General Specifications

Size: px

Start display at page:

Download "General Specifications"

Barbara Powers
5 years ago
Views:

1 Ultra-Miniature Slides General Specifications Electrical Capacity (Resistive Load) ower Level (silver): 0V DC Logic Level (gold): 0.VA 8V AC/DC maximum (Applicable Range 0.mA ~ 0mV ~ 8V) Note: Find additional explanation of operating range in Supplement section. Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Contact Timing: Total Travel: Materials & Finishes Actuator: Upper Case: Lower Case: Movable Contactor: Interior Base: Terminals: Environmental Data Operating Temp Range: umidity: Vibration: Shock: CB rocessing Soldering: Cleaning: Standards & Certifications 0 milliohms maximum for power level; 0 milliohms maximum for logic level 00 megohms 00V DC 00V AC minimum minute minimum 0,000 operations minimum 0,000 operations minimum SSS & SSS Shorting (make-before-break) (.0mm) olyamide Glass fiber reinforced polybutylene terephthalate for -On models; polyacetal for all other models Glass fiber reinforced polyester for -On models; glass fiber reinforced polybutylene terephthalate (thermoplastic) for other models hosphor bronze with silver plating (code ) or phosphor bronze with gold plating (code ) henolic resin (thermoset) Brass with silver plating over copper plating or brass with gold plating C through +0 C (+ F through +0 F) 90 ~ 9% humidity for 9 0 C (0 F) 0 ~ z with peak-to-peak amplitude of.mm traversing the frequency range & returning in minute; right angled directions for hours 0G (90m/s ) acceleration (tested in right angled directions, with shocks in each direction) Wave Soldering: For non-supported through-hole, see rofile B in Supplement section. For supported through-hole, seconds 0 C maximum. Manual Solder: See rofile B in Supplement section. These devices are not process sealed. and clean locally using alcohol based solution. The SS series devices have not been tested for UL recognition and CSA certification. These switches are designed for use in a low-voltage, low-current circuit. When used as intended in a low-voltage, low-current circuit, the results do not produce hazardous energy.

2 Ultra-Miniature Slides Series SS Distinctive Characteristics Top or side actuation permits flexible board design. Compact dimensions and low profile allow high density mounting and close stacking of C boards. Crisp actuation positively indicates circuit status. Double molded thermoset base and thermoplastic housing prevent loosening of terminals due to high soldering temperatures. Award-winning STC mechanism with benefits unavailable in conventional mechanisms: smoother, positive detend actuation, increased contact stability, and unparalleled logic-level reliability. (Additional STC details in Terms and Acronyms in the Supplement section.) Insert molded terminals lock out flux, solvents, and other contaminants. Inch or metric terminal spacing for standard C board grid ( x or.0mm x.0mm). Actual Size

3 Ultra-Miniature Slides ole Model SS oles & Circuits S SDT ON NONE ON SSS model has shorting contacts. * M ST ON ON ON S DDT ON NONE ON SSS model has shorting contacts. See oles & Circuits chart below. * M Circuit with silver contacts only. TYICAL SWITC ORDERING EXAMLE S Silver Contacts Rated 0V DC SDT ON-NONE-ON Circuit Terminals with Spacing Slide osition Connected Terminals Throw & Schematics Right Center Left Right Center Left S SSS ON NONE ON - NONE - SDT S SSM ON ON ON ST D SSS ON NONE ON - - NONE - - DDT D Terminal Spacing B Metric.0mm x.0mm D Inch x DESCRITION FOR TYICAL ORDERING EXAMLE SSSD OLES & CIRCUITS Actuation Contact Material & Ratings Silver Rated 0V DC Gold Rated 0.VA maximum 8V AC/DC maximum * Gold not available with SSM. Note: Terminal numbers are not actually on switch. (COM) (COM) (COM) (COM) ON-OFF-ON circuit can be created by not connecting terminal.

4 Ultra-Miniature Slides Series SS B D Metric.0mm x.0mm with Black Base (.0) Typ.0.7 Inch x with Gray Base (.0) Typ.0 TERMINAL SACING On-None-On Single ole Models On-None-On Double ole Models -On Models (.) Typ.0.7 (.). (0.).0 (0.).0 (.). (.) Typ.0 On-None-On Single ole Models On-None-On Double ole Models -On Models (.).07 (.) (.0) (.0) Typ.0 (.0). (.) Typ.0 (.).7 ACTUATION CONTACT MATERIALS & RATINGS Silver over hosphor Bronze ower Level 0V DC Gold over Silver/hosphor Bronze Logic Level 0.VA 8V AC/DC max (.0) (.) (0.0).9 (0.).0 (.). (.0) Complete explanation of operating range in Supplement section. (.). (.0) Typ.0 (.) Typ.0 (.).7 (.0) Typ.0.7 (.08).00 (.) Typ.0.7 (.) (.).07 (.) (.). (.)..7 (.0) Typ.0 (.08).00 (.) Typ.0 7

5 Ultra-Miniature Slides SSSD SSSD -On Circuit SSMD SSMD (.).07.7 (.).0.7 (.) (.) -On Circuit (.0) Travel (.).07.7 (.).07 TYICAL SWITC DIMENSIONS (.).7 (.).7 (.) (.).7 Single & Double ole (.0) Travel (.) (.0) (.).0 Single & Double ole (.).0 (.0) Travel Typ (.0) Travel (.) (.) Single ole (.0) Travel Typ (.) (.0) Single ole (.).77 (.0).97 (.).8 (.).07 (.).77 (.0).97 (.0).8.0 (.) Typ (.).07 (.).8.0 (.) Typ (.0).8.0 (.08).00 (.) Typ (.0).8.0 (.08).00 (.) Typ (.0).8 (0.).0 (0.).0 (.8). (.8). (0.).0 (.) (0.).0 (.) 8

6 Ultra-Miniature Illuminated Slides Series SS General Specifications Electrical Capacity (Resistive Load) ower Level: 0V DC Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Contact Timing: Total Travel: Materials & Finishes Actuator: Upper Case: Lower Case: Movable Contactor: Interior Base: Terminals: Environmental Data Operating Temp Range: umidity: Vibration: Shock: CB rocessing Soldering: Cleaning: Standards & Certifications 0 milliohms maximum 00 megohms 00V DC 00V AC minimum minute minimum 0,000 operations minimum 0,000 operations minimum Shorting (make-before-break) (.0mm) olyacetal olyacetal Glass fiber reinforced polybutylene terephthalate hosphor bronze with silver plating henolic resin (thermoset) Brass with silver plating over copper plating C through +0 C (+ F through +0 F) 90 ~ 9% humidity for 9 0 C (0 F) 0 ~ z with peak-to-peak amplitude of.mm traversing the frequency range & returning in minute; right angled directions for hours 0G (90m/s ) acceleration (tested in right angled directions, with shocks in each direction) Wave Soldering: For non-supported through-hole, see rofile B in Supplement section. For supported through-hole, seconds 0 C maximum. Manual Soldering: See rofile B in Supplement section. These devices are not process sealed. and clean locally using alcohol based solution. The SS series devices have not been tested for UL recognition and CSA certification. These switches are designed for use in a low-voltage, low-current circuit. When used as intended in a low-voltage, low-current circuit, the results do not produce hazardous energy. 9

Ultra-Miniature Illuminated Slides Distinctive Characteristics Top or side actuation permits flexible board design. Bright, LED illumination at tip of actuator.

7 Ultra-Miniature Illuminated Slides Distinctive Characteristics Top or side actuation permits flexible board design. Bright, LED illumination at tip of actuator. Compact dimensions and low profile allow high density mounting and close stacking of C boards. Crisp actuation positively indicates circuit status. Double molded thermoset base and thermoplastic housing prevent loosening of terminals due to high soldering temperatures. Sliding twin contact mechanism with self-cleaning action provides smooth actuation and produces high contact reliability. Insert molded terminals lock out flux, solvents, and other contaminants. Inch terminal spacing for standard C board grid ( x ). Actual Size 0

Ultra-Miniature Illuminated Slides Series SS ole SS S oles & Circuits S SDT ON NONE ON S DDT ON NONE ON Terminal Spacing D Inch x TYICAL SWITC ORDERING EXAMLE Silver Contacts Rated 0.

8 Ultra-Miniature Illuminated Slides Series SS ole SS S oles & Circuits S SDT ON NONE ON S DDT ON NONE ON Terminal Spacing D Inch x TYICAL SWITC ORDERING EXAMLE Silver Contacts Rated 0V DC Model Contact Material & Ratings Silver Rated 0V DC SDT ON-NONE-ON Circuit Terminals with Spacing Slide osition Connected Terminals Throw & Schematics Right Center Left Right Center Left S SSS ON NONE ON - NONE - SDT D SSS ON NONE ON - - NONE - - DDT D Inch x Single ole Models D Actuation DESCRITION FOR TYICAL ORDERING EXAMLE (.) Typ (.) Typ. (9.0). SSSDLC OLES & CIRCUITS TERMINAL SACING (.) Typ.0 (.0). Red LED L Note: Terminal numbers are not actually on switch. Isolated LED circuit requires external power source. Double ole Models (COM) (COM) (COM) C LED Colors C Red E Yellow F Green LED Circuit L Isolated (.) Typ (.) Typ. (9.0). (+) (-) (+) (-) (.) Typ.0 (.0).

9 Ultra-Miniature Illuminated Slides CONTACT MATERIALS & RATINGS Silver over hosphor Bronze ower Level 0V DC SSSDLC SSSDLC (.7). AT0 Slide Cap (7.).9 Material: olycarbonate Cap can be assembled on request Cap Color: Black only (9.0). (.0) Travel (.) (.) LEDs are supplied as an integral part of the switch (not available separately). The lamp circuit is independent of switch operation. Electrical specifications shown are determined at a basic temperature of C. If the source voltage exceeds the rated voltage, a ballast resistor is required. The resistor value can be calculated by using the formula given in the Supplement. (.0) Travel (.) (.) (.7). (.8).9 TYICAL SWITC DIMENSIONS (7.).9 (.).77.0 (.) Typ (.0).8 (.0).8.0 (.) Typ (.) (.) LED COLORS & SECIFICATIONS (.0).97 (8.). Single & Double ole OTIONAL CA (.).77.0 Single & Double ole (.). (0.).0 (.0).97 (.0)..0 (0.) Typ.0 (.0). (0.) Typ.0 (.0). (.) Typ (0.) Typ.0 (.) Typ (9.0)..0 (.0). (0.) Typ.0.0 (.0). Window color should match LED color. Colors Available: C Red E Yellow F Green (.) (.) Typ.0 (.) (.) Typ (.) Typ (.) Typ (.) Typ (.) Typ Isolated, L (+) (-) C E F -element Color Red Yellow Green Maximum Forward Current I FM 0mA 0mA ma Typical Forward Current I F ma ma ma Forward Voltage V F.98V.0V.V Maximum Reverse Voltage V RM V V V Current Reduction Rate Above C I F 0.0mA/ C 0.mA/ C 0.mA/ C Ambient Temperature Range ~ +0 C

Distinctive Characteristics

Distinctive Characteristics Top or side actuation permits flexible board design. Compact dimensions and low profile allow high density mounting and close stacking of PC boards. Crisp actuation positively