Starting up the system To start the system, the following equipment are needed:

Transcription

1 FLIR ThermoVision CM This Quick Start guide is intended for first time users who wishes to use the basic functionality of the system. Users who want to modify the ThermoVision CM (TV CM) should start with this document and then refer to other written materials. FLIR ThermoVision CM... 1 Demonstrating the ThermoVision CM... 2 Making sure the connected AX8 has the correct IP address

2 Starting up the system To start the system, the following equipment are needed: 1. The TV CM connected to a 100V -240V AC power supply. 2. At least one FLIR AX8 or FLIR A310 connected to the same network as the TV CM. 3. One monitor, keyboard and mouse. Once the TV CM are connected to power and everything is setup, power it on with the power switch on the rear panel. Login with the credentials admin/flir. This is the credentials for the TV CM computer, not to be confused with the credentials for the TV CM software which is admin/admin (changeable). When a user has logged into the TV CM computer, the TV CM software will start automatically asking for new credentials, which are admin/admin as default. Demonstrating the ThermoVision CM To connect to the ThermoVision CM (TV CM) as a customer would use it we can either treat it as an ordinary computer and connect a monitor, keyboard and mouse to it. Or we can use WideQuick Remote which is a small software that is used to connect to the TV CM with from a remote computer. The WideQuick Remote is basically a client software connecting to the TV CM server. The image below illustrates two different setups. The computer in the image could be your laptop or a few monitors connected to a desktop computer. Connecting via a computer has the advantages that you can connect multiple computers to your TV CM and it mimics an industrial control room. Connecting a VGA cable directly to the TV CM also requires that you bring a monitor with you, and that is not always possible. To connect to the TV CM from a computer, follow the steps below. 1) Install WideQuick Remote and WideQuick Designer on your laptop. This software doesn t require a license. The Designer software is not needed right now but convenient for the future. 2

3 Do not install the WideQuick Runtime program as this requires a license. It is important that you install version 7.02 and not a newer version of any WideQuick software. 2) The TV CM as default has the IP address To connect to it, your computer needs to have an IP address in the same range. So assign the IP address to your laptop. Instructions on changing your computer IP address are below. a. Start the Control panel, go to Network and Sharing Center and then press Change adapter settings. b. Right click your LAN connection and press Properties. c. Enter your computer credentials. d. Select Internet Protocol Version 4 and press Properties. 3

4 e. Assign your computer the settings as seen below. f. Press OK and then Close. Wait at least 10 seconds until the IP settings are stuck. 3) Now your computer is on the same subnet as the TV CM and you have installed all the software you need. To start the program, go to Start menu -> All Programs -> Kentima WideQuick -> WideQuick Remote Startup. 4

5 4) Now you will see the startup screen where you are asked to enter the Start view. Press Connect. Then chose the IP address and the port ) Login with the credentials admin/admin. Now you are in the TV CM software. Click around within the software. Press the Help button if you need any help. Making sure the connected AX8 has the correct IP address The predefined camera settings are two A310 cameras with the IP addresses and and two AX8 cameras with the IP addresses and To get data and video from an AX8, you therefor need to assign your AX8 to one of those IP addresses. To assign an IP address to your AX8, follow the instructions below. 1) Start FLIR IP Config from Start menu -> All Programs -> FLIR Systems -> FLIR IP Config -> FLIR IP Config. 2) Select your camera and then press the Settings button. 5

6 3) Assign the camera IP address to , the subnet to and the gateway to