Mission Planning Systems Quick Start Guide DO NOT overclock the motherboard, as this can damage the unit. Open the following containers:

Transcription

1 Open the following containers: Mouse Keyboard Monitor (Quantity 2) Workstation Mouse with USB cable Keyboard with USB Cable Monitor Box (Quantity two) Workstation Front View Workstation Rear View Page 1

2 Remove Monitor and Monitor base from Carton. Turn Monitor neck 90 degrees and connect the base. DVI Connection on the Monitor. Remove DVI Cable from monitor carton; remove plastic cover from the ends of the DVI cable. Page 2

3 Connect one end of DVI cable into DVI receptacle on monitor. Secure to monitor by tightening thumb screws on both sides of the connector. Remove power cube from monitor box. Connect power cube into receptacle on monitor. Page 3

4 Connect monitor power cord into monitor power cube. Insert the three prong end of the power cord into your power source. Turn on power switch on monitor power cube. After following procedures to connect your monitors to the workstation you will need to turn on the monitor power switch on front of your monitors. (Repeat procedures on second monitor). Page 4

5 Rear view of workstation Drive bay keys for 3 ½ and 2 ½ inch drive bays (Drive bays located on front panel of workstation) Page 5

6 Insert keyboard cable into first USB port Insert mouse cable into second USB port Page 6

7 Insert monitor DVI cable into bottom DVI port on the rear of your workstation. (Remove plastic cover from DVI Cable) Secure to workstation by tightening thumb screws on both sides of the DVI cable. Designated Monitor #2 Insert 2 nd monitor DVI cable into top DVI port. (Remove plastic cover from DVI Cable) Secure to workstation by tightening thumb screws on both sides of the DVI cable. (Designated Monitor #1) Page 7

8 Connect power cord to rear of workstation. Then connect other end to power source (electrical outlet) Toggle power switch to ON position. On front of workstation press power button to initialize system. Page 8

9 REMOVE THE 2 ½ INCH HARD DRIVE GUIDE To remove 2 ½ inch hard drive from drive bay: locate key on rear of workstation. Unlock drive bay door. Open latch then open drive bay door. Remove 2 ½ inch drive. Page 9

10 3 ½ Inch Drive Bay locking procedure The 3 ½ inch drive bay requires being in the lock position (using key) in order for the Hard Drive to operate properly. Unlocked key position (OFF) Locked key position (turned clockwise) (ON) Page 10

11 FRONT PANEL LED Activity light Blu-Ray Writer 3 ½ inch Drive Bay LED Activity light Multimedia card readers USB 2.0 (4 each) esata Port USB 3.0 (2 each) PCMCIA Card Reader (See page 13 for alternate versions) 2 ½ inch hard drive bay On/Off Button (Power LED Light) USB 2.0 (2 Each) Speaker/Headphone - OUT Microphone - IN Page 11

12 REAR PANEL Power Cord receptacle Power Switch Gigabyte GA-P75-D3 (Motherboard Back Panel Connectors) see page 16 Keyboard /Mouse USB Ports Bbbbbbbbbbbbbbbbbbbbbbbb DVI Video OUT (Monitor #1) (Remove plastic cover from end of DVI Cable) HDMI (Remove plastic cover to utilize) VGA Port DVI Video OUT (Monitor #2) (Remove plastic cover from end of DVI Cable) FireWire 800 Port (3 each) USB 2.0 (2 each) Page 12

13 PCMCIA (Version one) PCMCIA / CARDBUS (Version two) Page 13

14 REAR PANEL WITH SCSI CARD (68 PIN) INSTALLED (Optional Item B) Page 14

15 REAR PANEL WITH SCSI CARD (68 PIN) INSTALLED (Optional item B ) (SHOWN WITH CABLE) Page 15

16 Page 16 Mission Planning Systems