e-cap (x8): 6-12 Mic 4 Mic 3 Mic 2 Mic 1 RV4 RV3 RV2 RV Mic Preamp Card ver. 3-8/1

7 Mic Remote Panel & : Cabinet mount : Turret mount PC: PC Connector: pin Header: 14-2 Header jumper: Installation guide: Connector kit: Documentation: Connector Housing: 1-24 Terminal pins (x1): 1-8 Cabinet Grommet: PRE Panel: Panel: (shown) Switch guard (x2): 8-12 TLK CK Switch w/white engraved button: Switch: 2-86 COUGH Switch w/orange engraved button: Switch: Switch w/red engraved button: Switch: 2-88 Switch w/yellow engraved button: Switch: 2-89 ver. 3-8/1

8 Parts Summary Impulse Replacement Parts PR&E # Description or Use 12-9 On, Off, Talkback lamp & housing On, Off, Talkback lamp only Pot 24-1 CR and Studio Monitor, Headphone Pot 2-83 Pgm and / select switch 2-84 utofeed switch 2-8 switch 2-86 Off/ switch 2-88 Module On switch 2-89 Module Off switch 2-86 Talkback switch 2-87 White button cap Red button cap Yellow button cap & Telco channel faders Connector and Tool Kit Components PR&E # Description or Use Qty Inpulse-12 Connector Kit pin MP housing pin MP housing pin MP housing pin MP housing Receptacle contacts Impulse-2 Connector Kit pin MP housing pin MP housing pin MP housing pin MP housing Receptacle contacts irwave Tool Kit - Lithium battery Crimp Tool Contact Removal Tool Clock Magnet Tool 1 irwave Digital ssemblies & Modules PR&E # Description or Use PR&E # Description or Use 23-1 Electret microphone 23-2 speaker -21 Power Supply switchboard Monitor/Meter Select switchboard Dual Control PC Dual Telco Control PC Clock/Timer bezel " x 6" lank Panel " x 6" lank Panel " x 6" lank Panel " x 4." lank Panel Fader assy Microphone preamp PC Output mplifier PC Remote Selector/Timer nalog Config Card ES Config Card Optical Config Card RLS Selector PC Right DSP Card Left DSP Card Middle DSP Card (Impulse-2 only) 99-1 argraph Meter assy Copy Stand for Impulse Copy Stand for Impulse-2 ver. 3-8/1