Tacit 4G. Hush. Projector Enclosures 20-45K. Fourth eneration. Projector Enclosures

Transcription

1 4G 20-45K 4G Fourth eneration

2 Tempest is the world s leading manufacturer of large format indoor projector enclosures for noise attenuation in presentation suites, digital cinema, live theatre and concert venues any noise-sensitive indoor space. models are projector-specific for projectors over 20,000 ANSI lumens, and have been tested and approved for each of the projectors covered, up to 45,000 ANSI lumens. uses remote fans located in an adjacent space or insulated ceiling void to assure best-in-class noise attenuation, generally better than 25dB. has a lightweight but extremely strong aluminum frame, with threaded (M ) holes at six points for easy installation. offers excellent projector access, with opening front and rear doors, and a projector slide that may be ordered for front or rear access on most models. Standard color: White (RAL 9003). Other colors to order. is equipped with Tempest s patented Digital Enclosure Control, featuring variable fan speed and remote monitoring options. may be configured for projector ceiling mounting (where permitted) or tabletop installation inside the enclosure. Portrait and Ultra-Short-Throw options are available to special order. Why so Quiet? There are several parts to the puzzle: First, enclosures are airtight boxes with excellent seals, which do much of the work. Second, we line enclosures with high performance melamine sound insulation foam rated incidentally to the highest fire safety standards. Third, we put the exhaust fans someplace else. As a rule of thumb, you need to blow through an enclosure about double the amount of air being for Christie Boxer 30K. Tip: You can specify most models to slide front or back handled by the projector itself. That means fans, and fans mean noise. exhaust fans are located at the end of a duct, which may be in an insulated ceiling space, an adjoining room or an outside wall. Exhaust fans may also feed into the building air return, though we do not recommend feeding air to the enclosure inlets from the building air supply. It should be brought in at moderate temperature from a room or ceiling void. This combination achieves excellent attenuation in the audience space, which is our sole aim. Inlet air ideally sourced from adjoining space. If not feasible, lay a flexible padded duct hose in an S configuration over the ceiling tile. remote fan unit optionally feeding into building return air duct Exhaust Duct (by others Inlet Duct (by others) Inlet filter inside Enclosure Ceiling Adjoining Space Audience Space

3 6 Rigging points, top and bottom (M x 40mm stainless steel bolts supplied) Air inlet port with inlet filter (replace from inside) Air exhaust port Landscape Ultra-strong lightweight aluminum frame for Panasonic PT-DZ21K Gas struts for smooth fingertip opening and closing Adjust projector position using projector feet, then clamp firmly in place Heavy duty projector tray slides tray may be mounted for tabletop or ceiling operation, and to slide out front or back Lockable latches front and back assure security and a perfect seal Tempered low-iron optical grade port glass for security and perfect imaging DEC4 TM User Interface, for customized setup and system monitoring. May be monitored remotely with optional comms card Variable Speed remote exhaust fan runs as slowly as possible consistent with keeping the projector at a safe operating temperature

4 Portrait Like all models, each portrait enclosure is customized for the intended projector, so we need to know the projector you re using when you order. Not all projectors may be used in portrait mode check with your projector manufacturer before ordering. Some projectors may be used in portrait mode but only in one orientation either base left or base right (picture here shows a Panasonic PT-DZ21K installed base left. Tilt mechanism allows +/ projector tilt adjustment. The projector is attached by screws to the mounting plate that allow adjustment of tilt and roll using the projector feet before locking down. Ultra Short Throw UST enclosures allow you to paint the whole wall from just above or below. UST enclosures are wider than standard landscape enclosures, to allow for the extreme width of the projection beam without clipping. UST enclosures may be configured to mount above the image (projecting down) or below it (projecting up). The lenses may be fixed but the projector mount allows considerable adjustment of pan, tilt and roll. For the present, these UST enclosures are specially built for your project: Contact the factory and talk to us about your next UST adventure!

5 Variable Speed Fan Control enclosures use powerful AC fans to evacuate the air in the enclosure, once every 1-2 seconds. Since we must design these enclosures for worst-case operation, it follows that they may not need to be run so hard all of the time. With G4, Tempest introduces an innovative variable-speed AC fan control circuit that drives the fan(s) only as hard as needed in any given situation. This means longer fan and filter life, and quietest possible operation. Individual Fan Monitoring G4 enclosures can also tell you how each fan in a whole installation is performing. DEC4 compares calculated and actual fan speed, and is able to alert you if one of the fans in a system needs attention. Combined with Tempest s upcoming remote monitoring service this means you could be receiving an alert on your smartphone one day telling you it s time to check the fan on enclosure two! G4 Fan Control System Monitoring Comms Board Daisy-chain a group of enclosures together with this board one per enclosure. 51.EN Comms Board Use this board to connect one or a group of enclosures connected using to a PC or Tempest System Manager 51.RMS Remote Monitoring Service We do the work for you! We monitor your installation 24/7 and send you alerts if we spot anything out of the ordinary. Coming soon. 51.TSM System Manager The Tempest System Manager monitors any Tempest G4 system, with any number of enclosures. System manager may be connected to a PC for local monitoring, and/or to the internet, for remote monitoring. LAN LAN Local PC Remote PC (Daisy Smartphone Chain) Local PC For more on DEC4 and remote monitoring, download the User Manual from

6 G4 Ordering Guide _ 5 6_. _.. _ example: US.LFV Electrical US 208V, NEMA standard North America IN 230V, CE Standard International Format * L Landscape P Portrait U UST Tray F Front Slide B Back Slide Mount D Feet Down V Feet Up Model Description Dimensions (lwh) Weight Type * G x34x20in 1270x864x508mm 140lb/64kg Panasonic PT-DZ21K family Shipping: 56x40x30in 142x102x76cm 210lb/95kg G x30x24in 1270x762x610mm 160lb/73kg BARCO HDX Shipping: 56x36x34in 142x92x87cm 240lb/109kg G x34x26in 1372x864x660mm 190lb/86kg Christie Roadster S20+/J-Series Shipping: 60x40x36in 152x102x92cm 285lb/130kg G x34x24in 1473x864x610mm 162lb/74kg Christie Boxer Shipping: 64x40x34in 163x102x87cm 243lb/110kg G x36x30in 1372x915x762mm 200lb/91kg BARCO FLM, HDF Shipping: 60x42x40in 152x107x102cm 300lb/136lb G x42x33in 1778x1067x838mm 240lb/109kg Christie Roadie 45K Shipping: 76x48x43in 193x122x109cm 360lb/164kg G x38x36in 1778x965x915mm 245lb/111kg Christie D4K35, CP2220/30 Shipping: 76x44x46in 193x112x117cm 368lb/167kg G x38x36in 1778x965x915mm 245lb/111kg BARCO HDQ (note: HDQ rigging Shipping: 76x44x46in 193x112x117cm 368lb/167kg frame and air diffuser not used) * For projectors not shown here, please contact factory we will accomodate any projector type ** Ballast Enclosure for certain Christie 30-45K projectors includes 6 /2m DC pigtails, so DC cables are not required All Schedule B Export Code: Options 56.UR.xxx Unistrut Rail Kit (Use the 3-digit enclosure model #, eg 55.UR.200 for ) 51.DF DF.13 Replacement Inlet Filter Series Replacement Inlet Filter and up Comms Board Custom Colors All the enclosures in this brochure are shown in our standard warm white semi-gloss finish. Black or any RAL color are available to special order. 51.EN 51.TSM Comms Board Tempest G4 System Manager (coming soon) CAD drawings and user manuals at

7 Configurator Please complete this form and to us at Name Custom Requests: Company Phone type Model Quantity 55. Destination Country Install Date Type Landscape Portrait Ultra Short Throw Slide Front Back Mount Feet Down Feet Up Unistrut Kit Yes, Qty No Comms Yes, Qty No Comms Yes, Qty No Color Standard, Warm White Custom, RAL # Gloss Level % User manuals and CAD drawings at Made in the USA Tempest Lighting, Inc., June, 2016 In the interest of continuous product improvement, specifications are subject to change without notice Tempest Lighting, Inc., Wicks Street, Sun Valley, CA 91352, USA info@tempest.biz t: f: