SafeLine GL5. Installation manual. A GSM alternative for all of our lift telephones with built-in power supply and battery backup.

Transcription

1 SafeLine GL5 Installation manual A GSM alternative for all of our lift telephones with built-in power supply and battery backup.

2 SafeLine GL5 Installation manual TECHNICAL DATA Communication: Antenna connector type: Input: Output: Dimensions (HxWxD): GSM-module Siemens MC55i quad-band 850/900/1800/1900 MHz. SMA Power 230 VAC. Current consumption max 200mA. 12VDC Maximum output 120 ma continuously, 500 ma max 10 min. 47 x 144 x 97 mm (without antenna). Unit is delivered with a 2.5 m antenna cable, SMA contact (female) safeline.eu 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law. 2

3 Installation Introduction 4 Components and wiring 4 Menu Service Table of contents Using the SIM card 5 LED indication 6 Increase RX audio level 6 Troubleshooting 7 Interference / poor sound quality SafeLine and all the SafeLine products and accessories are copyrighted by law.

4 Installation INTRODUCTION The GL5 is a line emulator that simulates a standard telephone line, it can be used together with all SafeLine telephones or any other PSTN (Public Switched Telephone Network) telephone. Easy to install and no programming needed, makes it suitable for both temporary and permanent installation. HINT! GL5 can be used with a prepaid cash-card or a standard subscription SIM card. GL5 can supply up to four SafeLine MX2 with emergency power for one hour. COMPONENTS AND WIRING Power LED Status LEDs SIM card holder Push button If the push button on the unit is pressed for 3 sec the GSM fi eld intensity will be displayed for 5 sec. Best fi eld intensity is when all 4 LED s are lit. SMA contact for antenna Telephone line out RJ12 Telephone line out Telephone line out Power 12VDC out Power 0V out Battery terminal Holder for battery 230VAC L 230VAC N 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law. 4

5 Installation USING THE SIM CARD Before you can start using a new SIM card, the card has to be prepared. The SafeLine GL5 can only recognize the PIN code if the code is set to 0000, 1234, 1111 or if it is deactivated. If the PIN code is set to 0000 or if it is deactivated the SIM card can be moved from the SafeLine GL5 to any of SafeLine GSM products. If the code is set to 1234 the SIM card can be moved to another SafeLine GL1/GL2/GL5/GL5 unit if the software version is 3.10 or higher. If the PIN code is set to 1111 the SIM card cannot be moved to any other telephone (SafeLine or otherwise) without the PUK code. PIN code (set to 0000, 1234 or deactivate). 1. Insert the SIM card in an ordinary cellular phone. In the Security settings menu, change the PIN code to If this is not possible, set the PIN code to 1234 or set the PIN code request option to OFF. 2. Verify the PIN code by switching your phone off and on again. 3. Make a call from your phone to verify that the SIM card is active, before you move it to the SafeLine GL5. 4. Also make a call to SafeLine GL5 after insertion to check that it is possible to get a proper connection. NOTE! If you enter the wrong PIN code 3 times, the SIM card will be blocked (requires PUK code to de-block). The GL5 cannot be started and the LED (4) will be red. If PIN code id 1234, make sure the SafeLine GL5 software is V3.10 or higher. You can protect the SIM card against unauthorized use. 1. Insert the SIM card in a cellular phone. 2. In the Security settings menu, change the PIN code to When the SIM card is inserted in the SafeLine GL5, the code will be changed to a random number, thus making it impossible to use the card in another cellular phone unless it is unblocked by means of the PUK code. Insert the SIM card by gently pushing it into the SIM card holder. Please note the bevelled corner of the SIM card. NOTE! Disconnect both main and battery plugs, before inserting or extracting the SIM card SafeLine and all the SafeLine products and accessories are copyrighted by law.

6 Menu LED INDICATION LED 1 LED 2 LED 3 LED 4 Powering the unit Unit is operational SIM-card error* Outgoing call Outgoing call connected 2 times/ second Lit Incoming call 3 times/ second Incoming call connected Lit Call disconnected 2 times/ second Signal strenght <29% - Not enough Lit 30-50% - Minimum Lit Lit 51-75% Lit Lit Lit >75% Lit Lit Lit Lit *No SIM-card, Wrong PIN-code or SIM-card not activated. INCREASE RX AUDIO LEVEL Increase the receiving GSM audio level by clicking the reset button within 8 seconds from the time the GL unit has been powered. For each press you will toggle the audio volume according to the table to the right. Store the set level by restarting the unit. Use this function with caution! The voice switching of the emergency phone will be affected. +75% or +100% should only be used in uniqe installations where it s difficult to get the telephone to switch from the receiving part. +0% +25% +50% +75% +100% 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law. 6

7 Service TROUBLESHOOTING The red LED does not start flashing when unit is connected to supply voltage. Make sure that the supply voltage is: 230 VAC All 4 LED s starts flashing rapidly. Make sure that the SIM card is correctly positioned. Check that the SIM cards PIN-code is deactivated or that the PIN-code is set to 0000 or 1111 (see the section SIM card). Make sure that the SIM card is activated and operational by testing the card in an cellular phone. The call is interrupted directly after being connected. Make sure the battery is properly charged. Check voltage with the battery plug disconnected. Call can not be connected. Error message from telephone operator. To make a call, area code must always be used. INTERFERENCE / POOR SOUND QUALITY. Bear in mind that the wiring between GL5 and the lift telephone/ phone is basically a standard PSTN-line and can therefore not be placed in the lifts travelling cable together with high voltage. *** (Risk of interference)*** Always place the antenna in an upward position and at least 70 cm distance from GL5. Place the antenna where the highest fi eld intensity is obtained according to the table on the unit. When a call is connected try placing the antenna in different places to fi nd where the best receiving/sending position is SafeLine and all the SafeLine products and accessories are copyrighted by law.

8 SafeLine Sweden Antennvägen Tyresö SWEDEN Tel: +46(0) Fax: +46(0) SafeLine Europe Blvd de la Woluwe 42, 1200 Brussels BELGIUM Tel: +32(0) Fax: +32(0) SafeLine-Deutschland Westfalenstraße 22a D Wipperfürth DEUTSCHLAND Tel: +49 (0) SafeLine Elevator Parts UK 3 Evegate Park Barn Smeeth Ashford Kent TN25 6SX United Kingdom Tel: +44(0) Fax: +44 (0) SafeLine Denmark Erhvervsvej Glostrup DENMARK Tel: safeline.eu/support