Conducted Emissions, FCC Part 15

Size: px

Start display at page:

Download "Conducted Emissions, FCC Part 15"

Dorthy Reed
6 years ago
Views:

1 Page 1 of 9 Temperature: 23 C Humidity: 31% Pressure: 830 mb Input Voltage: Configuration of Unit: Type Frequency (MHz) Test Engineer: Level (dbuv) 120Vac/60Hz Video playback mode Mike Tidquist Transducer (db) Gain / Loss (db) Final (dbuv) Test Point Margin: FCC Class A AV (db) Margin: FCC Class A QP (db) AV Line QP Line AV Line QP Line AV Line QP Line AV Line QP Line AV Line QP Line AV Line QP Line AV Neutral QP Neutral AV Neutral QP Neutral AV Neutral QP Neutral AV Neutral QP Neutral AV Neutral QP Neutral AV Neutral QP Neutral The highest emission measured was at MHz, which was db below the limit.

2 Page 2 of 9 Type refers to the type of measurement performed. The type of measurement made is based on the requirements of the particular standard: PK = Peak Measurement: RBW is 9 khz, VBW is 3 MHz QP = Quasi-Peak Measurement: RBW is 9 khz, VBW is 3 MHz, and QP Detection is ENABLED AV = Video Average Measurement: RBW is 9 khz, VBW is 10 Hz The Final emissions level is attained by taking the Level and adding the Transducer factor and the Gain/Loss factor. (Sample Calculation: 40.2 dbuv db db = 58.1 dbuv. Important Note: This is a sample calculation only for the purpose of demonstration, and does not reflect data in this report.) The TestPoint indicates which AC or DC input power line or which I/O cable the measurement was made on. The Margin is with reference to the emissions limit. A positive number indicates that the emission measurement is below the limit. A negative number indicates that the emission measurement exceeds the limit. The PRESCAN is a peak measurement and is performed with the RBW set to 9 khz, and the VBW set to 3 MHz

3 Page 3 of 9 Figure B1: Conducted Emissions Prescan, Line 1, 0.150MHz to 30MHz, Peak Measurements

4 Page 4 of 9 Figure B2: Conducted Emissions Prescan, Neutral, 0.150MHz to 30MHz, Peak Measurements

5 Page 5 of 9 Figure B3: Conducted Emissions Test Setup Front Side

6 Page 6 of 9 Figure B4: Conducted Emissions Test Setup Right Side

7 Page 7 of 9 Figure B5: Conducted Emissions Test Setup Back Side

8 Page 8 of 9 Figure B6: Conducted Emissions Test Setup Left Side

9 Page 9 of 9 ID Number Test Equipment List Manufacturer Model # Serial # Description Cal Date Cal Due 1017 Pacific Power TMX kva, 50 Hz Power Source NA NA 1195 Solar R-24- BNC 1200 Agilent Technology LISN 04/10/ /10/ A 3107A03807 Transient Limiter, 9 khz to 200 MHz 1211 Solar kHz, 100 db, High Pass Filter 1223 Hewlett Packard 01/21/ /21/ A 3303A01859 Quasi-Peak Adaptor 03/12/ /12/ Com-Power CGC Conducted Comb Generator NA NA 1335 Hewlett Packard 1336 Hewlett Packard 1338 Hewlett Packard 1405 EXTECH Instruments 85662A 2542A10937 Spectrum Analyzer Display 03/12/ /12/ B 2532A02062 Spectrum Analyzer RF Section 03/12/ /12/ A 3506A01551 RF Preselector 03/12/ /12/ N/A Hygro-Thermometer 08/06/ /06/2014

ELEC-TECH INTERNATIONAL CO., LTD

Test Report Number: LCZE17050061 Total Page(s): 21 Applicant Name: ELEC-TECH INTERNATIONAL CO., LTD Applicant Address: Test item: Model / Type Reference: No.1 Jinfeng Road, Tangjiawan Town, Xiangzhou District,