9mm Size Metal Shaft Snap-in Type

Transcription

1 Potentiometer 9mm Size Snap-in Type RK09L Series Single-unit and dual-unit types suit a variety of controls. Typical Specifications Items Total tolerance Maximum operating voltage Total rotational angle Rotational torque life temperature range Specifications ±% V AC, V DC 00± to mn m,000cycles to +70 Product Line Number of resistor elements direction type Length of the shaft (mm) Center detent Total (kω) Resistance taper A B Minimum order unit (pcs.) Products No. RK09AS RK09P Drawing No. Single-unit. A RK09A69 RK0940AE RK0940A66 B RK0940AP RK0940AU RK09400T Flat,000 RK0940A6 Dual-unit for tone for vol. for tone for vol. 0 A B B A RK090M RK09AB RK09B0A RK09B0AZ RK094000Z RK0940A RK09D0AW RK09D0AT 4 Packing Specifications Tray Number of packages(pcs.) case /Japan case export packing,000,000 Export package measurements (mm) Notes. Products other than those listed in above products are also available. Please contact us for details.. Please place purchase orders per minimum order unit N (integer). Refer to P.48 for product varieties. Refer to P.48, 49, 470 for taper. Refer to P.79 for attached parts. 46

2 Potentiometer 9mm Size Snap-in Type RK09L Series Dimensions No. Photo Style PC board mounting hole dimensions (Viewed from mounting side) Single-shaft, single-unit RK holes M shown in Single-shaft, single-unit RK holes Single-shaft, dual-unit RK09(For tone) RK09B0(For vol.) M9 0.7 shown in R M shown in holes 4 Single-shaft, dual-unit RK0940 (For tone) RK09D0 (For vol.) holes R M shown in Dimensions of Bushing and Fixing Lug M9G

3 9mm Size Snap-in Type Potentiometer Product Varieties In addition to the recommended products, the following specifications can also be accommodated. Total Resistance Variety Total (kω) 0 Resistance Taper Resistance taper A B B C Variety Detail dimensions CO.8 60û shown in full CCW position Note marked are specifications recommended by ALPS. Refer to P.470 for taper. Refer to P.79 for attached parts. 48

4 9mm Size Snap-in Type Potentiometer Orders Other Than Recommended Products When ordering product varieties that are not listed in the Product Line, please specify by referring to the below example. Sample Part Number R K 0 9 L 4 0 F C 0 B 0 Model type 4 Model type Single-unit horizontal type Single-unit vertical type Dual-unit horizontal type for tone 4 Dual-unit vertical type for tone B D Dual-unit horizontal type for vol. Dual-unit vertical type for vol. type type F Flat *Only available in flat format. Length of the shaft()(mm) Length of the shaft Length of the shaft Length of the shaft Detent C0 C Center detent Resistance taper A B Resistance taper A B B:For tone & general(model type :,4,,4) V:For vol.(model type :,4,B,D) V C Resistance taper B C J G 0 (%) Output volt.across term.- Input volt. across term B(B) V(vol.control)(B) A(A) G 0 (%) J Output volt.across term.- Input volt. across term C(C) Term."" Rotation travel (%) J Term."" Term."" Rotation travel (%) J Term."" Total Total (kω) Total (kω) 4 0 Note marked are specifications recommended by ALPS. 49

5 List of Varieties Type Number of drive shafts 9mm size metal shaft snap-in Single-shaft 9mm size metal shaft multi-ganged Dual-shaft mm size metal shaft reflow Single-shaft Model RK09 RK097 RK097 RK9 Photo Fixing method of bushing Terminal mounting Attached switch Gang error applicable to Dual-unit parts for audio volume control purposes Solder heat Manual soldering Dip soldering Reflow soldering emperature range to +70 Automotive use Electrical performance Mechanical performance Environmental performance Rated power Residual Maximum attenuation (Volume control) Insulation Voltage proof Stopper strength Push-pull strength Vibration Cold Dry heat Damp heat R kω kω< R<kΩ kω R Bushing screw clamp 40dB to 0dB db max. switch Push-on push-off switch Momentary push switch Bushing guide type Momentary push switch max. s max. ± s ±, ±s kω R< kω kω R< kω kω R<0kΩ 0kΩ R to to +8 (Vehicle-compatible) 70dB min. 80dB min. 90dB min. 0dB min. Please see P to +8 ページ Page Push-on Switch Specifications Attached Parts 79 Cautions 80, 8 Notes 0.0W Ωmax. 0Ωmax. Nominal total of 0.% or less 0MΩ min. V DC 00V AC for minute R kω Ωmax. kω<r kω 80Ωmax. kω<r Nominal total of 0.% or less 0.N m 0.N m ( push-lock mechanism type: 0.4N m) 0.N m 80N max. 0N max. to to Hz/min., the amplitude is.mm for all the frequencies, in the direction of X, Y and Z and for hours respectively ± for 96h 70± for 96h 40±, 90 to 9%RH for 96h 〇〇〇 0± for 96h 40± for 96h(Vehicle-compatible) 70± for 96h 8± for 96h(Vehicle-compatible) Items RK097 RK9 Contact arrangement Travel(mm) force(n) Rating Contact life Single pole and single throw(push on) 40± for 40h 8± for 40h 60±, 90 to 9%RH for 40h ± ± 4± 0.A V DC 0.A V DC (0.mA V DC min.ratings) 0mΩfor initial period;0mωafter operating life,000 cycles min.,000 cycles min.,000 cycles min. 0,000 cycles min. ( life without Load).. For the switch attached, the single-shaft or inner shaft of the dual-shaft type can be chosen.. The operating temperature range for automotive applications can be raised upon request. Please contact us for details.. 〇 marks in "Available for automotive use" indicate that some of the series products can work at the operating temperature range from -40 to

6 Attached Parts The following parts are included with the product. Applicable products Bearing screw diameter Hexagonal nut Flat washer ø4 0. ø9. RK09L RK68 RK097 RK M9 M9G0.7 ø4 ø8. 0. RK7 M8 M8G0.7 ø 0. ø7. RK097 RK6 M7 M7G0.7 8 ø 0. ø6. RK097 M6 M6G0.7 79