55 % LIGHTGATEplus Room-oriented light management with daylight-dependent control and presence detection

Transcription

1 Room-oriented light management with daylight-dependent control and presence detection System features LIGHTGATEplus is a high-performance light management system with components for installation both within the luminaires and outside of the luminaires. The system combines automatic presence detection and constant light control for maximum energy savings. Both functions can be deactivated. The nominal value for constant light control, the switch-off delay and operating mode (automatic / semi-automatic) can be set independently of each other. The DALI luminaires connected to an integral control device can be operated in up to four groups. In areas supplied with daylight (e.g. classrooms), separate control with two separate light sensors (individual group control) can be set up. Offset control is also possible. Dimming of luminaires near to the windows is via a different setting (offset) to the group away from the windows. A further two groups can assume the function of supplementary lighting without daylight-dependent control. Simple manual dimming and switching can be via singlebutton operation. Multi-button operation gives further operating possibilities, or a remote control device can be used requiring a receiver (integrated in the LGS-RPL/S sensor unit). The advantages Energy savings via daylight use Additional energy savings via presence detection Intuitive one-button operation (switching, dimming) Multi-button operation with extended functions Operation via remote control device ominal value can be set individually Connection of max. three sensor units Individual control of groups of two Switch-off delay for presence detection can be set (3 min. to 60 min. or deactivated) Fully automatic operation (switching off, switching on again) Semi-automatic operation (only switching off, manual switching on) Simple installation and start-up System luminaires Master luminaires with integral LIGHTGATEplus light management can be integrated into many TRILUX luminaire ranges (luminaire designation: +LGM, with LGC-ES01/L/D control device) on request. They are wired ready for connection. All required electrical connections are available at easily accessible luminaire terminals (mains power, 2 x DALI, up to 4 push-buttons, 1 x RJ10 for external sensors). The connection of additional sensor units (total of 3) is possible for expanding the detection area of the presence detection. These can be in the form of sensor luminaires ( +LGS) or sensor units for recess-mounting or surface-mounting. Connection example with LIGHTGATEplus luminaires Master luminaire ( +LGM) with integral sensor unit (LGS-0PL/M) and control device (LGC-ES01/L/D) luminaire ( +LGS) with integral sensor unit (LGS-0PL/M) Simple switching and dimming via singlebutton operation (zero-voltage) Further operating functions via multi-button operation Control of up to 50 DALI luminaires possible (incl. master luminaire) Connector terminals for 2 DALI groups (single groups or offset control) Up to 4 DALI groups in addressing mode Simple installation with low wiring effort Group 2 luminaire (" +LGS") Group 1 Master luminaire (" +LGM") L

2 System components LGC-ES01/L/D LGS-RPL/S LGM-SM LGR-SC Control device Controller LGC-ES01/L/D For installation in luminaire Control of up to 50 DALI ECGs possible Connector terminals for 2 DALI groups Connector terminals for up to 4 push-buttons (zero-voltage, SELV) RJ10 connection for sensor units Height of housing: 21 mm (Details about push-button functions and system configurations to be found in the operating instructions at units LGS-RPL/S For surface-mounting and recess-mounting (with additional accessories) Integral radio receiver for system remote control LGS-0PL/M (mini-sensor) For installation in luminaire For recess-mounting (with additional accessories) With RJ10 connection cable, 2 m System remote control LGR-SC Radio remote control For the complete operation and convenient programming of all system functions of LIGHTGATEplus control devices, for installation in luminaire LGS-RPL/S requires radio receiver LGS-RPL/S LGS-OPL/M Designation TOC Description LGC-ES01/L/D Controller for installation in luminaire LGR-SC Remote control LGS-RPL/S (light, presence, radio receiver) LGS-0P0/S/T Radio presence detection LGS-0PL/M Mini-sensor (light, presence) LGM-RM Recess-mounting set for sensor LGS-RPL/S LGM-SM Surface-mounting set for sensor LGS-RPL/S LGM-RM/M Recess-mounting set for mini-sensor LGS-OPL/M 0MD Modular two-way distributor for data lines 0MK Modular coupling for data lines 0L Data line 2 m 0L Data line 5 m 0L Data line 10 m 0L Data line 20 m 0L Data line 50 m LGI-DA Interface converter, DALI 1-10 V Further control devices with special push-button functions on request, also available in master luminaires. Further information at

3 L L LIGHTGATEplus Light management for halls with daylight-dependent control and presence detection The LGC-HX01/S/D control device has been designed for optimal access to the system in halls and similar locations (e.g. works halls, sports halls, event halls, foyers) via installation in the sub-distribution. All system settings are via the control device. This enables the connection of up to 64 ballasts in each case for broadcast operation at three DALI connections. Presence detection and constant light control are via LGS-RPL/S sensor units. Both functions can be deactivated. The nominal values for constant light control, the switch-off delay and its operating mode (automatic / semi-automatic) can be set independently of each other. Separate control of the 3 DALI groups with separate light sensors (individual group control) can be implemented. For each area, two supplementary sensor units can be installed for presence detection. If all DALI groups are in standby operation via the DALI interface, deactivation of the mains supply for the connected luminaires is via the integral circuit-breaker, usually with postconnected power contactors. In this way standby losses are minimised. Simple manual dimming and switching of the lighting and the calling up of various nominal control values or lighting scenes can follow with up to 6 installation push-buttons. Up to three control devices can be installed in master/slave switching according to application (e.g. triple-discipline sports hall). This enables switching between separate operation of the control devices (single hall operation) and common operation (total hall operation) for all three controllers. LGC-HX01/S/D Control device Controller LGC-HX01/S/D For installing in the sub-distribution Connector terminals for 3 DALI groups 64 ECGs per DALI interface, broadcast operation Connector terminals for up to 6 push-buttons (zero-voltage, SELV) and control lamp (24 V DC) Connector terminals for 2 function selection switches and control lamp (24 V DC) 3 x RJ10 connections, each for 3 sensor units LGS-RPL/S Integral circuit-breaker (1000 VA), for avoidance of standby losses from controlled DALI ballasts Housing 9 DRA LGS-RPL/S LGM-SM unit LGS-RPL/S For surface-mounting and recess-mounting (with additional accessories) For mounting heights up to 8 m The advantages Energy savings via daylight use Additional energy savings via presence detection Connection of up to 192 luminaires to one control device Operation of up to 576 luminaires via master/slave switching of 3 control devices Up to three regulation ranges per controller Broadcast operation, no addressing Up to three presence sensors per regulation range Two sensitivity levels for presence detection All settings are via the control device PE L 1-3 Gr. 1 Power 4-6 Gr V 0/ Hz t a: C 7-9 Gr. 3 Slave Controller L : max. 1000VA DA1: max. 64 EVG DA2: max. 64 EVG DA3: max. 64 EVG Slave Controller Order no.: Progr. Interface T1 T2 T3 T4 T5 T6 T7 COM1 COM2 L PE DA1 DA1 +UB DA2 DA2 DA3 DA3 S1 S2 G8 H9 COM Gesamt-/Total hall H Einzel-/Single hall COM COM Group 1 Group 2 Group 3 Luminaire with DALI ballast Luminaire with DALI ballast Luminaire with DALI ballast Group 1 Group 2 Group 3 Luminaire with DALI ballast Luminaire with DALI ballast Luminaire with DALI ballast

4 Example of a triple-discipline sports hall with 3 control devices in master/slave operation Hall 3 Hall 2 Hall lx 300 lx 200 lx 500 lx 300 lx 200 lx 500 lx 300 lx 200 lx Active/inactive control Single/ complete Functions Single hall use Room lighting controlled according to daylight 2 independent control groups per hall in broadcast operation each with one light sensor ( 1, 2) Switches off with sufficient daylight Presence detection per hall over the complete space with 3 sensors Automatic switching on for each hall with falling to 200 lx in controlled operation Setting possibilities Push button 1: first set value 200 lx Push button 2: second set value 300 lx Push button 3: third set value 500 lx Switching on again with absence to 200 lx in controlled operation Complete hall use As with single halls, but with: Presence detection over the complete hall with 9 sensors Lighting control of complete hall via the sensors of one control device (master) Setting possibilities Switch S1: changing from regulated operation (set value) to manual operation (fixed dimming value), presence deactivated Push button 1: first set value/dimming value 200 lx Push button 2: second set value/dimming value 300 lx Push button 3: third set value/dimming value 500 lx Energy requirement (according to DI V 18599) Reference value according to EnEV kwh/a Planned lighting system kwh/a Reference value shortfall 42 % Room data Complete room Playing area Connected load 45 m x 27 m x 7 m 40 m x 20 m 10,584 Watt Energy saving via light management 29 % Designation TOC Description LGC-HX01/S/D Hall controller for mounting in the sub-distribution unit LGS-RPL/S (light, presence, radio receiver) LGM-RM Recess-mounting set for sensor LGS-RPL/S LGM-SM Surface-mounting set for sensor LGS-RPL/S 0MD Modular two-way distributor for data lines 0MK Modular coupling for data lines 0L Data line 2 m 0L Data line 5 m 0L Data line 10 m 0L Data line 20 m 0L Data line 50 m 0BS Ball protection basket for sensors LGI-DA/S Interface converter, DALI 1-10 V, for the sub-distribution unit Further information at

5 TRILUX säljs i Sverige genom: PROLJUS AB Kyrkogatan VRIGSTAD info@proljus.se Björn Celén bjorn.celen@proljus.se Johan Celén johan.celen@proljus.se