1.81" (46 mm) 0.24" (6.1 mm) Certifications CSA IEC CSA IEC CSA IEC 500V AC/DC. 500V AC/DC Maximum Current 25 A 30 A 25 A 30 A 15 A 15 A 15 A

Transcription

1 Bulletin Screw Connection Terminal Blocks Isolation Blocks Dimensions are not intended to be used for manufacturing purposes. Note: Height dimension is measured from top of rail to top of terminal block.." ( mm) -JKDTW -JKDQ -H." ( mm)." (. mm) Feed-through terminal block with knife disconnect; connection points, on one side." ( mm)." ( mm)." (. mm) Feed-through terminal block with knife disconnect; connection points on each side." ( mm)." (. mm)." (. mm) Handle-style isolating terminal block Certifications CSA IEC CSA IEC CSA IEC Voltage Rating V V V V V V V Maximum Current A A A A A A A Wire Range (Rated Cross Section) # AWG.... # AWG # AWG mm mm mm Fuse Size (Dummy Fuse Supplied) / x -/ in. Wire Strip Length. in. ( mm). in. ( mm). in. (. mm) Recommended Tightening Torque. lb in (. N m). lb in (. N m). lb in (. N m) Density pcs/ft ( pcs/m) pcs/ft ( pcs/m) pcs/ft ( pcs/m) Housing Temperature Range - + F (- + C) - + F (- + C) - + F (- + C) Short-Circuit Current Rating See page - Terminal Blocks Cat. No. Pkg Qty. Cat. No. Pkg Qty. Cat. No. Pkg Qty. Color: Grey -JKDTW -JKDQ With Test Points Grey -JKDTWTP -JKDQTP Black -H Accessories Cat. No. Pkg Qty. Cat. No. Pkg Qty. Cat. No. Pkg Qty. Mounting Rails: ft Scored A-B Rail -N ft Rigid A-B Rail -N ft Rigid Rise A-B Rail -N Standoff Brackets (use every in.) -N m Symmetrical DIN (Steel) -DR -DR -DR m Symmetrical DIN (Aluminum) -DR -DR -DR m Hi-Rise Sym. DIN (Aluminum) -DR -DR -DR m Angled Hi-Rise Sym. DIN (Steel) -DR -DR -DR End Barrier Grey -EBJTW -EBJQ -N Yellow -EBJTW-Y -EBJQ-Y End Anchors and Retainers: A-B Rail Heavy Duty -N A-B Rail Normal Duty -N Screwless End Retainer -ERL -ERL -ERL DIN Rail - Normal Duty -EAJ -EAJ -EAJ DIN Rail - Heavy Duty -EAHJ -EAHJ -EAHJ Jumpers: Plug-in Center Jumper -pole -CJLJ- -CJLJ- Plug-in Center Jumper -pole -CJLJ- -CJLJ- Plug-in Center Jumper -pole -CJLJ- -CJLJ- Plug-in Center Jumper -pole -CJLJ- -CJLJ- Plug-in Center Jumper -pole -CJLJ- -CJLJ- Uninsulated Side Jumper -Pole -N Side Jumper Insulating Sleeve -SJS Other Accessories: Partition Plate Marking Systems: Snap-in marker cards -MRX (/card) -MRX (/card) -MSX (/card) Snap-in marker cards -MX (/card) -MX (/card) -MSX (/card) Adhesive Labels -ALHFB (/sheet) For use with -N DIN rail only. Publication A-CAA-EN-P -

2 -H... Bulletin Screw Connection Terminal Blocks -WFB Fuse Blocks Dimensions are not intended to be used for manufacturing purposes. Note: Height dimension is measured from top of rail to top of terminal block.." ( mm)." (. mm)." (. mm)." (. mm) Single-circuit fusible terminal block with or without fuse indication. Single-circuit fuse block with or without fuse indication. Certifications CSA IEC CSA IEC H/WFB V V V V Voltage Rating H/WFB V V H/WFB V AC V AC Maximum Current A A A Wire Range (Rated Cross Section) # AWG. mm # AWG. mm Wire Strip Length. in. (. mm). in. ( mm) Recommended Tightening Torque. lb in (. N m).. lb in (.. N m) Density pcs/ft (pcs /m) pcs/ft ( pcs/m) Housing Temperature Range - + F (- + C) - + F (- + C) Indicator Type H/WFB Non-Indicating Non-Indicating H/WFB Red LED Red LED H/WFB Neon Neon Leakage Current H/WFB H/WFB V V H/WFB V V Fuse Size (Not Supplied) / x -/ in. x mm Short-Circuit Current Rating See page - Terminal Blocks Cat. No. Pkg Qty. Cat. No. Pkg Qty. Black No-indication -H -WFB Color: Black w/led -H -WFB Black w/neon -H -WFB Accessories Cat. No. Pkg Qty. Cat. No. Pkg Qty. Mounting Rails: m Symmetrical DIN (Steel) -DR -DR m Symmetrical DIN (Aluminum) -DR -DR m Hi-Rise Sym. DIN (Aluminum) -DR -DR m Angled Hi-Rise Sym. DIN (Steel) -DR -DR ft Scored A-B Rail -N ft Rigid A-B Rail -N ft High Rise A-B Rail -N Standoff Brackets (Use Every in.) -N End Barrier -N Not Required End Anchors and Retainers: Screwless End Retainer -ERL -ERL DIN Rail Normal Duty -EAJ -EAJ DIN Rail Heavy Duty -EAHJ -EAHJ A-B Rail Heavy Duty -N -Pole Side Jumper -N -SJFB- Side Jumper Insulating Sleeve -SJS Other Accessories: Partition Plate -PPSL Marking Systems: -MSX (/card) Snap-In Marker Card For Base Block -MSX (/card) For Handle -MSX (/card) -MSX (/card) -MSX (/card) Adhesive Labels -ALHFB (/sheet) -ALHFB (/card) IEC standards for x mm fuses do not include ratings above. A. Cat. No. -N is uninsulated. Cat. No. -SJFB- is insulated.." (. mm)." ( mm) Publication A-CAA-EN-P -

3 Bulletin IEC Terminal Block Accessories Jumpers Side Jumpers For Use With Two-Level Jumper Pkg Qty. Cat. No. -WM, W -N -H, H, H, H -N -SJS -W, WR -SJ- -JD, JDC, JDF, JDG, JDDF, JDDR, JDSS, JDGP -JD, JDC, JDF, JDG, JDDF, JDDR, JDSS, JDGP -JD, JDC, JDF, JDG, JDDF, JDDR, JDSS, JDGP -JD, JDC, JDF, JDG, JDDF, JDDR, JDSS, JDGP -SJA- -SJA- -SJB- -SJB- -WM, W, WTW -SJ- -JTM -SJA- -W -SJ- -JDFB, JDGFB -SJA- -JDFB, JDGFB -SJA- -JDFB, JDGFB -SJA- -LMP, LMPQ, LMJ, LM, LMQ, LMPE, LMPQE -SJLM- -WMD -SJMD- -WFB, WFB, WFB -SJFB- -WM -SJM- -WTF, WTS, WTFLP, WTSLP, WTFLP, WTFLN, WTSLN -WTF, WTS, WTFLP, WTSLP, WTFLP, WTFLN, WTSLN -SJT--R -SJT--B Note: Side jumpers carry the same current rating as the terminal block used with it Side jumper insulating sleeve only for use with Cat. No. -N Use jumper on single side of terminal block only Uninsulated For Use With -LTF (Connects Two Levels within a -LTF Terminal Block) Pkg Qty. Cat. No. -CJLD - Publication A-CAA-EN-P

4 Bulletin NEMA/EEMAC Terminal Blocks Panel Mount Blocks Dimensions are not intended to be used for manufacturing purposes.. (. mm) Certifications. ( mm). (. mm) High-density -pole panel mount terminal block. Can be interconnected to make - and - pole units.. (. mm). (. mm). (. mm) Standard -pole panel mount block. Screw terminal with wire clamp.. (. mm). (. mm). (. mm) Standard -pole panel mount block. Screw terminal with wire clamp. Voltage Rating V V V Maximum Current (per pole) A A A Wire Range (Rated Cross Section) # # AWG (. mm) # # AWG (. mm) # # AWG (. mm) Wire Strip Length. in. (. mm). in. (. mm). in. (. mm) Recommended Tightening Torque lb in (.. N m) lb in (.. N m) lb in (.. N m) Insulation Temperature Range + F ( + C) + F ( + C) + F ( + C) Terminal Blocks Cat. No. Pkg Qty. Cat. No. Pkg Qty. Cat. No. Pkg Qty. Terminal Block -HC -HJ -HJ Accessories (page -) Cat. No. Pkg Qty. Cat. No. Pkg Qty. Cat. No. Pkg Qty. Jumpers: -Pole Uninsulated -N -N -N -pole Uninsulated -N Insulating Sleeve -SJS Anchor Unit: (required every th block) Not Required Not Required Not Required End Piece Not Required Not Required Not Required #- screw. Measurement between mounting screw centers. Mounting screws are offset. in. (. mm) from centerline. Mounting screws are offset. in. (. mm) from centerline. -HC -HJ -HJ -T -T. (. mm). (. mm) Dimensions are not intended to be used for manufacturing purposes.. (. mm). (. mm). (. mm). (. mm) High temperature -pole panel mount block, wire clamp. Gangable for multi-pole installation. High temperature -pole panel mount block, wire clamp. Gangable for multi-pole installation. Voltage Rating V V Maximum Current (per pole) A A Wire Range (Rated Cross Section) # AWG (. mm) # AWG (. mm) Wire Strip Length. in. (. mm). in. (. mm) Recommended Tightening Torque lb in (.. N m) lb in (.. N m) Insulation Temperature Range + F ( + C) + F ( + C) Terminal Blocks Cat. No. Pkg Qty. Cat. No. Pkg Qty. Terminal Block -T -T Accessories (page -) Cat. No. Pkg Qty. Cat. No. Pkg Qty. Anchor Unit: (required every th block) -A -A End Piece -E -E Preferred availability cat. nos. are bold. Publication A-CAA-EN-P -

5 Bulletin NEMA Terminal Block Accessories End Anchors -EAHJ -N -A, -A -E, -E D C C D. (. mm) A E -N. (. mm). (. mm) -N. (. mm) A = Width B = Height A = Width B = Height Cat. No. A B C D E. (. mm). (. mm). (. mm) -A -E. in. (. mm). in. (. mm). in. (. mm). in. (. mm). in. (. mm). in. (. mm). in. (. mm). in. (. mm). in. (. mm) -A. in. (. mm). in. (. mm). in. (. mm). in. (. mm). in. (. mm) -E. in. (. mm). in. (. mm). in. (. mm). in. (. mm) The -SJS Insulating Sleeve reduces exposure to live parts on the -N and -N. The -SJS used with the -N and -H or - HM provides IEC IPX finger protection. Preferred availability cat. nos. are bold. Publication A-CAA-EN-P -